Search

Freeze–thaw cycles are frequently overlooked as a pivotal factor contributing to leakage and structural failures in clayey soil-impermeable barriers used in landfills or tailings repositories in regions subject to seasonal freezing. This investigation explores the recovery and residual strength properties of Jilin ball clay undergoing six freeze–thaw cycles, and assesses the pore structure characteristics through a series of nuclear magnetic resonance (NMR) tests. The results indicate that normal stress has a greater impact on peak recovery strength than dry density and rest periods. Cohesion increases earlier and more significantly during rest periods compared to internal friction angle. Although the pore diameter remains consistent within the micropores during the freeze–thaw cycles, the soil's structural integrity undergoes notable changes. The concluding analysis provides valuable insights for the construction and management of impermeable barriers in landfills or tailings repositories within seasonally frozen areas. [ABSTRACT FROM AUTHOR]

Currently, the treatment of miscellaneous fill foundations, composed of a mixture of domestic garbage, construction solid waste, and natural soil, presents a significant challenge in urban peripheral engineering construction. This paper discusses the application of vibrating rod compaction technology for foundation treatment in Xinjiang. It evaluates the effectiveness of cross-section vibrating rod compaction equipment in reinforcing fine-grained miscellaneous fill foundations. The study analyzes the impact of construction disturbances caused by the insertion of the vibrating rod, monitoring horizontal stresses at various depths. Both laboratory and field tests show significant improvements: soil dry density increased by 8% to 18%, porosity decreased by 10% to 23%, compression modulus increased by 22% to 246%, and compression coefficient decreased by 8% to 70%. Additionally, cohesion (C) and angle of friction (ɸ) saw increases ranging from 7 to 38% and 3% to 25%, respectively. Below a depth of 3 m, cone tip resistance exceeded 10 MPa, and sidewall friction resistance increased to over 100 kPa, surpassing pre-treatment values. The standard penetration test results doubled stroke length compared to pre-treatment, indicating a substantial improvement in foundation bearing capacity. Surface wave tests before and after treatment showed a 15% increase in wave velocity, reflecting a more compact soil structure. The vibrating rod compaction method is innovative, energy-efficient, environmentally friendly, and economically beneficial, holding great potential for future miscellaneous fill treatments. [ABSTRACT FROM AUTHOR]

The effectiveness of national policies for air pollution control has been demonstrated, but the relative effectiveness of short-term emission reduction measures in comparison with national policies has not. Here we show that short-term abatement measures during important international events substantially reduced PM2.5 concentrations, but air quality rebounded to pre-event levels after the measures ceased. Long-term adherence to strict emission reduction policies led to successful decreases of 54% in PM2.5 concentrations in Beijing, and 23% in atmospheric nitrogen deposition in China from 2012 to 2020. Incentivized by "blue skies" type campaigns, economic development and reactive nitrogen pollution are quickly decoupled, showing that a combination of inspiring but aggressive short-term measures and effective but durable long-term policies delivers sustainable air quality improvement. However, increased ammonia concentrations, transboundary pollutant flows, and the complexity to achieving reduction targets under climate change scenarios, underscore the need for the synergistic control of multiple pollutants and inter-regional action. In response to the rebound of air pollution during large events in China, the authors propose that a combination of ambitious short-term measures and enduring long-term pollution control policies is a sustainable solution for improving air quality. [ABSTRACT FROM AUTHOR]

The construction of new towns is one of the main measures to evacuate urban populations and promote regional coordination and urban–rural integration in China. Mining the spatio-temporal pattern of new town hot spots based on multivariate data and analyzing the influencing factors of new town construction hot spots can provide a strategic basis for new town construction, but few researchers have extracted and analyzed the influencing factors of new town internal hot spots and their classification. In order to define the key points of Wuhan's new town construction and promote the construction of new cities in an orderly and efficient manner, this paper first constructs a space-time cube based on the luminous remote sensing data from 2010 to 2019, extracts hot spots and emerging hot spots in Wuhan New City, selects 14 influencing factor indicators such as population density, and uses bivariate Moran's index to analyze the influencing factors of hot spots, indicating that the number of bus stops and vegetation coverage rate are the most significant. Secondly, the disorderly multivariate logistic regression model is used to analyze the influencing factors of emerging hot spots. The results show that population density, vegetation coverage, road density, distance to water bodies, and distance to train stations are the most significant factors. Finally, based on the analysis results, some relevant suggestions for the construction of Wuhan New City are proposed, providing theoretical support for the planning and policy guidance of new cities, and offering reference for the construction of new towns in other cities, promoting the construction of high-quality cities. [ABSTRACT FROM AUTHOR]

Elevated atmospheric reactive nitrogen (Nr) emissions and the subsequent nitrogen (N) deposition have negatively impacted the global environment, particularly in China. In order to assess the long-term trends in atmospheric N deposition in the south of China, Taojiang County in Hunan Province was selected as a representative rural area for study. We analyzed interannual variation in atmospheric Nr, including gaseous ammonia (NH3), nitrogen dioxide (NO2), nitrate acid (HNO3) vapor, particulate ammonium (NH4+), and nitrate (NO3−) in air and NH4+-N and NO3−-N in precipitation from 2011 to 2020. The 10-year average atmospheric wet-plus-dry N deposition was 41.9 kg N ha−1 yr−1, which decreased by approximately 24% after 2012, indicating that NH3 and NOx emissions were effectively reduced by emission controls introduced in 2013. Wet deposition accounted for approximately 74% of the total N deposition and was significantly influenced by annual precipitation amount. Reduced N (NH3, pNH4+, and NH4+ in rainwater) was the dominant form, comprising approximately 58% of the total N deposition, while oxidized N (pNO3−, NO2, HNO3, and NO3− in rainwater) accounted for 42% of the total N deposition. Atmospheric HNO3, NO2, and NH3 concentrations and deposition declined by 30–80% over the decade, while particulate NH4+ and NO3− concentrations and deposition remained at relatively stable levels, which suggests that ongoing research and policy should focus on rural particulate pollution. Future strategies must concentrate on the integrated control of NH3 and NOx emissions to mitigate air pollution and protect human health, particularly in rural areas because current abatement efforts are primarily directed toward urban areas and the industrial sector, whereas non-point source NH3 pollution, influenced mainly by agricultural activities, dominates in rural regions. [ABSTRACT FROM AUTHOR]

A modified parallel model for estimating the thermal conductivity of unsaturated sand was proposed in this study. The heat conduction in the solid phase of sand depends mainly on the form of contacts between solid particles, while water bridges at the particle contacts increase the contact areas and remarkably enlarge the transfer paths of heat conduction in sandy soils. However, the thermal conductivity of the solid particle itself (λs) cannot describe the influence of the form of contacts and water bridges on heat conduction through the solid phase. In this study, the equivalent thermal conductivity of the solid particle (λes) was presented which reflected the influence of the form of contacts and water bridges between particles under dry conditions or a low degree of saturation, respectively. The relationship between λes and degree of saturation was described by hyperbolic expression. The modified model was calibrated using measured values of the thermal conductivity from published datasets, including those for 41 types of sand from 15 studies. Numerical analyses of the temperature field of the energy pile were performed and validated against laboratory measurements. The results illustrated that the modified model was more applicable than the original model for predictions of sand thermal conductivity. [ABSTRACT FROM AUTHOR]

A series of biaxial tests with different initial particle shapes, confining pressures, bond strengths and depositional angles were conducted on coral sand by using a 2D discrete element method simulation. The interactions between particle shape and particle breakage were investigated, and their combined effects on the mechanical behavior of coral sand were analyzed. The test results showed that particle breakage considerably weakens the effect of particle shape and inherent anisotropy on shear strength. The difference between the internal friction angles of unbreakable and breakable agglomerates Δφ decreases with increasing aspect ratio AR, sphericity S, and depositional angle θ. There exists a unique relationship between the relative breakage BrDe and the input energy E for the same agglomerates, which is independent of axial strain and confining pressure. However, this relationship is significantly influenced by the agglomerate shape and depositional angle, and irregular and low depositional angle specimens are more easily broken. In addition, the evolution of the aspect ratio AR and sphericity S of agglomerates was controlled by particle breakage, regardless of the axial strain, confining pressure, bond strength and depositional angle, and these trends were determined by the initial particle shape. [ABSTRACT FROM AUTHOR]

Rainfall data with high spatial and temporal resolutions are essential for urban hydrological modeling. Ubiquitous surveillance cameras can continuously record rainfall events through video and audio, so they have been recognized as potential rain gauges to supplement professional rainfall observation networks. Since video-based rainfall estimation methods can be affected by variable backgrounds and lighting conditions, audio-based approaches could be a supplement without suffering from these conditions. However, most audio-based approaches focus on rainfall-level classification rather than rainfall intensity estimation. Here, we introduce a dataset named Surveillance Audio Rainfall Intensity Dataset (SARID) and a deep learning model for estimating rainfall intensity. First, we created the dataset through audio of six real-world rainfall events. This dataset's audio recordings are segmented into 12,066 pieces and annotated with rainfall intensity and environmental information, such as underlying surfaces, temperature, humidity, and wind. Then, we developed a deep learning-based baseline using Mel-Frequency Cepstral Coefficients (MFCC) and Transformer architecture to estimate rainfall intensity from surveillance audio. Validated from ground truth data, our baseline achieves a root mean absolute error of 0.88 mm h -1 and a coefficient of correlation of 0.765. Our findings demonstrate the potential of surveillance audio-based models as practical and effective tools for rainfall observation systems, initiating a new chapter in rainfall intensity estimation. It offers a novel data source for high-resolution hydrological sensing and contributes to the broader landscape of urban sensing, emergency response, and resilience., Competing Interests: The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (© 2024 Published by Elsevier B.V. on behalf of Chinese Society for Environmental Sciences, Harbin Institute of Technology, Chinese Research Academy of Environmental Sciences.)

Background: Psoriasis is an immune-mediated inflammatory disease characterized by activation of IL-23-driven IL-17-producing T cell and other IL-23 receptor-positive IL-17-producing cell responses. Selective blockade of IL-23p19 with guselkumab was superior to blockade of TNF-α with adalimumab (ADA) in treating moderate-to-severe psoriasis. Objective: Pharmacodynamic responses of guselkumab versus ADA were compared in patients with psoriasis in VOYAGE 1., Design: Inflammatory cytokine serum levels were assessed (n = 118), and lesional and nonlesional skin biopsies were collected (n = 38) in patient subsets at baseline and 4, 24, and 48 weeks after treatment to evaluate pharmacodynamic responses of guselkumab versus those of ADA., Results: Guselkumab provided rapid reductions in serum IL-17A, IL-17F, and IL-22 levels by week 4 versus at baseline, which were maintained through weeks 24 and 48 ( P < .001). The magnitude of reduction of IL-17A and IL-22 at week 48 and IL-17F at weeks 4, 24, and 48 were greater with guselkumab than with ADA (all P < .05). In the skin, guselkumab reduced the expression of IL-23/IL-17 pathway-associated and psoriasis-associated genes., Conclusion: These data provide extensive characterization of pharmacodynamic anti-inflammatory responses to IL-23p19 and TNF-α inhibition in human blood and tissue over time with FDA-approved doses of guselkumab and ADA. Trial registration: ClinicalTrials.govClinicalTrials.gov (NCT02207231)., (© 2024 The Authors.)