5 results on '"Hiroaki Iwane"'
Search Results
2. Preparation of Amorphous Lipon Electrolyte Particles Using the Polygonal-Barrel Plasma Treatment System
- Author
-
Hideki Nishizawa, Hiroaki Iwane, Yuzo Tasaki, Hideshi Kikuyama, Yuji Honda, and Takayuki Abe
- Abstract
Introduction Bulk-type all-solid-state lithium ion batteries consisting of electrode and electrolyte particles are expected to find application in electric vehicles. The systems using oxide-based electrolyte particles can make batteries safer, because they do not produce toxic gases such as H2S, which can be generated in sulfide-based systems by a reaction between electrolyte particles and air moisture [1]. However, the charge capacity of oxide-based systems is too small for the application in electric vehicles. To improve this capacity, it is important to increase lithium ion-conduction paths such as electrode particle‒electrolyte particle interfaces in the cathode. Effective lithium ion-conduction paths can be produced in the cathode by using small electrolyte particles with high ion conductivity in a mixture with electrode particles. However, to the best of our knowledge, there have been no oxide-based electrolyte particles that can be used effectively for this purpose. We, therefore, focused our attention on amorphous lithium phosphorus oxynitride (Lipon) electrolytes, which have been used practically in film-type all-solid-state lithium ion batteries [2,3]. While Lipon particles are conventionally prepared using a solid-state reaction [4], this method causes crystallization of the obtained Lipon particles due to heating at 950ºC, resulting in low ion conductivity. In contrast, the novel system we developed recently for the N2 plasma treatment of powder samples, called the “polygonal-barrel plasma treatment system” [5], achieves the nitridation of the particles without heating [5]. In this study, the preparation of amorphous Lipon particles with a small size and high ion conductivity was investigated by treating Li3PO4 particles with N2 plasma using the polygonal-barrel plasma treatment system. Experimental Samples were prepared by treating Li3PO4 particles (Toshima Manufacturing Corporation, 29 µm and 77 nm average particle sizes) with N2 plasma. The N2 plasma treatment was performed at an RF power of 100 W and an N2 gas pressure of ca. 13 Pa for 30-180 min without heating. During treatment, the hexagonal barrel containing the powdery sample was oscillated at 5 rpm over an angular range of ± 75º. The obtained samples were characterized by X-ray photoelectron spectroscopy (XPS) and cross-sectional observation using a transmission electron microscope (TEM). The lithium-ion conductivity of the samples was determined by impedance measurements (frequency range: 5 Hz-1 MHz). Results and discussion The color of the samples changed from white to light brown after N2 plasma treatment. To clarify the cause of this change, the as-received Li3PO4 and the plasma-treated samples with a particle size of 29 µm were examined by XPS. The results showed the presence of the N1s peak only for the plasma-treated samples. The N1s spectrum of the sample treated for 60 min, shown in Figure 1 (I), had an asymmetric peak, which was deconvoluted into the peaks for the N-P=N bond (peak position: 397.9 eV) and the N-P3PO4 particles are employed. The ion conductivity of the samples (particle size: 77 nm) was measured by impedance measurements. In all cases, the Cole-Cole plot of a sample had a semicircular shape, and the magnitude of the semicircle was decreased by N2 plasma treatment. Figure 1 (II) shows the ion conductivity determined from the Cole-Cole plots versus sample treatment time. Ion conductivity was increased by N2 plasma treatment, and the maximum ion conductivity after 90-min treatment (8.80 × 10-6 S cm-1) was higher than the values reported for Lipon films (e.g., 6.4 × 10-6 S cm-1 [3]). These results demonstrate that our plasma treatment system allows the preparation of small, highly ion conductive amorphous Lipon electrolyte particles, which will be useful to improve the charge capacity of bulk-type all-solid-state lithium ion batteries. References [1] T. Ohtomo, A. Hayashi, M. Tatsumisago, K. Kawamoto, J. Mater. Sci. 48 (2013) 4137. [2] Z. Hu, D. Li, K. Xie, Bull. Mater. Sci. 31 (2008) 681. [3] N. Suzuki, T. Inaba, T. Shiga, Thin Solid Films 520 (2012) 1821. [4] K. Senevirathne, C.S. Day, M.D. Gross, A. Lachgar, N.A.W. Holzwarth, Solid State Ionics 233 (2013) 95. [5] K. Matsubara, M. Danno, M. Inoue, Y. Honda, N. Yoshida, T. Abe, Phys. Chem. Chem. Phys. 15 (2013) 5097. Figure 1
- Published
- 2016
3. [A case of gastric carcinoma with diffuse bone marrow carcinomatosis showing osteosclerosis]
- Author
-
Katsuyuki, Koichi, Shuzou, Tugawa, Hiroaki, Iwane, Tomoko, Nakatumi, Toshirou, Nagayoshi, and Masanobu, Kitagawa
- Subjects
Male ,Stomach Neoplasms ,Humans ,Disseminated Intravascular Coagulation ,Middle Aged ,Bone Marrow Neoplasms ,Osteosclerosis - Published
- 2002
4. Effect of Zr, V, Nb, Mo, and Ta substitutions on magnetic properties and microstructure of melt-spun SmCo5 magnets
- Author
-
Abe Kazutomo, Ryuji Tamura, Tadaaki Oikawa, Fukuzaki Tomokazu, Hiroaki Iwane, and Toshihiro Doi
- Subjects
Crystallography ,Materials science ,Ferromagnetism ,Annealing (metallurgy) ,Magnet ,Metallurgy ,Zirconium alloy ,Melting point ,General Physics and Astronomy ,Melt spinning ,Coercivity ,Microstructure - Abstract
We have investigated effects of metal substitutions on the magnetic properties and microstructure of melt-spun Sm-Co-Cu-Fe-M (M = Zr, V, Nb, Mo, Ta) magnets. We prepared melt-spun ribbons with compositions of Sm(Co1−xCux)5Fe0.54−yMy (x = 0.1–0.5, y = 0–0.43, M = Zr, V, Nb, Mo, Ta). For compositions of Sm(Co1−xCux)5Fe0.54 (x = 0.1–0.5), coercivity increased with increasing of annealing temperature, and a high coercivity of 17.6 kOe was obtained at a Cu content of x = 0.3. The coercivity was found to increase with increasing melting point of the substitution element. A high coercivity of 24.5 kOe was obtained for a composition of Sm(Co0.7Cu0.3)5Fe0.34Ta0.2.
- Published
- 2014
5. Entrapment of phenylalanine ammonia-lyase in silk fibroin for protection from proteolytic attack
- Author
-
Shintaro Inoue, Takashi Nose, Yuji Matsunaga, Hiroaki Iwane, and Mikio Sotomura
- Subjects
Ammonia-Lyases ,Phenylalanine ,Biophysics ,Fibroin ,macromolecular substances ,Phenylalanine ammonia-lyase ,Biochemistry ,In vivo ,Phenylketonurias ,medicine ,Animals ,Chymotrypsin ,Trypsin ,Molecular Biology ,Phenylalanine Ammonia-Lyase ,chemistry.chemical_classification ,biology ,Chemistry ,technology, industry, and agriculture ,Cell Biology ,Enzyme assay ,Rats ,stomatognathic diseases ,Enzyme ,Cinnamates ,biology.protein ,Fibroins ,medicine.drug - Abstract
Phenylalanine ammonia-lyase was entrapped in silk fibroin. The entrapped enzyme showed a similar Km for Phe and pH optimum to the free enzyme. It was resistant against chymotrypsin and trypsin in vitro . To assess the activity in vivo , the free or entrapped enzymes and then Phe were injected into rat duodenum, and cinnamate, a product, in plasma was determined as the most direct evidence of the enzyme activity. The entrapped enzyme but not the free form caused a marked raise of plasma cinnamate. It declined with a half life of about 45 min, which was significantly longer than that(10–15 min) observed upon i.v. administration of cinnamate. These results indicated that the entrapped enzyme was actively degrading Phe in the intestinal tract. Entrapment of phenylalanine ammonia-lyase in fibroin thus provides a new prospect for oral enzyme therapy of phenylketonuria.
- Published
- 1986
Catalog
Discovery Service for Jio Institute Digital Library
For full access to our library's resources, please sign in.