Search

An active–passive microwave retrieval algorithm for simultaneous determination of soil surface roughness parameters [vertical root-mean-square (RMS) height (${s}$) and horizontal correlation length (${l}$)] is presented for bare soils. The algorithm is based on active–passive microwave covariation, including the improved Integral Equation Method (I2EM), and is tested with global soil moisture active passive (SMAP) observations. The estimated retrieval results for ${s}$ and ${l}$ are overall consistent with values in the literature, indicating the validity of the proposed algorithm. Sensitivity analyses showed that the developed roughness retrieval algorithm is independent of permittivity for ${\varepsilon }_{s} > 10$ [-]. Furthermore, the physical model basis of this approach (I2EM) allows the application of different autocorrelation functions (ACF), such as Gaussian and exponential ACFs. Global roughness retrieval results confirm bare areas in deserts such as Sahara or Gobi. However, the type of ACF used within roughness parameter estimation is important. Retrieval results for the Gaussian ACF describe a rougher surface than retrieval results for the exponential ACF. No correlations were found between roughness results and the amount of precipitation or the soil texture, which could be due to the coarse spatial resolution of the SMAP data. The extension of this approach to vegetated soils is planned as an add-on study. [ABSTRACT FROM AUTHOR]

The L-band passive microwave data from the Soil Moisture Active Passive (SMAP) observatory are investigated for remote sensing of ocean surface winds during severe storms. The surface winds of Joaquin derived from the real-time analysis of the Center for Advanced Data Assimilation and Predictability Techniques at Penn State support the linear extrapolation of the Aquarius and SMAP geophysical model functions (GMFs) to hurricane force winds. We apply the SMAP and Aquarius GMFs to the retrieval of ocean surface wind vectors from the SMAP radiometer data to take advantage of SMAP's two-look geometry. The SMAP radiometer winds are compared with the winds from other satellites and numerical weather models for validation. The root-mean-square difference (RMSD) with WindSat or Special Sensor Microwave Imager/Sounder is 1.7 m/s below 20-m/s wind speeds. The RMSD with the European Center for Medium-Range Weather Forecasts direction is 18° for wind speeds between 12 and 30 m/s. We find that the correlation is sufficiently high between the maximum wind speeds retrieved by SMAP with a 60-km resolution and the best track peak winds estimated by the National Hurricane Center and the Joint Typhoon Warning Center to allow them to be estimated by SMAP with a correlation coefficient of 0.8 and an underestimation by 8%–18% on average, which is likely due to the effects of spatial averaging. There is also a good agreement with the airborne Stepped-Frequency Radiometer wind speeds with an RMSD of 4.6 m/s for wind speeds in the range of 20–40 m/s. [ABSTRACT FROM PUBLISHER]

The objective of the NASA Soil Moisture Active Passive (SMAP) mission is to provide global measurements of soil moisture and freeze/thaw states. SMAP integrates L-band radar and radiometer instruments as a single observation system combining the respective strengths of active and passive remote sensing for enhanced soil moisture mapping. Airborne instruments are a key part of the SMAP validation program. Here, we present an airborne campaign in the Rur catchment, Germany, in which the passive L-band system Polarimetric L-band Multi-beam Radiometer and the active L-band system F-SAR of DLR were flown simultaneously on six dates in 2013. The flights covered the full heterogeneity of the area under investigation, i.e., the main land cover types and all experimental monitoring sites. Here, we used the obtained data sets as a test bed for the analysis of three active–passive fusion techniques: 1) estimation of soil moisture by passive sensor data and subsequent disaggregation by active sensor backscatter data; 2) disaggregation of passive microwave brightness temperature by active microwave backscatter and subsequent inversion to soil moisture; and 3) fusion of two single-source soil moisture products from radar and radiometer. Results indicate that the regression parameters $\beta$ are dependent on the radar vegetation index. The best performance was obtained by the fusion of radiometer brightness temperatures and radar backscatter, which was able to reach the same accuracy as single-source coarse-scale radiometer soil moisture retrieval but on a higher spatial resolution. [ABSTRACT FROM AUTHOR]

The impact of ocean waves on L-band brightness temperatures and backscatter from the ocean surface was analyzed using Aquarius data. Matchups of Aquarius data with significant wave height (SWH) from National Oceanic and Atmospheric Administration (NOAA) WaveWatch3 reanalysis and the ocean surface wind are generated. We perform the analysis using two different wind speed products: special sensor microwave imager/sounder (SSMI/S) and National Center for Environmental Prediction (NCEP) operational data. Interestingly, the influence of SWH manifests itself differently for these two wind speed products. Conditionally, averaged normalized radar cross-section (\sigma _0) and brightness temperatures (\textT\text{B}) by NCEP wind speed show strong influence by SWH over the entire range of NCEP wind speeds with a larger impact at lower wind speeds. However, performing the same analysis conditioned on the SSMI/S wind speed, the conclusion becomes entirely different: the SWH effects appear small at low wind speeds (< 5\,\textm\texts^ - 1) and increase with increasing wind speed. The apparent contradiction is a result of the differing characteristics of NCEP and SSMI/S wind speeds. NCEP wind is an atmospheric model estimate of surface wind velocity, whereas the SSMI/S wind is a microwave remote sensing product, representing the characteristics of sea surface roughness. The impact of SWH needs to be considered when the SSMI/S wind speed is assimilated into the numerical weather prediction models, such as the NCEP. [ABSTRACT FROM PUBLISHER]

The L-band passive and active microwave geophysical model functions (GMFs) of ocean surface winds from the Aquarius data are derived. The matchups of Aquarius data with the Special Sensor Microwave Imager (SSM/I) and National Centers for Environmental Prediction (NCEP) winds were performed and were binned as a function of wind speed and direction. The radar HH GMF is in good agreement with the PALSAR GMF. For wind speeds above 10 \m\cdot\s^-1, the L-band ocean backscatter shows positive upwind–crosswind (UC) asymmetry; however, the UC asymmetry becomes negative between about 3 and 8 \m\cdot\s^-1. The negative UC (NUC) asymmetry has not been observed in higher frequency (above C-band) GMFs for ASCAT or QuikSCAT. Unexpectedly, the NUC symmetry also appears in the L-band radiometer data. We find direction dependence in the Aquarius TBV, TBH, and third Stokes data with peak-to-peak modulations increasing from about a few tenths to 2 K in the range of 10–25- \m\cdot\s^-1 wind speed. The validity of the GMFs is tested through application to wind and salinity retrieval from Aquarius data using the combined active–passive algorithm. Error assessment using the triple collocation analyses of SSM/I, NCEP, and Aquarius winds indicates that the retrieved Aquarius wind speed accuracy is excellent, with a random error of about 0.75 \m\cdot\s^-1. The wind direction retrievals also appear reasonable and accurate above 10 \m\cdot\s^-1. The results of the error analysis indicate that the uncertainty of the GMFs for the wind speed correction of vertically polarized brightness temperatures is about 0.14 K for wind speed up to 10 \m\cdot\s^-1. [ABSTRACT FROM AUTHOR]

This paper describes an algorithm to simultaneously retrieve ocean surface salinity and wind from combined passive/active L-band microwave observations of sea surfaces. The algorithm takes advantage of the differing response of brightness temperatures and radar backscatter to salinity, wind speed, and direction. The algorithm minimizes the least square error (LSE) measure, signifying the difference between measurements and model functions of brightness temperatures and radar backscatter. Three LSE measures with different measurement combinations are tested. One of the LSE measures uses passive microwave data only with retrieval errors reaching 2 psu for salinity and 2 m/s for wind speed. The second LSE measure uses both passive and active microwave data for vertical and horizontal polarizations. The addition of active microwave data significantly improves the retrieval accuracy by about a factor of five. To mitigate the impact of Faraday rotation on satellite observations, we propose the third LSE measure using measurement combinations invariant under the Faraday rotation. For Aquarius, the expected root-mean-square SSS error will be less than 0.2 psu for low winds and increases to 0.3 psu at 25-m/s wind speed for warm waters, and the accuracy of retrieved wind speed will be high (about 1-2 m/s or lower). Our results suggest that combining passive and active microwave observations will allow retrieval of sea surface salinity along with the wind speed and direction. In particular, the LSE measure invariant under the Faraday rotation will be directly applicable to spaceborne missions, such as the NASA Aquarius and Soil Moisture Active Passive missions. [ABSTRACT FROM AUTHOR]

Several soil moisture and sea salinity campaigns, including airborne L-band radiometer measurements, have been carried out in preparation for the European Space Agency Soil Moisture and Ocean Salinity (SMOS) mission. The radiometer used in this context is fully polarimetric and is capable of detecting radio frequency interference (RFI) using the kurtosis method. Analyses have shown that the kurtosis method generally detects RFI in an efficient manner, particularly concerning pulsed, low duty cycle signals, but it has some shortcomings when it comes to more continuous wave signal types. Hence, other detection methods have been investigated as well. In particular, inspection of the third and fourth Stokes parameters shows promising results-possibly as a complement to the kurtosis method. The kurtosis method, however, cannot be used with SMOS data. Since SMOS is fully polarimetric, the third and fourth Stokes parameter method is an option, and a first assessment using a fully polarimetric SMOS data set looks promising. Finally, a variable incidence angle signature algorithm is introduced, and the possibility of using this as an RFI indicator is discussed. [ABSTRACT FROM PUBLISHER]

A robust and simple algorithm is developed to merge L-band radiometer retrievals and L-band radar observations to obtain high-resolution (9-km) soil-moisture estimates from data of the NASA Soil Moisture Active and Passive (SMAP) mission. The algorithm exploits the established accuracy of coarse-scale radiometer soil-moisture retrievals and blends this with the fine-scale spatial heterogeneity detectable by radar observations to produce a high-resolution optimal soil-moisture estimate at 9 km. The capability of the algorithm is demonstrated by implementing the approach using the airborne Passive and Active L-band System (PALS) instrument data set from Soil Moisture Experiments 2002 (SMEX02) and a four-month synthetic data set in an Observation System Simulation Experiment (OSSE) framework. The results indicate that the algorithm has the potential to obtain better soil-moisture accuracy at a high resolution and show an improvement in root-mean-square error of 0.015–0.02- \cm^3/\cm^3 volumetric soil moisture over the minimum performance taken to be retrievals based on radiometer measurements resampled to a finer scale. These results are based on PALS data from SMEX02 and a four-month OSSE data set and need to be further confirmed for different hydroclimatic regions using airborne data sets from prelaunch calibration/validation field campaigns of the SMAP mission. [ABSTRACT FROM PUBLISHER]