Search

To investigate the spray cooling characteristics and the impact of spray parameters such as chamber pressure, spray height, and spray tilt angle on heat transfer efficiency, a mathematical model based on the Eulerian–Lagrangian frame was established for an R410A closed-loop spray cooling system. The results revealed that the spray pattern is conical, with the center velocity significantly higher than the edge velocity. The temperature distribution of the cooling surface and liquid film height both exhibit a "W" shape, and the surface temperature is lower where the liquid film is thin. There is an optimal liquid film height of approximately 5 μm, at which the cooling surface temperature is the lowest. The surface temperature increases with an increase in the spray chamber pressure. Considering average cooling surface temperature, the optimal tilt angle is 40° with an average surface temperature of 330.1 K. When considering wall temperature and wall heat transfer coefficient uniformity, however, the optimal tilt angle is 10°, leading to the average surface temperature of 332.6 K. When increasing the optimal spray height to 70 mm, the average surface temperature is 313.4 K. [ABSTRACT FROM AUTHOR]

• Spray cooling heat transfer of various surface structures are investigated numerically. • 3D Euler-Lagrangian simulation is performed and wall-film model is used. • Liquid film thickness and streamlines are computed in the vicinity of different fin geometries. • Local film thickness increases in grooves. • The film velocity magnitude depends on the fin blockage. Liquid impingement cooling in the form of jet or spray is an appropriate method to remove heat from small surfaces progressively utilized in industry. In this study, numerical simulations are conducted to investigate the effect of surface structure on heat transfer characteristics. Five different three-dimensional structured surfaces are investigated using Euler-Lagrangian approach. The effect of surface structures is discussed on the liquid film thickness, the liquid film velocity, and the heat flux with its uniformity for a given spray and temperature characteristics. The results show that the convective heat transfer strongly depends on both liquid film thickness and velocity. While the liquid film thickness always grows in the grooved surfaces, its velocity depends on the form and direction of the fins. The averaged values of the film thickness and velocity magnitude are almost independent of the surface temperature. Among the investigated surfaces, the parallel and circular patterns showed the best and worst performance on heat transfer characteristics, respectively. [ABSTRACT FROM AUTHOR]