Search

In the following years and decades the increase in cooling capacity will put tremendous pressure on the energy infrastructure and severely increase the environmental impacts. In a moderate climate and well thermally insulated buildings like, e.g., in Europe, installation of low-exergy radiant systems could help alleviate these negative effects. Wall systems may be especially suitable for installation in existing buildings, however, their possible applications in buildings retrofit have not been fully explored. We therefore investigate the possible applications of wall cooling in existing buildings by numerical simulations of two-dimension heat flow through a wall fragment. Three wall systems are proposed and compared in terms of thermal response and heat transfer. The effect of various parameters is investigated to facilitate the design of the wall systems.

Radiant systems are being increasingly used for space heating and cooling of buildings. The contemporary research of radiant systems addresses mainly floor and ceiling structures. Research regarding the possibilities of their incorporation in wall structures is lacking, despite their potential advantages. This study addresses a radiant wall system manufactured according to a patent. The patented design involves panels that consist of pipes arranged in milled channels in thermal insulation. The potential advantage of this system is the fact that the thermally active panels can be attached to the facades of existing buildings as a part of their retrofit. Thereby, only minor interventions on the interior side of the retrofitted buildings are needed. To test and improve the design of the wall system, laboratory measurements and computer simulations were performed on a wall fragment for its operation under summer conditions. The results indicate a significant potential for improvement of the patented design by addressing the imperfections in the contact between pipe and wall. Inserting a metal fin between pipe and wall enhanced the cool distribution within the wall fragment considerably. From the three materials of the metal fin considered, using copper led to highest values of the cooling output, followed by aluminium. For these two metals the effect of increasing the thickness of the fin on the cooling output was small. On the contrary, the fin made of steel was the least efficient in terms of cool distribution. In this case the cooling output was most sensitive to the thickness of the fin.