Search

The extensive application of vector phase shift modulation method in permanent magnet synchronous motor drive systems with single dc-link current sensor results in obvious current ripple in the low-speed region. The patterns of these ripples vary greatly in different sectors, leading to nonnegligible phase current reconstruction errors. In this article, an estimation of the local average current change rate (ELAC2R) based reconstruction error suppression method within the switching cycle is proposed to resolve this problem. By comparing the actual and the ideal sampling points, the increase of current ripple and the reconstruction error caused by the combination of the vector phase shift and the single current sensor sampling in the low-speed region are modelled and analyzed. Then according to equivalent modelling of the current ripple between the ideal and the actual sampling points, the more accurate phase current information can be quickly obtained based on the sampling value. The compensation process is significantly simplified and the computation burden of the processor is reduced. Experimental results show that the performance of current reconstruction can be improved effectively with less harmonic content with the proposed method. [ABSTRACT FROM AUTHOR]

Due to the unbalanced three-phase currents and the torque ripples and speed fluctuations to the drive caused by the current sampling errors of three-phase current sensors and corresponding signal processing circuits, the estimation on current sampling errors is of great importance to eliminate these adverse effects. The observer-based methods, however, present two defects: first, they could increase the computational burden to the drives, thus limiting their practical applications; second, their high dependence on the system speed or position feedback information might degrade the estimation accuracy. To solve these problems, this article proposed a fixed-point sampling method of lower branch flows and three phase-currents, which adopts the relations between the measured currents, rather than any complex algorithm, to estimate the current sampling errors. To coordinate with the proposed strategy, a fixed-point sampling scheme was accordingly rolled out. Compared with the observer-based methods, as a fixed-point one, much applicable to actual digital controllers, it could reduce the computational burden of the drive. Meanwhile, its effectiveness was verified by experimental results on a 1.5-kW IPMSM prototype, which showed accurate estimated current sampling errors and the effectively eliminated torque ripples and speed fluctuations. [ABSTRACT FROM AUTHOR]

Because of the time-sharing sampling logic, the three-phase currents reconstructed by single dc-link shunt present significant errors in the permanent magnet synchronous motor drives. A traceback-prediction current correction method for sampled currents is proposed in this article to eliminate the reconstruction errors. According to the analysis of time-sharing sampling errors, the concept of equivalent current change rate during one pulsewidth modulation (PWM) period is introduced, and the phase current characteristic model based on state observer is established. Both the equivalent and instantaneous current change rates can be obtained by the observer-based calculation method. In order to improve the current reconstruction precision, the ultimate values of three-phase currents can be predicted by adopting the proposed traceback-prediction current correction method, which does not require major computation and is easy to implement with no restrictions on the PWM strategy. The effectiveness of the proposed method is verified by experimental results. [ABSTRACT FROM AUTHOR]

The current reconstruction strategies using single current sensor in the motor drives are widely researched. However, the sampled currents do not represent the average values within the modulation period, especially for the asymmetric modulation or asymmetric sampling solutions. This is due to the following two reasons: 1) The detected current values obtained at different sampling points are utilized to calculate the three-phase currents; and 2) the detected instantaneous currents are applied to estimate the average current values. In this letter, the current change rates under different action vectors are estimated to compensate these errors in a three-phase four-switch interior permanent magnet synchronous motor (IPMSM) drive with single current sensor. The effectiveness of the proposed strategy is verified by experimental results on a 5-kW IPMSM motor prototype, which shows that the current reconstruction errors are reduced after compensation. [ABSTRACT FROM AUTHOR]