Search

The aim of this study was to investigate the effects of the cryogenic treatment (CT) using liquid nitrogen on tensile properties and microstructures of the 2024-T351 aluminum alloy. Tensile tests were carried out, and tensile fractures were observed using a scanning electron microscope (SEM). The microstructure evolution of 2024-T351 subjected to CT was also studied using both an optic microscope (OM) and a SEM. The components of the second phase were tested with an energy dispersive spectrometer (EDS). The results showed that both the ultimate strength and the yield strength of the 2024-T351 aluminum alloy could be improved through CT without the sacrifice of elongation. In addition, tensile fractures showed that the plasticity of 2024-T351 aluminum might also be improved, as the dimples in the fracture of the CTed specimens were markedly more uniform compared with the untreated specimen. The phenomenon of grains refinement (GR) was found through microstructure observation. It was also found that the second phases were distributed more uniformly after CT. A conceivable mechanism concerning the shrinking effect and crystal grain movement was raised to explain the experimental phenomena. The effects of CT on residual stress in the 2024-T351 aluminum alloy are discussed herein. Measurements showed that tensile residual stress in 2024-T351 was removed, and slight compressive residual stress was generated after CT. This may also contribute to the improvement of the tensile properties of the alloy.

In order to investigate the hydrogen permeation behavior of 316L stainless steel during the microstructural evolution induced by laser peening (LP), an electrochemical hydrogen charging system for initial hydrogen charging of LPed and non-LPed specimen was developed. Afterward, the microhardness, residual stress, and microstructures of the samples were determined and analyzed. Finally, electrochemical hydrogen permeation experiments were undertaken to verify LP's influence on hydrogen permeation parameters of 316L. The results showed that LP reduced the hydrogen-induced hardening rate of the alloy and additionally invoked high magnitude compressive residual stress on its surface. At the layer close to the face of the specimen, the grain refinement rate was as high as 56.18%, which was accompanied by the appearance of high-density dislocations. Compared with the non-LPed sample, the hydrogen permeation time increased significantly, and the saturation current density in steady state hydrogen permeation also decreased gradually.

The aim of this paper is to study the effects of laser peening (LP) on the residual stress distribution and microstructure evolution of AA 6061-T6 under different temperatures. A laser peening experiment was conducted on the square-shape samples by using single spot and 50% overlap shock. Three-dimensional surface morphologies of treated samples were observed. The influence of peening temperature on the distribution of compressive residual stress was analyzed. An optical microscope (OM) and a transmission electron microscope (TEM) were employed to observe the microstructure evolution of the samples before and after LP. The results indicate that, as the peening temperature increases, the micro-hardness increases first and then decreases. The LP process induces high-amplitude compressive residual stress on the surface at different temperatures even if the compressive residual stress slightly reduces with increases in temperature. The maximum compressive residual stress affected layer depth is about 0.67 mm, appearing at a temperature of 160 °C. The OM test revealed that the grain size was significantly decreased after warm laser peening (WLP) and that the average value of grain size was reduced by 50%. The TEM test shows that more dislocation tangles were produced in AA 6061-T6 after WLP; compared to the LP process, the precipitate-dislocation interaction can benefit both strength and ductility for AA 6061-T6, thus enhancing the mechanical properties of the material.