Search

By taking a 130 t/h water-cooled grate biomass boiler as the research object, the ANSYS software is applied to simulate the effects of the tail burnout air's incidence angle, wind speed, and pipe diameter on flow field distribution in the furnace, the movement of unburned carbon particles at the tail of the grate under cold operation. The influence rules of the incidence angle, pipe diameter, and wind speed of the tail burnout air on the combustion in the furnace and the movement of the tail particles were obtained. The results show that the setting of burnout air at the tail of the grate can better organize the air flow field at the grate tail, change the particle distribution, prevent small density particles from directly falling into the ash hopper, and prolong the residence time of particles on the grate. Under the study conditions, with an increase in the outlet velocity and the pipe diameter of the tail burnout air, as the movement degree and the burnout degree of grate particles increase, the boiler efficiency increases. With an increase in the incidence angle of the tail burnout air, the flow field in the furnace and the reduction ratio of the tail particles increases at first and then decreases, and the optimal incidence angle is 11–13°. [ABSTRACT FROM AUTHOR]

In the mechanical ventilation room, human body will block the air flows and change the original airflow organization. In the crowd places, the influence of the crowd may greatly change the indoor air movement and even worsen the environment. So the effect can not be ignored. The paper studied the influence of the human body to the indoor air movement by using the method of Particle Image Velocimetry (PIV) and numerical simulation (CFD). The PIV experiment and numerical simulation contain two conditions. One condition is an empty room and another contains models of human body in the room. The paper compared the result of experiment and numerical simulation. Numerical simulations are demonstrated to be accurate in the two conditions, and the Standard k-ɛ model most accurately predicts the flow in a room contains crowd model. In this study, the numerical simulation and measurements show that the crowds will greatly change the air distribution and the residence time of the flows in the building. Therefore, it is important that crowds be considered in ventilation design. [ABSTRACT FROM AUTHOR]

The ventilation system plays a crucial role in every building. Proper design and optimization of its operation increase the comfort of users due to efficient air exchange and at the same time control its velocity in the rooms. The aim of this paper is the analysis of the effect of plenum box entry on the velocity profile concerning the diffuser face panel. This issue may sometimes be ignored at the design stage but can significantly affect the airflow from the diffuser and consequently increase the risk of draft. The results of the PIV experimental measurements and numerical simulations concerning various entries of the plenum box (top and side) were investigated in this study. The measurements were used to develop the mathematical and numerical models, which were then used to assess the effect of localization of the spigot of the plenum box on its operation. The numerical analysis was carried out on plenum boxes with the air diffuser with a face panel composed of square grid perforations. Analyses show that the entries significantly affect both the way of air distribution inside the plenum box and the profile of the airflow and its velocity under the simulated air diffuser. [ABSTRACT FROM AUTHOR]