Search

Nowadays, what captures consumers' primary attention is how to purchase electric vehicles with long range and desirable price. Lightweight construction stands as one of the most effective approaches for prolonging range and lowering costs. As a consequence, it is particularly imperative to undertake lightweight design optimization for the battery bracket of new energy vehicles by applying 3D printing technology. To actualize this goal, Rhino software was initially employed for 3D modeling to design the battery bracket system for a pure electric vehicle in China. Subsequently, topology optimization design of the battery bracket was carried out by adopting Altair Inspire software. Last but not least, manufacturing and assembly inspection were completed using a 3D printer. The results show that the maximum displacement of the battery lower tray bracket after topology optimization is 3.20 mm, which is slightly higher than before, but still relatively small. The maximum Mises equivalent stress rose to 240.7 MPa post-optimization, but brought about a uniform stress distribution at the bottom of the bracket. In comparison, the minimum factor of safety met design requirements at 1. The mass was lessened to 0.348 kg, representing a 49.2% decrease in comparison with pre-optimization levels. The 3D-printed bracket was fabricated by employing a 3D printer, thereby achieving the aforementioned mass abatement. The battery pack parts exhibited a bright surface with low roughness and no discernible warping or deformation defects. As revealed by the assembly results, the components of the battery pack bracket are tightly coordinated with each other, with no evident assembly conflicts, revealing that the dimensional accuracy and fit of the completed parts meet production requirements. These findings lay solid groundwork for the mass production of high-performance battery pack brackets. [ABSTRACT FROM AUTHOR]

• The heat generation model for cylindrical Li-ion battery was built. • A liquid immersion cooling battery pack containing 60 batteries were established. • At 2C discharge rate, 0.5 L/min flow rate was recommended. • The battery pack can address localized high-rate discharge events (4.5C or 6.5C). • Liquid immersion cooling BTMSs have great heat dissipation performance. With the increasingly severe challenges of the thermal management of battery packs for electric vehicles, the liquid immersion cooling technology has gradually attracted more attention due to its superior characteristics such as high heat dissipation efficiency, well temperature uniformity and low risk of thermal runaway. To investigate the heat transfer characteristics of the liquid immersion cooling BTMSs, the 3D model of the 60-cell immersion cooling battery pack was established, and a well-established heat generation model that leveraged parameters derived from theoretical analysis and experiments was incorporated into the 3D simulation to analyze the thermal characteristics of battery pack. The simulation results showed that under the discharging rate of 2C, even with the lowest coolant flow rate in this work (0.2 L/min), no localized abnormal overheating within the battery pack was observed, and the highest temperature was 34.22 °C. The temperature uniformity within the battery pack improved with the increase of the coolant flow rate. It was recommended to maintain a flow rate above 0.5 L/min to ensure a temperature difference below 5 °C. The experimental apparatus of the immersion cooling battery pack was also developed to explore the heat dissipation and temperature uniformity at 2C discharge rate. The simulation results were in well agreement with the experimental results, with the deviation less than 0.43 °C when the flow rate exceeded 0.6 L/min. The effect of the localized high-rate discharge events (4.5C and 6.5C) at different battery pack locations on temperature distribution and uniformity was further discussed based on the verified 3D model. The results suggested that liquid immersion cooling systems offered promising potential for achieving both efficient heat dissipation and preventing thermal runaway in battery packs. [ABSTRACT FROM AUTHOR]