Search

The hydrogen isotope ratio (HIR) of body water and, therefore, of all endogenously synthesized compounds in humans, is mainly affected by the HIR of ingested drinking water. As a consequence, the entire organism and all of its synthesized substrates will reflect alterations in the isotope ratio of drinking water, which depends on the duration of exposure. To investigate the effect of this change on endogenous urinary steroids relevant to doping-control analysis the hydrogen isotope composition of potable water was suddenly enriched from -50 to 200 0/00 and maintained at this level for two weeks for two individuals. The steroids under investigation were 5β-pregnane-3α,20α-diol, 5α-androst-16-en-3α-ol, 3α-hydroxy-5α-androstan-17-one (ANDRO), 3α-hydroxy-5β-androstan-17-one (ETIO), 5α-androstane-3α,17β-diol, and 5β-androstane-3α,17β-diol (excreted as glucuronides) and ETIO, ANDRO and 3β-hydroxyandrost-5-en-17-one (excreted as sulfates). The HIR of body water was estimated by determination of the HIR of total native urine, to trace the induced changes. The hydrogen in steroids is partly derived from the total amount of body water and cholesterol-enrichment could be calculated by use of these data. Although the sum of changes in the isotopic composition of body water was 150 0/00, shifts of approximately 30 0/00 were observed for urinary steroids. Parallel enrichment in their HIR was observed for most of the steroids, and none of the differences between the HIR of individual steroids was elevated beyond recently established thresholds. This finding is important to sports drug testing because it supports the intended use of this novel and complementary methodology even in cases where athletes have drunk water of different HIR, a plausible and, presumably, inevitable scenario while traveling.

Important developments in the diagnosis of scuba diving fatalities have been made thanks to forensic imaging tool improvements. Multi-detector computed tomography (MDCT) permits reliable interpretation of the overall gaseous distribution in the cadaver. However, due to post-mortem delay, the radiological interpretation is often doubtful because the distinction between gas related to the dive and post-mortem decomposition artifactual gases becomes less obvious. We present six cases of fatal scuba diving showing gas in the heart and other vasculature. Carbon dioxide (CO₂) in cardiac gas measured by gas chromatography coupled to thermal conductivity detection were employed to distinguish decomposition from embolism based on the detection of decomposition gases (hydrogen, hydrogen sulfide and methane) and to confirm arterial gas embolism (AGE) or post-mortem offgasing diagnoses. A Radiological Alteration Index (RAI) was calculated from the scan. Based on the dive history, the intra-cadaveric gas was diagnosed as deriving from decomposition (one case, minimal RAI of 61), post-mortem decompression artifacts (two cases, intermediate RAI between 60 and 85) and barotrauma/AGE (three cases, maximal RAI between 85 and 100), illustrating a large distribution inside the bodies. MDCT scans should be interpreted simultaneously with compositional analysis of intra-cadaveric gases. Intra-cadaveric gas sampling and analysis may become useful tools for understanding and diagnosing scuba diving fatalities. In cases with short post-mortem delays, the CO₂ concentration of the cardiac gas provides relevant information about the circumstances and cause of death when this parameter is interpreted in combination with the diving profile.

Postmortem imaging consists in the non-invasive examination of bodies using medical imaging techniques. However, gas volume quantification and the interpretation of the gas collection results from cadavers remain difficult. We used whole-body postmortem multi-detector computed tomography (MDCT) followed by a full autopsy or external examination to detect the gaseous volumes in bodies. Gases were sampled from cardiac cavities, and the sample compositions were analyzed by headspace gas chromatography–mass spectrometry/thermal conductivity detection (HS-GC–MS/TCD). Three categories were defined according to the presumed origin of the gas: alteration/putrefaction, high-magnitude vital gas embolism (e.g., from scuba diving accident) and gas embolism of lower magnitude (e.g., following a traumatic injury). Cadaveric alteration gas was diagnosed even if only one gas from among hydrogen, hydrogen sulfide or methane was detected. In alteration cases, the carbon dioxide/nitrogen ratio was often >0.2, except in the case of advanced alteration, when methane presence was the best indicator. In the gas embolism cases (vital or not), hydrogen, hydrogen sulfide and methane were absent. Moreover, with high-magnitude vital gas embolisms, carbon dioxide content was >20%, and the carbon dioxide/nitrogen ratio was >0.2. With gas embolisms of lower magnitude (gas presence consecutive to a traumatic injury), carbon dioxide content was

We present an investigation of the physico-chemical surface properties of commercially pure titanium coverslips which were submitted to various treatments designed to optimize their topography in view of application in oral implantology. The surface microroughness, chemical composition and water wettability were analyzed on titanium coverslips prepared by mechanical polishing, acid attack in HCl/H2SO4, after mechanical polishing or sandblasting, and titanium plasma-spray. The chemical composition has been measured by Auger electron spectroscopy. The treatments have no major influence on the surface chemical composition and all the samples display a composition approaching that of TiO2 with minor amounts of carbon, sulfur, silicon and calcium as impurities. The roughness has been measured by scanning force microscopy on an area of 20 microns x 20 microns on each sample. Polished titanium is smooth (peak-to-valley roughness 81 nm), whereas the acid-attacked surfaces exhibit a micro-roughness in the microns range (2100 nm for polished and acid attacked; 3600 nm for sandblasted and acid attacked) which is quite reproducible over large areas of the sample. The acid attacked samples present a subsurface layer which contains hydrogen below the native passivating oxide layer. Water wettability measurement shows that all surfaces are hydrophobic with a slightly higher contact angle for the acid attacked surfaces. The different treatments analyzed in this study essentially influence the surface roughness by preserving the chemical composition and the wettability properties of titanium native oxide surface layer.