Search

AZ80 hollow profile was produced by porthole-die extrusion. The mechanical behavior and microstructure characteristic of extrusion welds in AZ80 hollow profile during different T5 heat treatments were investigated. Five kinds of morphologies of β-Mg17Al12were observed in turn in weld regions under various temperatures. Extrusion weld is not weakest region in AZ80 hollow profile in terms of hardness, the peak hardness of weld regions is roughly equal to the weld-free regions at different aging temperatures, which is attributed to similar volume fraction, morphology, and size of β-Mg17Al12precipitate in weld regions and weld-free regions. The precipitate-free zones (PFZs) usually form near the welds interface in aging process, and the hardness of PFZs is usually lower than those of weld regions and weld-free regions. Aging at 200°C for 24 h is suitable heat treatment system for AZ80 hollow profile, which can achieve excellent mechanical property and simultaneously reduce the width of PFZs. [ABSTRACT FROM PUBLISHER]

The hot deformation behavior and microstructural evolution of a Ti-55511 alloy in α+β region are investigated by uniaxial compressive tests at elevated temperatures. Transmission Electron Microscope (TEM) and Electron Backscattered Diffraction (EBSD) are employed to observe the microstructures. The spheroidization of lamellate α phases and the dynamic recrystallization (DRX) of β grains are analyzed. It is observed that the flow characteristics are prominently affected by deformation parameters, i.e., the flow stress, peak stress and flow softening stress decrease with the reduced strain rate or the increased deformation temperature. When the deformation temperature is slightly raised or the strain rate is properly reduced, the fraction of spheroidized α phase greatly increases. The substructures are formed in the lamellate α phase, and the β phase wedges into the lamellate α phase. Then, the lamellate α phase is fragmentized and spheroidized. The DRX of β grains is promoted with the raised strain rate or the reduced deformation temperature. Additionally, the higher dislocation density and obvious dislocation pile-ups can be noticed at the α/β interface, which induces the DRX nucleation of β grains at the α/β interface. • Hot deformation behavior and microstructure evolution of a Ti-55511 alloy in α+β region are investigated. • The fraction of spheroidized α phase increases with increasing deformation temperature or reducing strain rate. • The substructures are easily formed in the lamellate α phase, and the β phase wedges into the lamellate α phase. • The DRX of β grains is promoted with the raised strain rate or the reduced deformation temperature. • The obvious DRX of β grains easily nucleate at the α/β interface. [ABSTRACT FROM AUTHOR]