Search

The efficient operation of a solar cooling system strongly depends on the chiller behavior under part load conditions, since driving energy and cooling load are never constant. For this reason, the performance of a single stage, hot water driven 30 kW H2O/LiBr-absorption chiller employed in a solar cooling system with a field of 350 m² evacuated tube collector has been analyzed under part load conditions with both simulations and experiments. A simulation model has been developed for the whole absorption chiller (Type Yazaki WFC-10), where all internal mass and energy balances are solved. The connection to the external heat reservoirs of hot, chilled, and cooling water is done by lumped and distributed UA values for the main heat exchangers. In addition to an analytical evaporator model-which is described in detail-experimental correlations for UA values have been used for the condenser, generator, and solution heat exchanger. For the absorber, a basic model based on the Nusselt theory has been employed. The evaporator model was developed, taking into account the distribution of refrigerant on the tube bundle, as well as the change in operation from a partially dry to an overflowing evaporator. A linear model is derived to calculate the wetted area. The influence of these effects on cooling capacity and coefficient of performance (COP) is calculated for three different combinations of hot and cooling water temperature. The comparison to experimental data shows a good agreement in the various operational modes of the evaporator. The model is able to predict the transition from partially dry to an overflowing evaporator quite well. The present deviations in the domain with high refrigerant overflow can be attributed to the simple absorber model and the linear wetted area model. Nevertheless, the results of this investigation can be used to improve control strategies for new and existing solar cooling systems. [ABSTRACT FROM AUTHOR]

The paper describes the successful amalgamation of the thermoelectric and the adsorption cycles into a combined electro-adsorption chiller (EAC). The symbiotic union produces an efficiency or COP (coefficient of performance) more than threefold when compared with their individual cycles. The experiments conducted on the bench-scale prototype show that it can meet high cooling loads, typically 120 W with an evaporator foot print of 25 cm², that is 5 W/cm² at the heated surface temperature of 22°C, which is well below that of the room temperature. The COPs of the EAC chiller vary from 0.7 to 0.8, which is comparable to the theoretical maximum of about 1.1 at the same operating conditions. With a copper-foam cladded evaporator, the high cooling rates have been achieved with a low temperature difference. In addition to meeting high cooling rates, the EAC is unique as (i) it has almost no moving parts and hence has silent operation, (ii) it is environmentally friendly as it uses a nonharmful adsorbent (silica gel), and (iii) water is used as the refrigerant. [ABSTRACT FROM AUTHOR]