Search

Electricity, heating, and cooling are the three main components constituting the tripod of energy consumption in residential, commercial, and public buildings all around the world. Their separate generation causes higher fuel consumption, at a time where energy demands and fuel costs are continuously rising. Combined cooling, heating, and power (CCHP) or trigeneration could be a solution for such challenge yielding an efficient, reliable, flexible, competitive, and less pollutant alternative. A variety of trigeneration technologies are available and their proper choice is influenced by the employed energy system conditions and preferences. In this paper, different types of trigeneration systems are classified according to the prime mover, size and energy sequence usage. A leveled selection procedure is subsequently listed in the consecutive sections. The first level contains the applied prime mover technologies which are considered to be the heart of any CCHP system. The second level comprises the heat recovery equipment (heating and cooling) of which suitable selection should be compatible with the used prime mover. The third level includes the thermal energy storage system and heat transfer fluid to be employed. For each section of the paper, a survey of conducted studies with CHP/CCHP implementation is presented. A comprehensive table of evaluation criteria for such systems based on energy, exergy, economy, and environment measures is performed, along with a survey of the methods used in their design, optimization, and decision-making. Moreover, a classification diagram of the main CHP/CCHP system components is summarized. A general selection approach of the appropriate CCHP system according to specific needs is finally suggested. In almost all reviewed works, CCHP systems are found to have positive technical and performance impacts. [ABSTRACT FROM AUTHOR]

This paper investigates the thermal performance of a translucent solar wall providing, concurrently, storage and restitution of heat, super thermal-acoustic insulation and daylighting to the interior environment. The wall is composed of glazing, silica aerogel used as a transparent insulation material (TIM) and glass bricks filled with fatty acid, an eutectic phase change material (PCM). To assess the TIM–PCM wall thermal behavior, experimentations were conducted in-situ in a full-sized test cell located in Sophia Antipolis, southern France. Experimental data shows that the tested wall is more effective in winter and might cause overheating during the summer mainly due to solar gains and un-cycling behavior of PCM which remains in liquid state. To enhance the energy performance of the wall in summertime, a numerical model describing the heat transfer mechanisms occurring in the PCM layer in combination with the other transparent wall layers is developed. Then, the model of the wall is linked to TRNSYS software to assess the thermal performance of the whole building. The numerical model is validated experimentally and a good agreement is shown comparing the simulated values with the measured data for seven consecutive days in summer and winter. The importance of considering the natural convection effect in the liquid PCM is also demonstrated. Moreover, it was shown that shading devices can effectively reduce overheating while natural night ventilation decreases the indoor temperature without affecting the PCM performance since the outdoor temperature is always higher than the phase change temperature. The use of a glass with selective solar reflection properties depending on the season instead of the ordinary glazing is shown also to be very effective way to overcome the overheating problem. Finally, the TIM-PCM wall is tested under different climate conditions and passive solutions are given to ensure thermal comfort in summer season. [ABSTRACT FROM AUTHOR]