Search

In this paper, system design for a multiple-input–multiple-output (MIMO) relay broadcast channel with individual signal-to-interference-plus-noise ratio (SINR) constraints at mobile stations (MSs) is considered. By exploring the structure of downlink–uplink duality at either the base station (BS) or the relay station (RS), we propose two schemes of joint power allocation and beamforming design at the BS and the RS. The problem of the existence of feasible solutions under practical power constraints at the BS and the RS with given SINR targets is considered first. Then, the problem of sum power minimization is considered. Each design problem can be efficiently solved using optimal joint power allocation and beamforming under the framework of convex optimization. We also show that with subchannel pairing at the RS, the transmission power can be further reduced. Finally, a generalization to the multihop scenario is provided to further improve power efficiency. [ABSTRACT FROM PUBLISHER]

In this paper, a point-to-point orthogonal-frequency- division multiplexing (OFDM) system with a decode-and- forward (DF) relay is considered. The transmission consists of two hops. The source transmits in the first hop, and the relay transmits in the second hop. Each hop occupies one time slot. The relay is half-duplex, and capable of decoding the message on a particular subcarrier in one time slot, and re-encoding and forwarding it on a different subcarrier in the next time slot. Thus, each message is transmitted on a pair of subcarriers in two hops. It is assumed that the destination is capable of combining the signals from the source and the relay pertaining to the same message. The goal is to maximize the weighted sum rate of the system by jointly optimizing subcarrier pairing and power allocation on each subcarrier in each hop. The weighting of the rates is to take into account the fact that different subcarriers may carry signals for different services. Both total and individual power constraints for the source and the relay are investigated. For the situations where the relay does not transmit on some subcarriers because doing so does not improve the weighted sum rate, we further allow the source to transmit new messages on these idle subcarriers. To the best of our knowledge, such a joint optimization inclusive of the destination combining has not been discussed in the literature. The problem is first formulated as a mixed integer programming problem. It is then transformed to a convex optimization problem by continuous relaxation, and solved in the dual domain. Based on the optimization results, algorithms to achieve feasible solutions are also proposed. Simulation results show that the proposed algorithms almost achieve the optimal weighted sum rate and outperform the existing methods in various channel conditions. [ABSTRACT FROM PUBLISHER]

In this paper, we aim to solve the multiuser multi-input multi-output (MIMO) downlink beamforming problem where one multi-antenna base station broadcasts data to many users. Each user is assigned multiple data streams and has multiple antennas at its receiver. Efficient solutions to the joint transmit-receive beamforming and power allocation problem based on iterative methods are proposed. We adopt the group maximum signal-to-interference-plus-noise-ratio (SINR) filter bank (GSINR-FB) as our beamformer which exploits receiver diversity through cooperation between the data streams of a user. The data streams for each user are subject to an average SINR constraint, which has many important applications in wireless communication systems and serves as a good metric to measure the quality of service (QoS). The GSINR-FB also optimizes the average SINR of its output. Based on the GSINR-FB beamformer, we find an SINR balancing structure for optimal power allocation which simplifies the complicated power allocation problem to a linear one. Simulation results verify the superiority of the proposed algorithms over previous works with approximately the same complexity. [ABSTRACT FROM PUBLISHER]