Search

Biological cells are utilized for diverse biotechnological and bioengineering purposes ranging from the production of biopharmaceuticals, to cell therapy, "human-on-a-chip" drug and toxicology assays, and drug-resistance tests. In these and other applications, it is critical to quantify the levels of not only viable but also non-viable cells. While traditional off-line cell-staining methods are available for counting of non-viable cells, many applications cannot periodically remove cells for their off-line analysis because of the risk of contamination or workflow logistics. Here we show in-situ label-free quantitation of viable and non-viable cells with multivariable multi-resonant sensors. We used Chinese hamster ovary (CHO) cells in suspension culture in single-use bioreactors as a representative example. The resonant sensor design strategy permitted enhanced sensor sensitivity versus conventional non-resonant measurements and probed the spectral dispersion of viable and non-viable cells with multiple resonances. These capabilities of label-free in-situ analysis of cell viability can be attractive in diverse cell applications such as cell suspensions, adhered cells, and their 3D assemblages.

We propose the use of Fabry–Perot cavities as a means to augment the enhancement factor in surface-enhanced Raman spectroscopy (SERS) and tip-enhanced Raman spectroscopy (TERS) experiments by optical interference. Using both clean-room and bench-top fabrication approaches, we demonstrate that such a design can be readily realized and provides an additional 12× SERS enhancement and 5× TERS enhancement, in good agreement with expectations from electromagnetic modeling. The mechanism of optical interference enhancement is of far-field nature and is independent of the enhancement mechanisms relying on plasmonic and molecular resonances. Therefore, the Fabry–Perot cavity substrate can be applied generally without material and molecular limitations. The Fabry–Perot cavity structure provides enhancement at large incidence angles away from the surface normal, particularly suitable for low-light Raman measurements with side illumination.

Wearable and distributed sensors are attractive for monitoring of gases for environmental surveillance, industrial safety, and other applications. For these sensors to be of high value, they need suitable detection accuracy in complex backgrounds. Here, we show accurate detection of volatiles using low-cost sensors based on a radio-frequency identification (RFID) platform. Our design and excitation conditions of RFID sensors provide several outputs that result in three- and four-dimensional sensor response after multivariate spectral analysis. This high dimensionality of sensor response, achieved in measurements of multiple model vapors and complex patterns of volatiles, make these RFID sensors an attractive addition to high-end existing analytical instruments.

In this perspective we discuss the roles of hot spots in surface-enhanced Raman spectroscopy (SERS). After giving background and defining the hot spot, we evaluate a variety of SERS substrates which often contain hot spots. We compare and discuss the differentiating properties of each substrate. We then provide a thorough analysis of the hot spot contribution to the observed SERS signal both in ensemble-averaged and single-molecule conditions. We also enumerate rules for determining the SERS enhancement factor (EF) to clarify the use of this common metric. Finally, we present a forward-looking overview of applications and uses of hot spots for controlling chemistry on the nanoscale. Although not exhaustive, this perspective is a review of some of the most interesting and promising methodologies for creating, controlling, and using hot spots for electromagnetic amplification.

An existence proof for single-molecule tip-enhanced Raman spectroscopy (SMTERS) is given using the frequency domain approach involving the two isotopologues of Rhodamine 6G (R6G) that were previously employed for single-molecule surface-enhanced Raman spectroscopy (SMSERS). A combination of experimental and theoretical studies provides a detailed view of the isotopic response of R6G–d0 and R6G–d4 in the 600 – 800 cm–1 region. The single-molecule nature of the TERS experiment is confirmed through two lines of evidence. First, the vibrational signature of only one isotopologue at a time was observed from multiple TER spectra. Second, the spectral wandering of the 610 cm–1 mode of R6G–d0 was less than ±4 cm–1, which in turn is less than the 10 cm–1 isotopic shift so that no confusion in assignment resulted. As a consequence, the total TERS enhancement factor can now be accurately established as EFTERS = 1.0 × 1013 because only one molecule at a time is measured. Furthermore, EFTERS can be partitioned into an...

We explore the correlation between localized surface plasmon resonance (LSPR) of triangular Ag nanoparticles, molecular resonance, and the surface-enhanced resonance Raman excitation profile of molecules adsorbed on these nanostructures. Ag nanoparticles with various LSPRs were fabricated with nanosphere lithography (NSL). A monolayer of tris(2,2′-bipyridine)-ruthenium(II) (Ru(bpy)32+) was introduced to the NSL Ag nanoparticles, and its effect on the LSPR was monitored by UV−vis spectroscopy. Wavelength-scanned surface-enhanced resonance Raman excitation spectroscopy (WS SERRES) profiles of Ru(bpy)32+ adsorbed on Ag nanoparticle arrays were measured for excitation wavelengths in the range of 400−500 nm. The WS SERRES profiles are correlated, both spatially and spectrally, with the corresponding LSPR spectra of the nanoparticle arrays and with the solution absorption spectrum of Ru(bpy)32+. The WS SERRES profile peak position depends on the relative spectral position of LSPR and the molecular resonance. Qu...

After its discovery more than 30 years ago, surface-enhanced Raman spectroscopy (SERS) was expected to have major impact as a sensitive analytical technique and tool for fundamental studies of surface species. Unfortunately, the lack of reliable and reproducible fabrication methods limited its applicability. In recent years, SERS has enjoyed a renaissance, and there is renewed interest in both the fundamentals and applications of SERS. New techniques for nanofabrication, the design of substrates that maximize the electromagnetic enhancement, and the discovery of single-molecule SERS are driving the resurgence of this field. This Account highlights our group's recent work on SERS. Initially, we discuss SERS substrates that have shown proven reproducibility, stability, and large field enhancement. These substrates enable many analytical applications, such as anthrax detection, chemical warfare agent stimulant detection, and in vitro and in vivo glucose sensing. We then turn to a detailed study of the wavelength and distance dependence of SERS, which further illustrate predictions obtained from the electromagnetic enhancement mechanism. Last, an isotopic labeling technique applied to the rhodamine 6G (R6G)/silver system serves as an additional proof of the existence of single-molecule SERS and explores the dynamical features of this process. This work, in conjunction with theoretical calculations, allows us to comment on the possible role of charge transfer in the R6G/silver system.

Surface-enhanced Raman spectroscopy (SERS) is currently experiencing a renaissance in its development driven by the remarkable discovery of single molecule SERS (SMSERS) and the explosion of interest in nanophotonics and plasmonics. Because excitation of the localized surface plasmon resonance (LSPR) of a nanostructured surface or nanoparticle lies at the heart of SERS, it is important to control all of the factors influencing the LSPR in order to maximize signal strength and ensure reproducibility. These factors include material, size, shape, interparticle spacing, and dielectric environment. All of these factors must be carefully controlled to ensure that the incident laser light maximally excites the LSPR in a reproducible manner. This article describes the use of nanosphere lithography for the fabrication of highly reproducible and robust SERS substrates for both fundamental studies and applications. Atomic layer deposition (ALD) is introduced as a novel fabrication method for dielectric spacers to study the SERS distance dependence and control the nanoscale dielectric environment. Wavelength scanned SER excitation spectroscopy (WS SERES) measurements show that enhancement factors approximately 10(8) are obtainable from NSL-fabricated surfaces and provide new insight into the electromagneticfield enhancement mechanism. Tip-enhanced Raman spectroscopy (TERS) is an extremely promising new development to improve the generality and information content of SERS. A 2D correlation analysis is applied to SMSERS data. Finally, the first in vivo SERS glucose sensing study is presented.

A detailed wavelength-scanned surface-enhanced Raman excitation spectroscopy (WS SERES) study of benzenethiol adsorbed on Ag nanoparticle arrays, fabricated by nanosphere lithography (NSL), is presented. These NSL-derived Ag nanoparticle array surfaces are both structurally well-characterized and extremely uniform in size. The WS SERES spectra are correlated, both spatially and spectrally, with the corresponding localized surface plasmon resonance (LSPR) spectra of the nanoparticle arrays. The surface-enhanced Raman scattering (SERS) spectra were measured in two excitation wavelength ranges: (1) 425-505 nm, and (2) 610-800 nm, as well as with the 532-nm line from a solid-state diode-pumped laser. The WS SERES spectra have line shapes similar to those of the LSPR spectra. The maximum SERS enhancement factor is shown to occur for excitation wavelengths that are blue-shifted with respect to the LSPR lambda(max) of adsorbate-covered nanoparticle arrays. Three vibrational modes of benzenethiol (1575, 1081, and 1009 cm(-1)) are studied simultaneously on one substrate, and it is demonstrated that the smaller Raman shifted peak shows a maximum enhancement closer to the LSPR lambda(max) than that of a larger Raman shifted peak. This is in agreement with the predictions of the electromagnetic (EM) enhancement mechanism of SERS. Enhancement factors of up to approximately 10(8) are achieved, which is also in good agreement with our previous SERES studies.

Multiple vibrational modes have been observed for copper phthalocyanine (CuPc) adlayers on Ag(111) using ultrahigh vacuum (UHV) tip-enhanced Raman spectroscopy (TERS). Several important new experimental features are introduced in this work that significantly advance the state-of-the-art in UHV-TERS. These include (1) concurrent sub-nm molecular resolution STM imaging using Ag tips with laser illumination of the tip-sample junction, (2) laser focusing and Raman collection optics that are external to the UHV-STM that has two cryoshrouds for future low temperature experiments, and (3) all sample preparation steps are carried out in UHV to minimize contamination and maximize spatial resolution. Using this apparatus we have been able to demonstrate a TERS enhancement factor of 7.1 × 10(5). Further, density-functional theory calculations have been carried out that allow quantitative identification of eight different vibrational modes in the TER spectra. The combination of molecular-resolution UHV-STM imaging with the detailed chemical information content of UHV-TERS allows the interactions between large polyatomic molecular adsorbates and specific binding sites on solid surfaces to be probed with unprecedented spatial and spectroscopic resolution.

The ability to control the size, shape, and material of a surface has reinvigorated the field of surface-enhanced Raman spectroscopy (SERS). Because excitation of the localized surface plasmon resonance of a nanostructured surface or nanoparticle lies at the heart of SERS, the ability to reliably control the surface characteristics has taken SERS from an interesting surface phenomenon to a rapidly developing analytical tool. This article first explains many fundamental features of SERS and then describes the use of nanosphere lithography for the fabrication of highly reproducible and robust SERS substrates. In particular, we review metal film over nanosphere surfaces as excellent candidates for several experiments that were once impossible with more primitive SERS substrates (e.g., metal island films). The article also describes progress in applying SERS to the detection of chemical warfare agents and several biological molecules.

The surface-enhanced Raman excitation profiles (REPs) of rhodamine 6G (R6G) on Ag surfaces are studied using a tunable optical parametric oscillator excitation source and versatile detection scheme. These experiments afford the ability to finely tune the excitation wavelength near the molecular resonance of R6G (i.e., approximately 500-575 nm) and perform wavelength-scanned surface-enhanced Raman excitation measurements of a single molecule. The ensemble-averaged surface-enhanced REPs are measured for collections of molecules on Ag island films. The relative contributions of the 0-0 and 0-1 vibronic transitions to the surface-enhanced REPs vary with vibrational frequency. These results highlight the role of excitation energy in determining the resonance Raman intensities for R6G on surface-enhancing nanostructures. Single-molecule measurements are obtained from individual molecules of R6G on Ag colloidal aggregates, where single-molecule junctions are located using the isotope-edited approach. Overall, single-molecule surface-enhanced REPs are narrow in comparison to the ensemble-averaged excitation profiles due to a reduction in inhomogeneous broadening. This work describes the first Raman excitation spectroscopy studies of a single molecule, revealing new information previously obscured by the ensemble.

The optical response of individual nanoparticles is strongly influenced by their structures. In this report, we present a quick and simple pattern-matching based approach in which optical images of nanoparticles from localized surface plasmon resonance and single-molecule surface-enhanced Raman spectroscopy were used in conjunction with transmission electron microscopy for correlation of optical responses and the nanostructures of exactly the same nanoparticles or clusters of nanoparticles.

The existence of single-molecule surface-enhanced Raman spectroscopy (SMSERS) is proven by employing a frequency-domain approach. This is demonstrated using two isotopologues of Rhodamine 6G that offer unique vibrational signatures. When an average of one molecule was adsorbed per silver nanoparticle, only one isotopologue was typically observed under dry N2 environment. Additionally, the distribution of vibrational frequencies hidden under the ensemble average is revealed by examining the single-molecule spectra. Correlation with transmission electron microscopy reveals that SMSERS active aggregates are composed of multiple randomly sized and shaped nanoparticles. At higher coverage and in a humid environment, adsorbate interchange was detected. Using 2D cross correlation, vibrational modes from different isotopologues were anti-correlated, indicating that the dynamic behavior was from multiple molecules competing for a single hot spot. This allows hot-spot diffusion to be directly observed without analyzing the peak intensity fluctuations.

Since the discovery of SERS nearly thirty years ago, it has progressed from model-system studies of pyridine to state-of-the-art surface-science studies coupled with real-world applications. We have demonstrated a SERS-based glucose sensor as an example of the latter. A SERS-active surface functionalized with a mixed SAM was shown to partition and departition glucose efficiently. The two components of the SAM, DT and MH, provide the appropriate balance of hydrophobic and hydrophilic groups. The DT/MH-functionalized SERS surface partitioned and departitioned glucose in less than 1 min, which indicates that the sensor can be used in real-time, continuous sensing. Furthermore, quantitative glucose measurements, in the physiological concentration range, in a mixture of interfering analytes and in bovine plasma were also demonstrated. Finally, the DT/MH-functionalized SERS surface showed temporal stability for at least 10 days in bovine plasma, making it a potential candidate for implantable sensing.

We present here a detailed study of the specific nanoparticle structures that give rise to single-molecule surface-enhanced Raman scattering (SMSERS). A variety of structures are observed, but the simplest are dimers of Ag nanocrystals. We chose one of these structures for detailed study using electrodynamics calculations and found that the electromagnetic SERS enhancement factors of 10(9) are easily obtained and are consistent with single-molecule SERS activity.