Search

During bridge deck construction, the deck finishing machine and the fresh concrete often produce large vertical loads and torsional moments acting on the bridge girder system. In some cases, these loads can cause excessive vertical deflection and transverse rotation in the bridge girders, leading to many maintenance and safety problems, such as changes in deck thickness and local and global instabilities during construction. To minimize the potential problems caused by deck construction, the AASHOTO LRFD Bridge Design Specification requires consideration of these torsional moments during the design procedure, and a detailed three-dimensional finite element analysis may be conducted. However, for bridge girders with open-section thin-walled sections, only the solid or shell element can be used to recognize the warping of the girder since the torsional warping effect is not included in the classical beam element. In this research, a warping degree of freedom was added to a beam element, and a three-dimensional beam element with seven degrees of freedom (7-DOF) at each node was derived as an alternative method for analyzing girder bridges during deck construction. A computer program based on the 7-DOF beam element was also developed in MATLAB. To assess the 7-DOF beam element, one bridge was selected to measure the transverse rotation, vertical deflection, and stress of the exterior girder and the first interior girder during deck construction. Also, three full-scale numerical models using solid elements, classical three-dimensional beam elements, and 7-DOF beam elements were created based on the geometries and loads of the experimental bridge. A comparative study was conducted by comparing the results from the numerical models and experimental monitoring data to evaluate the 7-DOF beam element. The results showed that the 7-DOF beam element had excellent behavior in analyzing the girder bridges under construction load, especially in the torsional analysis of bridge girders. Also, unlike the solid element model, which also provided reasonable results, the 7-DOF beam element model can compute the internal forces of the cross-sections along the bridge, which allows the 7-DOF beam element to be an alternative approach for design and research requiring less modeling effort and computational complexity. [ABSTRACT FROM AUTHOR]

In bridge design, bridge decks regularly overhang past the exterior girders in arrange to extend the width of the deck whereas constraining the specified number of girders. The overhanging part of the deck comes about in uneven eccentric loads to the exterior girders which are by and large most prominent. These eccentric loads are primarily a result of bridge construction operations as well as the weight of new concrete and other construction live loads. These unbalanced loads can lead to a differential edge deflection of overhang deck and a rotation of the exterior girders. The girder rotation or differential deck deflection can also affect local and global stability of the entire bridge. The objective of this study is to enhance the knowledge and understanding of external girder behavior due to unbalanced eccentric construction loads and to identify the critical factors affecting their rotation. In this article, field data obtained during the construction of two skewed (one with a small skew (3.8°) and the second with a severe skew (24°)) and one non-skewed steel girder bridges are described, and a detailed comparison is presented. The three bridges experienced maximum outward exterior girder rotation during construction which subsequently decreased following construction operations. The field results were used to validate and calibrate the finite element models. The numerical and field-monitored data showed good agreement and can be used to assist bridge designers and construction engineers to design appropriate systems to limit girder rotation during construction. [ABSTRACT FROM AUTHOR]