Search

The effects of wet chemical treatments before treatment using (NH4)2S solutions in atomic layer deposition Al2O3/InGaAs metal-oxide-semiconductor (MOS) interfaces are experimentally examined. It is found that no chemical treatment before sulfur passivation leads to high interface state density (Dit) in spite of the (NH4)2S treatment. Furthermore, the value of Dit is dependent among the pretreatments using NH4OH, HCl, and BHF solutions before the sulfur treatment. HCl + (NH4)2S and BHF + (NH4)2S combinations show the lowest values of Dit. In addition, all of the Al2O3/InGaAs MOS interfaces with the sulfur treatment show a small amount of arsenic oxide. Thus, much higher Dit of the interfaces with the sulfur treatment indicates that the amount of arsenic oxide is not a deterministic factor for Dit. On the other hand, the amount of arsenic oxide before the sulfur treatment is found to correlate with Dit after sulfur treatment. Also, the interfaces with higher Dit after the sulfur treatment show a larger number of sulfur atoms remaining at the interfaces. These experimental results mean that there is a strong correlation among Dit, the amount of arsenic oxide, and the number of sulfur atoms remaining at the Al2O3/InGaAs interfaces. As a result, we can interpret for the present experimental results that the sulfur treatment can have two opposite impacts on Dit at the Al2O3/InGaAs interfaces: the decrease in Dit due to etching of native oxides and suppression of oxidation by sulfur passivation and the increase in Dit due to defect generation through some interaction between sulfur and arsenic oxide. [ABSTRACT FROM AUTHOR]

The thin gap chambers (TGCs) are used for the muon trigger system in the end-cap regions of the ATLAS detector. The TGC mass production phase at High Energy Accelerator Research Organization (KEK) started in January 2001. As the anode-cathode distance is small, 1.4 ram, chamber flatness is essential to achieve a uniform gas gain over the chamber. In order to perform a stable production with high quality we developed a chamber closing system. When we glue two half-chambers together, we sandwich them between a granite table and an aluminum honeycomb panel to keep the chamber flat from both sides. By using silk screens, we control the quantity of epoxy adhesive that affects the chamber thickness. Due to these developments, we can achieve the flatness of less than 100 [micro]m. Uniformity of detection efficiency of the TGC is measured with a cosmic-ray test bench at Kobe University. So far we have tested 300 TGCs. Position dependence of the efficiency is measured with a granularity of 5 mm x 5 mm. The average efficiency over the tested chambers is achieved to be 99% excluding the wire supports and spacers. Index Terms--Gas detectors, proportional counters, triggering.

Copyright of Il Nuovo Cimento: B is the property of Springer Nature and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

Experimental viscosity measurements of aqueous solutions of CO2 along three isotherms at 273, 276, and 278 K for pressures up to 30 MPa are reported. The measurements have been carried out in a falling capillary viscometer and have an estimated uncertainty of ±1.5%. The experimental values were compared with the correlation proposed by Kanti et al. derived from Flory's theory. The equation is in poor agreement with the experimental values, but the equations of Kanti et al. and of Grunberg and Nissan with one adjustable parameter yield good agreement with the experimental data. [ABSTRACT FROM AUTHOR]