Search

The Brazilian Regulatory Agency for fuel production and commercialization requires that the sodium concentration in alcohol fuel should be determined by flame photometry and that the analytical curves should be obtained with matrix-matched standards. Notwithstanding, this methodology can produce inexact results because alcohol fuel presents a significant variability in matrix composition and, consequently, in the matrix effect. This problem can be circumvented by using the standard addition method (SAM). However, this method is slow and laborious when it carried out by manual procedures. To overcome these drawbacks, an automatic flow-batch SAM for sodium determination in alcohol fuel by flame photometry is described. This system requires only one standard solution, handles about 80 - 140 samples per hour and consumes a total volume of sample and of standard solution smaller than 1.5 mL for each analysis. The results present a standard deviation usually less than 0.1 mg L-1 (n = 4). A agência brasileira que regulamenta a produção e comercialização de álcool combustível estabelece que a concentração de sódio deve ser determinada usando a fotometria de chama e curva analítica construída com soluções padrão preparadas em uma matriz que se assemelhe às amostras. Todavia, essa metodologia pode produzir resultados inexatos porque o álcool combustível apresenta uma variabilidade significativa na composição de matriz e, conseqüentemente, no efeito de matriz. Esse problema pode ser contornado usando o método por adições de padrão (MAP), porém o MAP é lento e trabalhoso quando realizado manualmente. Para superar esses inconvenientes, um sistema Flow-Batch é proposto para automatizar o MAP visando à determinação de sódio em álcool combustível por fotometria de chama. O sistema requer uma única solução padrão, processa cerca de 80 - 140 amostras por hora, consome um volume total de amostra e solução padrão menor que 1,5 mL por análise e apresenta um desvio padrão usualmente menor que 0,1 mg L-1 (n = 4).

A method for the determination of phosphorus in mineralized biodiesel using a micro-flow-batch analyzer (μFBA) with solenoid micro-pumps was proposed. The samples were mineralized using an ashing procedure at 550 °C followed by dissolution of the residue. The determination of phosphorus was performed by employing the well-known molybdenum blue method. The measures of the absorbance were performed at 850 nm using an InfraRed LED integrated into the μFBA. Comparing with the reference method, no statistically significant differences were observed when applying the paired t-test at a 95% confidence level. Recovery study shows results between 97.9% and 105.8%. The proposed microsystem using solenoid micro-pumps presented satisfactory robustness and high sampling rate (190 h −1 ), with satisfactory reproducibility (relative standard deviation n =3), low reagents consumption (32 μL per analysis) and cost to build the device. Moreover, μFBA presents limit of detection (0.014 mg Kg −1 ), precision and accuracy compatible with the biodiesel regulations that establish a maximum concentration of 10 mg Kg −1 (Brazil, USA, EU), suggesting that it is a good alternative for the determination of phosphorus in biodiesel.