Search

A 256-channel time-of-flight electronics system has been developed for a facility called “Back-n white neutron source (WNS)” in China Spallation Neutron Source (CSNS). This paper presents the structure and performance of the electronics system and test results at CSNS-WNS. A piece of lithium glass scintillator, coupled with a 256-channel multi-anode photomultiplier tube, is placed at the center of the neutron beam line as the detector. A 256-channel readout electronics system, including one front-end board (FEB), four time-to-digital converter (TDC) cards and one clock distribution module (CDM), measures the arrival time of each signal from the detector. Signals are sent to FEB from the detector through 15-cm cables and discriminated on FEB. FEB drives differential signals over 2-m cables to the TDC cards. Each TDC card has 64 channels, using a field-programmable gate array (FPGA) to measure the arrival time of each signal. The CDM supplies clock signals to the TDC cards to make them work synchronously. The TDC cards and CDM are housed in one peripheral component interconnect (PCI) eXtensions for Instrumentation chassis. The TDC cards achieve a timing precision of 3.5 ns. The electronics system meets the requirement of the experiment and is currently being used in CSNS. [ABSTRACT FROM AUTHOR]

The Circular Electron Positron Collider (CEPC) is a proposing electron–positron collider in China, which aims for generating high center-of-mass energy colliding above 250 GeV. The high-granularity electromagnetic calorimeter (ECAL) is included in a calorimeter system, which is mainly responsible for the measurement of photon. A particle flow algorithm (PFA)-based ECAL solution will utilize about 400k channels/m3. Here, we present the design and development status of readout electronics based on SPIROC2b for the CEPC ECAL with high-granularity scintillants and silicon photomultipliers (SiPMs). The readout electronics consists of front-end electronics (FEE), data interface (DIF) board, and data acquisition (DAQ) board. The front-end board (FEB) carries SiPMs (S12571-010P), scintillants (PSD), and FEB application-specific integrated circuit (ASIC) (SPIROC2b). Two electronics were designed in this paper, one is for ASIC functionality and performance only, and the other is used as a single layer of a further prototype of ECAL. Electronic test and cosmic ray test have been done to electronics. The results indicate that a charge dynamic from 62 fC to 300 pC at S/N = 2 is successfully achieved, and the minimum ionizing particles (MIPs) are separated from the pedestal. [ABSTRACT FROM AUTHOR]

Jiangmen Underground Neutrino Observatory (JUNO) is a next generation liquid scintillator neutrino experiment under construction phase in South China. Thanks to the anti-neutrinos produced by the nearby nuclear power plants, JUNO will be able to study the neutrino mass hierarchy, one of the open key questions in neutrino physics. One key ingredient for a successful measurement is to use high speed, high resolution sampling electronics located very close to the detector signal. Linearity in the response of the electronics is another important ingredient for the success of the experiment. During the initial design phase of the electronics, a custom design with the Front-End and Read-Out electronics located very close to the detector analog signal has been developed and successfully tested. The present paper describes the electronics structure and the first tests performed on the prototypes. The electronics prototypes have been tested and they show good linearity response, with a maximum deviation of 1.3% over the full dynamic range (1-1000 p.e.), fulfilling the JUNO experiment requirements. [ABSTRACT FROM AUTHOR]