Search

Bisphenol A (BPA) is an endocrine and metabolic disruptor commonly employed as a color developer in thermal papers. Consequently, BPA derived from thermal papers has been considered an important source of exposure for humans, since this chemical may migrate from paper to skin upon contact. Further, due to recent restrictions on BPA use in some countries, it has been replaced by a new analogue, bisphenol S (BPS). The aim of the present study was to determine levels of BPA and BPS in 190 different thermal receipts, randomly collected from different locations in São Paulo State, Brazil, including receipts from supermarkets, general and fast-food restaurants, gas stations, bus and airplane tickets, and credit card and bank accounts. BPA and/or BPS were detected in 98% of samples at concentrations ranging from below the quantification limit to 4.3% (mg/100 mg paper). The obtained values were higher than amounts previously reported in other countries. The estimated daily intake through dermal absorption from handling of thermal receipt papers was estimated on the basis of concentrations and frequencies of handling of papers by humans in both the general population and occupationally exposed individuals. Fifth percentile, median, and 95th percentile daily intakes by the general population were 0.44, 1.42, and 2 μg/d, respectively, whereas the corresponding values for occupationally exposed population are 21.8, 71 and 101 μg/d. The potential adverse consequences of elevated occupational exposure are currently being examined. [ABSTRACT FROM AUTHOR]

Abstract: Lead (Pb) contamination in the black paper that recovers intraoral films (BKP) has been investigated. BKP samples were collected from the Radiology Clinics of the Dental School of Ribeirão Preto, University of São Paulo, Brazil. For sake of comparison, four different methods were used. The results revealed the presence of high lead levels, well above the maximum limit allowed by the legislation. Pb contamination levels achieved after the following treatments: paper digestion in nitric acid, microwave treatment, DIN38414-54 method and TCLP method were 997μgg−1, 189μgg−1, 20.8μgg−1, and 54.0μgg−1, respectively. Flame atomic absorption spectrometry (FAAS) and inductively coupled plasma mass spectrometry (ICP-MS) were employed for lead determination according to the protocols of the applied methods. Lead contamination in used BKP was confirmed by scanning electron microscopy coupled with energy dispersive X-ray microanalysis (SEM-EDS). All the SEM imaging was carried out in the secondary electron mode (SE) and backscattered-electron mode (QBSD) following punctual X-ray fluorescence spectra. Soil contamination derived from this product revealed the urgent need of addressing this problem. These elevated Pb levels, show that a preliminary treatment of BKP is mandatory before it is disposed into the common trash. The high lead content of this material makes its direct dumping into the environment unwise. [Copyright &y& Elsevier]

This article is a preliminary attempt to understand the corporate social responsibility claims and impacts of Aracruz Celulose sa, Brazil's largest pulp and paper manufacturer. Aracruz locates its operations in the vulnerable biodiversity hotspot of the Atlantic Forest, having acquired 800 000 hectares of land in five states of Brazil for the planting of eucalyptus. It owns some of the largest pulp and paper mills in the country. Both its record of land acquisition and its impact on the environment have resulted in considerable social conflict with the indigenous inhabitants, former slave communities and other small farmers in the state of Espírito Santo, and with supportive activist ngos. The company's application of formal corporate social responsibility practices often flies in the face of its social and environmental impacts. This raises questions about the nature of corporate social responsibility and its claims in developing countries like Brazil and elsewhere. [ABSTRACT FROM AUTHOR]