Search

In order to eliminate problems such as corrosion and ash deposition caused by alkalis, effects of the biomass composition and the pressure of syngas in the downstream process on condensation of alkalis in a wood steam/oxygen blown fluidized bed gasification process are investigated based on a model. This model is established by combining Aspen Plus with SimuSage. Aspen Plus is applied to predict the composition of major gas species formed by C, H, O, N, S and Cl, using empirical correlations to predict the yields of non-equilibrium substances. SimuSage is used to study the release and condensation of inorganics associated with the minor elements (Al, Ca, Fe, K, Mg, Na, P, Si and Ti) based on a customized thermodynamic database. Results show that carbonation reactions between alkalis and CO/CO 2 can be occurred during gas cooling, leading to form alkali carbonates in the condensed phase. The temperature window forming melts varies with the change of the downstream pressure of syngas and the elemental composition of biomass. As the syngas pressure in the downstream process decreases, the initial temperature of forming melts during gas cooling is reduced. For biomass lower in K/Cl ratio, the condensate with the largest mass formed during gas cooling is potassium chloride. The condensation rate of Cl increases with the decrease of the K/Cl ratio in biomass. [ABSTRACT FROM AUTHOR]

In a biomass gasification process, condensation of inorganic species can cause problems such as corrosion and deposition on the downstream equipment. In this work, in order to investigate the condensation of inorganics during the gas cooling step of the biomass gasification system, both experimental and modelling studies were conducted. Experiments were performed on a pilot-scale steam/oxygen blown fluidized bed gasification facility. A CO 2 cooled probe was located at the head of a filter to condense inorganic species. Five thermocouples were used to monitor the probe temperature profile. Deposits on the probe were characterized using scanning electron microscopy/energy dispersive X-ray spectroscopy (SEM/EDS) to analyze the elemental composition of deposits. A process model based on the local chemical and phase equilibriums was developed using software SimuSage to predict both release and condensation of inorganics. A customized thermodynamic database extracted from the FactSage 7.1 was used during model calculations. Two cases including with and without addition of bed material were calculated. Results show that the identified elemental compositions of deposit under different gas cooling temperatures reasonably agree with the elemental compositions predicted by model calculations. This demonstrates that the established model and the customized thermodynamic data are valid. A large amount of carbon is identified in the deposit of low temperature probe sections, which may come from the condensed tar. Additionally, a temperature window is found, where melts are formed during gas cooling. [ABSTRACT FROM AUTHOR]