Search

Based on the demand of vehicle emission research and control, this paper presents the development of a portable vehicle measurement system (PEMS) based on SEMTECH-DS and ELPI+, the vehicle emission tests carried out on actual roads, and the data obtained for the establishment and validation of a vehicle emission model. Based on the results of the vehicle emission test, it was found that vehicle driving conditions (speed, acceleration, vehicle specific power (VSP), etc.) had a significant impact on the pollutant emission rate. In addition, local driving cycles were generated and the frequency distribution of VSP-bin under different cycles was analyzed. Then, through the establishment of an emission rate database, calculation of emission factors and validation of the emission model, a vehicle emission model based on actual road driving conditions was developed by taking VSP as the "surrogate variables". It showed that the emission factor model established in this study could better reflect the vehicle transient emissions on the actual road with high accuracy and local adaptability. Through this study, it could be found that due to the great differences in traffic development modes and vehicle driving conditions in different cities in China, the emission model based on driving conditions was a better choice to carry out the research on vehicle emission in Chinese cities. Compared with directly applying international models or quoting the recommended values of relevant macroscopic guidelines, the emission factor model established in this study, using actual driving conditions, could better reflect the vehicle transient emissions on the actual road with high accuracy and local adaptability. In addition, due to the rapid development of China's urban traffic and the rapid change of driving conditions, it was of great significance to regularly update China's urban conditions to improve the accuracy of the model, no matter which model was chosen. [ABSTRACT FROM AUTHOR]

• The paper integrated the flexible wheelset model calculated by the finite element method into the classical vehicle-track coupling dynamic model, and then imported the bearing substructure model into the vehicle-track coupling dynamic model including flexible wheelset to complete the bearing-vehicle-track coupled dynamic simulation model. • In order to solve the contact relationship between raceway and roller, the slice method is used to describe the contact state of bearing substructure, and the contact between inner ring rib and roller is considered. • To verify the correctness of the established bearing-vehicle-track model, field tests were conducted on the high-speed railway line from Beijing to Tianjin. The field tests verify the effectiveness of the simulation model as well as the correctness of the vehicle model under polygonal wheel wear excitation. • The effects of the different orders and amplitudes of wheel-polygonal wear on dynamic performance of the axle-box system are analyzed and discussed in detail. With the increasing speed of high-speed trains and the deteriorating operation environment of axle-box system, the dynamic performance of axle-box bearing directly affects the stability and safety of operation. In this paper, a bearing-vehicle-track coupling dynamic model is established, and its effectiveness is verified by field tests. The simulation results of the coupling dynamic model including wheel-polygonal wear show that the effect of high order polygonal wheel wear (17th ∼ 21st order) on the axle-box system is greater than that of low order wheel wear (1st ∼ 5th order). The frequency domain of axle-box vertical vibration acceleration excited by high order wheel-polygonal wear is mainly distributed in 400 ∼ 600 Hz. The low order polygonal wheel wear amplitude has little effect on the bearing roller-outer raceway contact load. When the wear amplitude of 20th order polygonal wheel is 0.06 mm, the roller-outer raceway contact load is 27.22% higher than that when the wear amplitude is 0.04 mm. In order to avoid bearing failure caused by excessive bearing roller-raceway contact force, the amplitude of 20th order polygonal wheel wear should reduce to less than 0.04 mm. [ABSTRACT FROM AUTHOR]