Search

Due to the unbalanced three-phase currents and the torque ripples and speed fluctuations to the drive caused by the current sampling errors of three-phase current sensors and corresponding signal processing circuits, the estimation on current sampling errors is of great importance to eliminate these adverse effects. The observer-based methods, however, present two defects: first, they could increase the computational burden to the drives, thus limiting their practical applications; second, their high dependence on the system speed or position feedback information might degrade the estimation accuracy. To solve these problems, this article proposed a fixed-point sampling method of lower branch flows and three phase-currents, which adopts the relations between the measured currents, rather than any complex algorithm, to estimate the current sampling errors. To coordinate with the proposed strategy, a fixed-point sampling scheme was accordingly rolled out. Compared with the observer-based methods, as a fixed-point one, much applicable to actual digital controllers, it could reduce the computational burden of the drive. Meanwhile, its effectiveness was verified by experimental results on a 1.5-kW IPMSM prototype, which showed accurate estimated current sampling errors and the effectively eliminated torque ripples and speed fluctuations. [ABSTRACT FROM AUTHOR]

This paper proposes an effective sliding mode controller (SMC) for a grid-connected 7-level packed U-cell (PUC7) inverter. The aim is to design a simple controller that deals effectively with the complex control problem of the PUC7 inverter (multiobjective control problem). The selection of the control actions is achieved according to the system state error at every sampling time, regardless of the previous values, which makes the control technique model-independent. The control algorithm evaluates online two cost functions (one for each state error), which are derived on the basis of sliding mode theory, and it selects the optimal control input in order to satisfy the reaching conditions of the two cost functions. Compared with the existing solutions, the proposed SMC technique ensures lower average switching frequency by tuning the hysteresis bandwidth of the capacitor-voltage error. The fast implementation, needless of gains tuning, and simple design procedure are the main features of the proposed algorithm. Simulation and experimental results are presented to prove the effectiveness of the proposed technique in controlling the PUC7 inverter with high dynamic performance and robustness against disturbances and parameters mismatch. [ABSTRACT FROM AUTHOR]