Search

Exhaust regulations and improved exhaust gas treatment systems have already initiated the trend that brings emissions from brakes and tires to the forefront of traffic-induced particulate matter. The health and environmental relevance of particulate matter has resulted in regulators, industry, and research institutions prioritising the mitigation of non-exhaust particle emissions. To this end, under the umbrella of the United Nations Economic Commission for Europe World Forum for Harmonisation of Vehicle Regulations (UNECE WP.29), the Working Party on Pollution and Energy (GRPE) mandated the Particle Measurement Programme Informal Working Group (PMP-IWG) to develop a Global Technical Regulation (GTR) for measuring brake dust. The standards and procedures defined within the GTR should eventually form the basis for the introduction of a Euro 7 limit value for brake emissions. The purpose of this measurement campaign is to provide an exemplary overview of the emission behaviour of wheel brakes and friction pairings currently available on the market and to identify possible reduction potential with regard to particulate emissions. All measurements were carried out taking into account the draft GTR valid at the time of execution. For the investigations, brakes were selected using the example of different vehicle classes, brake concepts (disc and drum brake), vehicle axles (front and rear axle), and alternative friction materials (brake disc and pads/shoes). Thus, the use of wear-resistant discs and improved brake pad compositions are able to achieve significantly lower emissions. In addition, the measurement of brake dust emissions from vehicles with different levels of electrification was considered. Electrical braking was modelled and applied to the Worldwide Harmonised Light-Duty Vehicles Test Procedure (WLTP) Brake Cycle, which has demonstrated high emission reduction potentials depending on the electrification level. [ABSTRACT FROM AUTHOR]

Brake-wear particle emissions are the result of the components of a friction brake being in tribological contact, and they are classified as non-exhaust emissions. Since most of the emitted particles belong to the size classes of particulate matter (≤10 μm) and differ significantly in terms of their physico-chemical properties from automotive exhaust emissions, this source is of particular relevance to human health and, therefore, the focus of scientific studies. Previous studies have shown that coated brake discs offer significant wear and emission reduction potential. Nevertheless, no studies are available that describe the specific particle formation process, the contact conditions, the structure of the friction layer and the differences compared to conventional grey cast iron discs. The aim of this study is to describe those differences. For this purpose, the tribological behaviour, the structure of the friction layer and the associated particle dynamics within the friction contact between a laser cladding coated disc and a conventional grey cast iron disc are compared. The required investigations are carried out both ex situ (stationary) and in situ (dynamic). Parallel to the tribological investigations, the particle emission behaviour is determined on an inertia dynamometer using a constant volume sampling system (CVS) and equipment for particle number and particle size distribution measurement. The results show that, for two different brake pads, the laser cladding brake disc has lower wear and less particulate emissions than the grey cast iron brake disc. The wear behaviour of the coating varies significantly for the two brake pads. By contrast, the grey cast iron brake disc shows a significantly lower influence. [ABSTRACT FROM AUTHOR]