Search

The remotely controlled shape memory behaviors of a two-dimensional (2D) sheet to controlled helix structure upon external stimuli is of great significance in the field of smart materials. Herein, we devise a strategy to fabricate a series of shape memory polycaprolactone/[W.sub.18][O.sub.49] nanowire film via highly efficient UV-triggered thiol-acrylate click chemistry. The resultant polymer composites exhibited desirable photothermal transfer efficiency and can enable rapid temperature increase over the melting temperature of polymeric matrix, thus remotely actuating shape transformation within 8 s. Owing to the well- defined architecture of the polymer network, the fabricated elastic composite film exhibited a high degree of crystallinity and showed excellent shape memory properties with [R.sub.f] of 93.12% and [R.sub.r] of 95.32%. Remarkably, under a 160 mW/[cm.sup.2] simulated sunlight illumination, the transformation of flat 2D film into 3D chiral actuators is driven by designing anisotropic bilayer thin sheet, and it yields right- and left-handed helix. This work will pave the way for designing biomimetic flexible actuators toward multifunctional shape-shifting devices. Highlights * Shape memory polycaprolactone/[W.sub.18][O.sub.49] nanowires composite film is fabricated via UV-triggered thiol-ene click chemistry. * Polymer composites exhibit light-activated shape memory behaviors. * The composite films show excellent shape fixity and shape recovery ratio based on the well-defined network. * The shape morphing behaviors of a flexible 2D bilayer strip into 3D chiral actuators are achieved. KEYWORDS flexible actuators, polycaprolactone, shape memory polymers, stimuli- responsive polymers, 1 | INTRODUCTION Stimuli-responsive morphing materials belong to one kind of molecules with 'intelligent' behavior, which can generate corresponding response signals upon the stimuli of heat, light, electric field, etc. [...]

Energy consumption of air-conditioning in wet and hot climates is not only for cooling but, to a large extent, for dehumidification. Taking urban agglomeration in the Pearl River Delta region as a case study, this study analysed the cooling and dehumidification loads during the past 20 years. In addition, the impacts of cooling and dehumidification loads on carbon emissions were determined. The results showed that there was large spatial heterogeneity in the variations of the cooling and dehumidification loads. The cooling design loads in 1991–2020 was increased 1.83% to 5.56% compared to those in 1971–2000, while the loads for dehumidification was decreased 0.92% to 5.5%. Carbon emissions from cooling were increased, exceeding the carbon reduction from dehumidification, which leads to a weak increase in total carbon emissions. This study revealed that air-conditioning design should fully consider climate change impact by separating cooling and dehumidification loads, increasing the cooling load to avoid insufficient air-conditioning output but reducing the dehumidification load to promote energy efficiency of the air-conditioning system and to reduce carbon emissions. More importantly, an assessment of design loads with climate change in city or small scales should be made before determining summer air-conditioning system design capacity. [ABSTRACT FROM AUTHOR]

Background: Gout is a chronic inflammatory diseases caused by monosodium urate crystal deposition. However, the role of interleukin (IL)-36 in gout has not dbeen elucidated. Methods: We enrolled 75 subjects, including 20 healthy controls (HC), 30 patients with acute gout attack and 25 patients in remission. Baseline data were obtained through clinical interrogation and laboratory data were obtained through tests of blood samples. Serum levels of IL-36α were detected using enzyme-linked immunosorbent assay. Spearman correlation analysis was used to investigate the correlation of IL-36α with other parameters. The diagnostic value of IL-36α was demonstrated using a receiver operating characteristic curve. Results: The serum IL-36α level of gout patients in acute attack and remission stage was significantly higher than that of HC. Serum IL-36α was positively correlated with alanine transaminase (ALT) and aspartate transaminase (AST). Serum amyloid A (SAA) levels positively correlated with C-reactive protein levels and erythrocyte sedimentation rates. Glutamyl transpeptidase levels positively correlated with AST and ALT levels. Conclusion: In conclusion, serum IL-36α levels were elevated in patients with gout and correlated with the clinical markers of inflammation. Our findings suggest that IL-36α may be a novel inflammatory indicator for gout. [ABSTRACT FROM AUTHOR]

Plant growth regulators (PGRs) are commonly used in cereal cropping systems to restrict plant height and control lodging. Ethephon has been reported to shorten internodes and increase grain yield of maize. To analyze the transcriptomic profiles of maize internode elongation following ethephon treatment, differentially expressed genes were compared between the treatment and control samples of inbred line Zong 31 using the Affymetrix Maize Genome Array. According to the microarray data, 326 probe sets showed significant change in expression. Further research revealed that the most remarkable effects of ethephon on maize internodes elongation occurred during a 48 h period, when 89 differentially expressed genes were detected. There were dramatic change in transcript levels at 24 h and six Auxin transport genes and four gibberellin biosynthesis pathway genes were differentially expressed in Zong 31 in response to ethephon treatment. In summary, we showed that gaseous ethylene release is involved in internode meristem cell elongation through the regulation of plant hormone signaling in maize. This work provides a platform for studies in which candidate genes will be functionally tested for involvement in internode elongation.

It is important for territorial spatial planning to master meteorological disaster risk under the conditions of climate change and then carry out risk adaptation planning according to local conditions. Taking Beijing, a large city in China, as an example, a meteorological disaster risk assessment model was established based on the framework of hazard factors, disaster‐bearing body exposure, and vulnerability of underlying surface. Combined with 11 years of observation data from 293 high‐density weather stations, the rainstorm and high‐temperature risks of urban, agriculture, and ecological spaces were studied. The results show that (1) rainstorms and high‐temperature are mainly distributed in the built‐up areas of plain towns, which are the climate risk factors that need to be considered. (2) The central city of Beijing is at a high risk of rainstorms and high temperature, indicating that the underlying surface and disaster‐bearing body are highly vulnerable to meteorological disasters. (3) In suburbs with agricultural land, there is a certain rainstorm risk in Fangshan and Daxing districts, and a risk of high temperatures in the southern part of Tongzhou and Daxing. (4) The risk of high temperatures in the ecological space (eco‐zone) is relatively low, but the rainstorm risk is relatively high in Pinggu and Miyun. (5) The strategies of coping with rainstorm and high‐temperature disaster risk in Beijing's territorial space planning were discussed. [ABSTRACT FROM AUTHOR]

The observation facts of trend and variability are estimated for a century‐long timescale, as well as some possible attributions affecting temperature extremes over Beijing‐Tianjin‐Hebei region. In this paper, the new constructed daily maximum and minimum temperature series during the last 100 years in situ stations of Beijing, Tianjin and Baoding city are used, and two 30‐year baseline climatology of 1961–1990 and 1980–2010 are both used in calculating extreme temperature events. The results indicate that there are long‐lasting, frequent and serious extreme warming over Beijing‐Tianjin‐Hebei region, especially for extreme low temperature, with larger declining trends (at 5% significance) from 1981 to 2010 baseline than those from 1961 to 1990 baseline. And from a statistical perspective, El Niño decay years and surface sea temperature (SST) anomalies at some typical ocean regions of the Arabian Sea and the Bengal Bay on the northern Indian Ocean, the Western Pacific and the Mid Atlantic, Southern Indian Ocean and around 45°–85°E, 68°–82°N on the southwest Arctic Ocean can be used as the warning signals denoting extreme warming over Beijing‐Tianjin‐Hebei region. Additionally, urbanization has a significant (at 5% significance) effect on extreme warming over Beijing‐Tianjin‐Hebei region since 1979, with 24.3% warming contribution for annual minimum temperature. [ABSTRACT FROM AUTHOR]

In previous studies, the concept of degree days has been widely used to indicate heating or cooling energy requirements, but it does not consider the dehumidification effect. In the present study, the concept of dehumidification degree days based on moisture content is used, and the degree days over the past 57 years for temperature decreasing and dehumidification in 4 cities belonging to major climate zones of China are analyzed. The results showed that the number of cooling degree days showed a significant increase (1.2–4.6 days/10 a) in all the selected cities, corresponding to the warming climate. In contrast, the degree days of dehumidification accounted for 19%–45% of the total days in summer and showed significant decreases (2.0–3.7 days/10 a) in the cold, hot summer and cold winter, and hot summer and warm winter climate zones. Comfortable days, i.e., days requiring no cooling and no dehumidification, accounting for 8–45% of the total days in summer, decreased significantly in the extreme cold and cold zones (0.9–1.8 days/10 a) but showed no apparent changes in the hot summer and cold winter and hot summer and warm winter climate zones. This study suggests that energy consumption for cooling increases linearly with climate warming, and only the energy consumed for dehumidification had an apparent decrease. The degree days of dehumidification, as well as those requiring no cooling and no dehumidification, should be fully considered in the capacity design of air-conditioning units, especially air-conditioning systems with temperature- and humidity-independent control (THIC). This study indicates that the assessment of energy consumption for requests for air-conditioning in relation to climate change should be carried out after separating energy consumption for cooling from energy consumption for dehumidification to improve building energy efficiency and indoor comfort. [ABSTRACT FROM AUTHOR]