Search

The present study evaluated different sludge-reduction mechanisms in the oxic-settling-anaerobic (OSA) process in terms of their effects on methane productivity by anaerobic digestion of sewage sludge. Two different layouts were investigated for the sludge return from an anaerobic side-stream reactor (ASSR) to the anoxic (scheme A) or the aerobic (scheme B) reactor of a pre-denitrification plant. Biochemical methane-potential (BMP) assays performed on the excess sludge revealed that scheme A promoted an overall increase of methane production in the OSA (20 mLCH4 gVSS−1d−1, +19%), although compared with a control CAS plant a significant decrease in the excess sludge production (31%) was obtained. Operating conditions in scheme A caused the occurrence of cell lysis and EPS hydrolysis, thereby increasing the biodegradability of sludge. In contrast, scheme B favoured the occurrence of uncoupling and a maintenance metabolism that did not involve sludge hydrolysis. Consequently, despite a higher reduction of excess sludge (82%), a significant decrease in methane productivity in the OSA (4 mLCH4 gVSS−1d−1, −41%) was observed. Based on the results, implementing the OSA process may allow high levels of methane production by anaerobic digestion to be maintained if specific sludge-reduction mechanisms are triggered in the waterline, also raising the possibility of co-digestion with other feedstocks. [ABSTRACT FROM AUTHOR]

The recovery of biopolymers from sewage sludge could be a crucial step in implementing circular economy principles in wastewater treatment plants (WWTP). In this frame, the present study was aimed at evaluating the simultaneous production of polyhydroxyalkanoates (PHA) and extracellular polymeric substances (EPS) obtainable from the treatment of agro-industrial wastewater. Two biological enrichment systems, aerobic granular sludge (AGS) and a conventional activated sludge operating as a sequencing batch reactor (SBR), were monitored for 204 and 186 days, respectively. The maximum biopolymers accumulation capacity was close to 0.60 mgPHA-EPS gVSS−1 in the AGS when operating at 3 kgCODm−3d−1, whereas in the SBR, it was about half (0.35 mgPHA-EPS gVSS−1). Biopolymers extracted from the AGS were mainly constituted by EPS (>70%), whose percentage increased up to 95% with the OLR applied in the enrichment reactor. In contrast, SBR enabled obtaining a higher PHA production (50% of the biopolymers). Results suggested that organic carbon was mainly channeled toward metabolic pathways for extracellular storing in AGS, likely due to metabolic stressors (e.g., hydraulic selection pressure, shear forces) applied for promoting aerobic granulation. [ABSTRACT FROM AUTHOR]

This work reports the results obtained with an innovative configuration of a closed-static solar greenhouse for sludge drying. The novelty of the solar greenhouse configuration consisted in using a forced ventilation system to provide hot air for sludge drying and the utilization of solar irradiation for energy supply. Wet sewage sludge (97% humidity) was successfully dried up to a residual humidity close to 5% after 25 days during wintertime. The increase of the airflow rate supplied under the sludge bed improved the sludge drying rate. Moreover, the fraction of volatile suspended solids decreased from 70% to 41% after 13 days, indicating that air supply promoted the simultaneous stabilization of the sludge as a side-effect to the drying process. Overall, the specific energy consumption per ton of evaporated water was estimated to approximately 450 kWh/t, resulting in about 55% of energy demand lower than a conventional thermal drying system, while using only free solar energy. The achieved high weight reduction of up to 99% implies a noticeable reduction of the excess sludge handling costs, indicating that solar greenhouse drying is a highly interesting opportunity for sludge drying in medium-small sized WWTPs. [ABSTRACT FROM AUTHOR]

Two experimental campaigns were conducted to optimize the applicability of the Sediment Washing treatment on the marine sediments of Augusta Bay contaminated with heavy metals and total petroleum hydrocarbons (TPH). In the first campaign were used EDTA, citric acid, and acetic acid to removal only heavy metals (Ni, Cu, Zn, Cr, and Hg) from the sediments, while in the second campaign EDTA, citric acid, and EDDS were used to removal heavy metals (Ni, Cu, Cr, and Pb) and TPH. The tests were conducted at different pH values and contact times with 1:10 solid:liquid weight ratio. In the first experimental, at pH values 4, contact time 3 h, and citric acid, high removal efficiencies (78-82%) have been obtained for Ni, Cu, Zn, and Cr metals, while, in the second experimental campaign, at pH value 4, contact time 0.5 h, and citric acid, high removal efficiencies have been achieved especially for Pb and TPH. Finally, on the basis of the results obtained, a conceptual sediment washing treatment layout was proposed and the related costs estimated. [ABSTRACT FROM AUTHOR]

The aim of the present work was to investigate the behavior of a membrane bioreactor (MBR) system for the treatment of oily wastewater. A bench scale MBR was fed with synthetic wastewater containing diesel fuel. Organic carbon, hydrocarbon and ammonium removal, kinetic constants, extracellular polymeric substances production, and membrane fouling rates were monitored. The MBR plant was operated for more than 200 days, and the results highlighted good carbon removal and nitrification, suggesting a sort of biomass adaptation to hydrocarbons. Membrane fouling analysis showed an increase in total resistance, likely due to hydrocarbons, which caused an irreversible fouling (pore blocking) mainly due to oil deposition. [ABSTRACT FROM AUTHOR]