Search

This paper was on the forming characteristics of AZ 31B Mg alloy in a combined forward–backward extrusion (CFBE) at warm temperatures. Both experimental studies and thermomechanical finite element analyses were performed. A finite element analysis model coupled with damage evolution was presented. Based on our previous work, the forward extrusion ratio, backward extrusion ratio, forming temperature, and punch speed were chosen as the most important process parameters. Two punch speeds of 2 mm/s and 20 mm/s were examined for the forming temperatures of 180 °C and 200 °C. Forward extrusion ratios were 2.25, 4.0, and 9.0, while backward extrusion ratios were 1.33, 2.16, 4.02, and 7.75. Effects of those parameters on the forming limit, deformation behaviors, extrusion load, and the mechanical properties of an extruded product were discussed in detail. [ABSTRACT FROM AUTHOR]

Large area organic light emitting diode (OLED) has been fabricated on flexible polyethylene terephthalate (PET) substrate using electrohydrodynamics spray system with active area of 3 × 3 cm. This solution processing of organic inks and quantum dots is performed at room temperature and atmospheric pressure in a single step processing compatible with roll-to-roll processing system. The thin film characterizations are performed by SEM, TEM, spectroscopes and semiconductor device analyzer. CdSe/ZnS quantum dots are used as emissive layer while PEDOT:PSS and MEH-PPV are used as hole and electron transport layers. OLED produced red light at the wavelength of 634 nm. A life time of 1 h at 0.3 lx was achieved by the OLED device. [ABSTRACT FROM AUTHOR]

Polyethylene oxide (PEO) is a polymer hydrogel possessing ionic conductivity that varies with different percentage of absorbed water molecules and ions. This property makes it a good candidate to be used in humidity sensors’ active layers. The degree of crystallinity of PEO thin films decrease with increasing humidity that facilitates the ion conduction in the thin films, thus reducing the film impedance. In this research work, the humidity sensing properties of the thin films of semi-crystalline PEO have been investigated and the material is then modified to its amorphous dominant phase by heating the thin films beyond the melting point of the polymer. The slowly cooled resulting thin films had a waxy solid like appearance and showed an excellent response towards quantitative detection of relative humidity in the surrounding environment. The results show a roughly linear impedance versus relative humidity curve in the range of 0% RH to 90% RH with a very high maximum achieved sensitivity of ∼35 kΩ/%RH. The response and recovery times measured for the modified sensors were 2.8 s and 5.7 s respectively. The 30 day trial of stability readings showed a standard deviation of only 1%. The results prove thermally modified amorphous PEO thin films to be strong candidates for high end electronic relative humidity sensors. [ABSTRACT FROM AUTHOR]

A high performance humidity sensor for environmental and health monitoring has been fabricated using various combinations of molybdenum carbide (Mo 2 C) with polyacrylamide (PAM) and polyvinyl alcohol (PVA). The humidity sensing properties of pure Mo 2 C were compared with those of its composites with PAM and PVA. The response curves and working principle were investigated and novel bi-layered sensors were then fabricated to achieve highly linear and stable response for a wide range of humidity sensing (0% RH to 90% RH). The sensors having a bi-layer combination of Mo 2 C with PAM give a linear response with a sensitivity of 775 Ω/%RH and excellent repeatability. The working mechanism of the sensors allow them to be used with frequency response conversion read-out circuits and the results ascertain their linear and stable behavior. The response-time and recovery-time of the sensors were measured that gave average values of ∼1 s and ∼2.5 s respectively for the composites and ∼1.8 s and 2.3 s for the bi-layer configuration. The sensors are aimed to replace low performance complex and expensive sensors in the market for environmental and health monitoring applications. [ABSTRACT FROM AUTHOR]