Search

We experimentally investigated a pilot-aided digital signal processing (DSP) chain in combination with high-order geometric constellation shaping to increase the achievable information rates (AIRs) in standard intradyne coherent transmission systems. We show that the AIR of our system at 15 GBd was maximised using geometrically-shaped (GS) 2048 quadrature amplitude modulation (QAM), reaching 18.0 b/4D-symbol in back-to-back transmission and 16.9 b/4D-symbol after transmission through 100 km of a single-mode fibre after subtracting the pilot overhead (OH). This represents the highest-order GS format demonstrated to date, supporting the highest AIR of any standard intradyne system using conventional optics and 8-bit electronics. Detailed characterisation of the DSP, transceiver performance, and transmission modelling has also been carried out to provide insight into sources of impairments and directions for further improvement.

Transmission of highly spectral efficient 24.5 GBaud quadrature phase shift keying and 16- and 64-quadrature amplitude modulated signals in the S-band between 1492 nm and 1518 nm wavelength is demonstrated over 55 km few-mode fibers. The carrier lines for S-band transmission were generated by a single wideband optical comb source with more than 120 nm optical bandwidth. While the three-mode fiber was originally optimized for C- and L-band transmission, we show that differential mode delay and mode-dependent loss show only a minor wavelength dependence within the measured S-band channels. However, the transceiver sub-system, including S-band optical amplifiers as well as a reduced optical signal-to-noise ratio of the comb source, leads to a significant Q-factor penalty for channels towards the edges of the S-band optical amplifiers below 1495 nm and above 1515 nm wavelength.

We demonstrate a method for experimentally characterizing the second order statistics of nonlinear interference noise (NLIN) as an intersymbol interference (ISI) process. The method enables measurement of the properties of high-order ISI coefficients, which have been largely overlooked in the past. The ability of measuring these statistics is imperative for designing effective NLIN mitigation schemes. The variance, temporal correlation times, and cross correlations of the various ISI coefficients are evaluated in several system implementations.

The use of spectrally shaped amplified spontaneous emission noise (SS-ASE) as a method for emulating interfering channels in optical fibre transmission systems has been studied. It is shown that the use of SS-ASE leads to a slightly pessimistic performance relative to the use of conventionally modulated interfering channels in the nonlinear regime. The additional nonlinear interference noise (on the channel under test), due to the Gaussian nature of SS-ASE, has been calculated using a combination of the Gaussian noise (GN) and enhanced GN (EGN) models for the entire C-band (4.5 THz) and experimentally shown to provide a lower bound for transmission performance.

The performance of digital back-propagation (DBP) for distributed Raman amplified optical communication systems is evaluated through analytical models and numerical simulations, and is compared with conventional lumped amplifier solutions, such as EDFA. The complexity of the DBP algorithm including the characteristic signal power profile of distributed Raman amplifiers is assessed. The use of full-field DBP in distributed Raman amplified systems leads to 1.3 dB additional gain with respect to systems employing lumped amplification, at the cost of only a 25% increase in complexity.

Rivers are important ecosystems that are integrated into biogeochemical cycles and constitute an essential resource for numerous human uses. However, the assessment of the biological diversity and composition of microbial communities found in rivers remains incomplete, partly due to methodological constraints which are only recently being resolved with the advent of next generation sequencing (NGS) techniques. Using 454-pyrosequencing of the 16S gene, the present study analyzed the microbial diversity of the planktonic and sediment populations in a tropical river in northeastern Brazil that is exposed to severe pollution. Six water and six sediment samples were analysed. The dominant bacterial phyla in both sediment and water were the Proteobacteria, followed by Bacteroidetes and Actinobacteria in the water column and by Chloroflexi and Acidobacteria in the sediment. Biological diversity appeared to be greatly decreased by environmental pollution, whereas the microbial community structure was variable across the analyzed transect. Moreover, a narrow relationship between industrial and urban sources of contamination and the bacterial genera detected at these sites has been observed. A variety of potentially pathogenic bacteria was detected, including Klebsiella, Treponema, Faecalibacterium and Enterococcus, indicating that the river might pose a substantial risk to public health. [Int Microbiol 20(1): 11-24 (2017)]., (Copyright© by the Spanish Society for Microbiology and Institute for Catalan Studies.)

This paper investigates the impact of transceiver noise on the performance of digital back-propagation (DBP). A generalized expression to estimate the signal-to-noise ratio (SNR) obtained using DBP in the presence of transceiver noise is described. This new expression correctly accounts for the nonlinear beating between the transceiver noise and the signal in the optical fiber transmission link. The transceiver noise-signal nonlinear beating has been identified as the main reason for the discrepancy between predicted and practical performance of DBP; which has not been previously suggested. This nonlinear beating has been included in the GN model, allowing DBP gains in practical systems to be predicted analytically. Experiments and split-step simulations with and without polarization-mode dispersion (PMD) in the transmission link have been performed. The results show that the impact of transceiver noise greatly outweighs that of PMD, and the analytical expressions are confirmed by the numerical simulations.

The Gaussian noise model is used to estimate the performance of three digital nonlinearity compensation (NLC) algorithms in C-band, long-haul, optical fiber transmission, when the span length and NLC bandwidth are independently varied. The algorithms are receiver-side digital backpropagation (DBP), transmitter-side DBP (digital precompensation), and Split NLC (an equal division of DBP between transmitter and receiver). For transmission over 100×100 km spans, the model predicts a 0.2 dB increase in SNR when applying Split NLC (versus DBP) to a single 32 GBd channel (from 0.4 dB to 0.6 dB), monotonically increasing with NLC bandwidth up to 1.6 dB for full-field NLC. The underlying assumptions of this model and the practical considerations for implementation of Split NLC are discussed. This work demonstrates, theoretically, that, regardless of the transmission scenario, it is always beneficial to divide NLC between transmitter and receiver, and identifies the transmission regimes where Split NLC is particularly advantageous.

Single-polarization direct-detection transceivers may offer advantages compared to digital coherent technology for some metro, back-haul, access and inter-data center applications since they offer low-cost and complexity solutions. However, a direct-detection receiver introduces nonlinearity upon photo detection, since it is a square-law device, which results in signal distortion due to signal-signal beat interference (SSBI). Consequently, it is desirable to develop effective and low-cost SSBI compensation techniques to improve the performance of such transceivers. In this paper, we compare the performance of a number of recently proposed digital signal processing-based SSBI compensation schemes, including the use of single- and two-stage linearization filters, an iterative linearization filter and a SSBI estimation and cancellation technique. Their performance is assessed experimentally using a 7 × 25 Gb/s wavelength division multiplexed (WDM) single-sideband 16-QAM Nyquist-subcarrier modulation system operating at a net information spectral density of 2.3 (b/s)/Hz.

We demonstrate the use of spectrally shaped amplified spontaneous emission (SS-ASE) noise for wideband channel loading in the investigation of nonlinear transmission limits in wavelength-division multiplexing transmission experiments using Nyquist-spaced channels. The validity of this approach is explored through statistical analysis and experimental transmission of Nyquist-spaced 10 GBaud polarization-division multiplexing (PDM) quadrature phase-shift keying and PDM-16-ary quadrature amplitude modulation (QAM) channels, co-propagated with SS-ASE over single mode fiber. It is shown that this technique, which is simpler to implement than a fully modulated comb of channels, is valid for distances exceeding 240 km for PDM-16QAM with dispersion of 16 ps/nm/km, yields a good agreement with theory, and provides a conservative measure of system performance.

Transmission of a net 467-Gb/s PDM-16QAM Nyquist-spaced superchannel is reported with an intra-superchannel net spectral efficiency (SE) of 6.6 (b/s)/Hz, over 364-km SMF-28 ULL ultra-low loss optical fiber, enabled by bi-directional second-order Raman amplification and digital nonlinearity compensation. Multi-channel digital back-propagation (MC-DBP) was applied to compensate for nonlinear interference; an improvement of 2 dB in Q(2) factor was achieved when 70-GHz DBP bandwidth was applied, allowing an increase in span length of 37 km.

The achievable transmission capacity of conventional optical fibre communication systems is limited by nonlinear distortions due to the Kerr effect and the difficulty in modulating the optical field to effectively use the available fibre bandwidth. In order to achieve a high information spectral density (ISD), while simultaneously maintaining transmission reach, multi-channel fibre nonlinearity compensation and spectrally efficient data encoding must be utilised. In this work, we use a single coherent super-receiver to simultaneously receive a DP-16QAM super-channel, consisting of seven spectrally shaped 10GBd sub-carriers spaced at the Nyquist frequency. Effective nonlinearity mitigation is achieved using multi-channel digital back-propagation (MC-DBP) and this technique is combined with an optimised forward error correction implementation to demonstrate a record gain in transmission reach of 85%; increasing the maximum transmission distance from 3190 km to 5890 km, with an ISD of 6.60 b/s/Hz. In addition, this report outlines for the first time, the sensitivity of MC-DBP gain to linear transmission line impairments and defines a trade-off between performance and complexity.

The paper investigates the performance of a blind symbol synchronisation technique for optical OFDM systems based on virtual subcarriers. The test-bed includes a real-time 16-QAM OFDM transmitter operating at a net data rate of 30.65 Gb/s using a single OFDM band with a single FPGA-DAC subsystem and demonstrates transmission over 23.3 km SSMF with direct detection at a BER of 10(-3). By comparing the performance of the proposed synchronisation scheme with that of the Schmidl and Cox algorithm, it was found that the two approaches achieve similar performance for large numbers of averaging symbols, but the performance of the proposed scheme degrades as the number of averaging symbols is reduced. The proposed technique has lower complexity and bandwidth overhead as it does not rely on training sequences. Consequently, it is suitable for implementation in high speed optical OFDM transceivers.

During the last 4 decades, intensive research has focussed on the effect of small organic molecules with antitumour activity that are able to intercalate into DNA and inhibit topoisomerase and telomerase enzymes. In this review, we describe some of the chemical and biological properties of acridine, which is a chemotherapeutic agent that has been used for cancer treatment since 1970. In addition, we summarise the progress that has been made in the development of anticancer agents based on the clinical in vivo/in vitro studies that have been conducted for 13 classes of natural and synthetic acridines.

The effects of a type I AFP on the bulk melting of frozen AFP solutions and frozen AFP+solute solutions were studied through an NMR microimaging experiment. The solutes studied include sodium chloride and glucose and the amino acids alanine, threonine, arginine, and aspartic acid. We found that the AFP is able to induce the bulk melting of the frozen AFP solutions at temperatures lower than 0 °C and can also keep the ice melted at higher temperatures in the AFP+solute solutions than those in the corresponding solute solutions. The latter shows that the ice phases were in super-heated states in the frozen AFP+solute solutions. We have tried to understand the first experimental phenomenon via the recent theoretical prediction that type I AFP can induce the local melting of ice upon adsorption to ice surfaces. The latter experimental phenomenon was explained with the hypothesis that the adsorption of AFP to ice surfaces introduces a less hydrophilic water-AFP-ice interfacial region, which repels the ionic/hydrophilic solutes. Thus, this interfacial region formed an intermediate chemical potential layer between the water phase and the ice phase, which prevented the transfer of water from the ice phase to the water phase. We have also attempted to understand the significance of the observed melting phenomena to the survival of organisms that express AFPs over cold winters.

Synthesis and physico-chemical properties of six 3-(4-bromophenacyl)-5-arylidene-thiazolidine-2,4-diones and eight 3-(4-chlorobenzyl)-5-arylidene-4-thio-imidazolidine-2-ones are described. These products were synthesized by an aldolisation-crotonisation reaction from aromatic aldehydes and 3-substituted thiazolidine-2,4-diones or 4-thio-imidazolidine-2-ones. Hypoglycemic and peripheral antinociceptive activities were investigated for these compounds.