Search

The high frame rate (HFR) ultrasonic imaging system based on linear frequency-modulated (LFM) signal constructs images at a high frame rate; the signal-to-noise ratio (SNR) of this system can also be improved. Unfortunately, such pulse compression methods that increase the SNR usually cause range sidelobe artifacts. In an imaging situation, the effects of the sidelobes extending on either side of the compressed pulse will be self-noise along the axial direction and masking of weaker echoes. The improvement on high frame rate ultrasonic imaging system based on LFM signal is considered in this paper. In this proposed scheme, a predistorted LFM signal is used as excited signal and a mismatched filter is applied on receiving end. The results show that the proposed HFR ultrasonic imaging system can achieve higher SNR and the axial resolution is also improved.

This paper mainly introduces the design and implementation of rotary scanning imaging for Endoscopic Ultrasonography System based on USB2.0. The ultrasonic pulse-echo imaging technique has been used. In the paper, we simply introduce the emission circuit, receiving circuit and isolation circuit. According to the character of rotary scanning, we design the synchronous control circuit based on FPGA and data transmission circuit based on USB2.0. Finally the original polar coordinate image is transformed to rectangular coordinate grey image through coordinate transformation. The system performances have been validated by the experimental result gotten by scanning a specific object with continuous rotary motor.

Speckle is the main reason which declines the quality of medical ultrasonic images. In this paper, the initial condition for the Downhill filter, a morphological reconstruction algorithm, is modified and applied in the speckle reduction. Firstly, the initial area and start position as the mark image was determined in the marker image. Then the modified Downhill filter was used in the ultrasonic marker image. The results showed that, in comparison with the other three filters, this modified Downhill filter, while maintaining the integrity of the contour,could reduce the speckle in the regions of cavity efficiently and rapidly.

Lower contrast and speckle noise are the main reasons which decline the quality of medical ultrasonic images. In this paper, a new method is proposed to filter the speckle noises and enhance the contrast simultaneously. Anisotropic diffusion filtering method was firstly applied to filter images. Then the loss of information, which the contrast function of contrast enhancement model lies on, was obtained. Finally, the contrast can be enhanced by using enhancement model. Experimental results show that the proposed method not only removes the speckle noises effectively, but also enhances the contrast obviously. This method supplies an effective approach for improving the quality of medical ultrasonic images.

Ultrasound medical imaging has been widely applied in clinic diagnoses because of its real-time, non-invasiveness and convenience. However, it suffers from severe speckle noises. Until now, a lot of filtering algorithms have been proposed, but none of them is satisfactory. In this paper, four nonlinear filter methods, based on median filter, wavelet decomposition and anisotropic diffusion, are systematically reviewed. Finally, the prospect of the nonlinear filtering method is discussed.

This paper introduces the design and realization of the FIR dynamic filter by EP1C6Q240 of Cyclone of Altera Corporation, showing the hardware diagram of the filter and the process of calculating parameters, and compares and analyzes the B mode ultrasound images created by using the dynamic filter and by using the constant filter.

The high frame rate (HFR) ultrasonic imaging system, which is developed with limited diffraction beams, constructs images at a high frame rate. However the rectangular imaging area, to some extent, restricts the far field imaging information. At the same time, because of one transmission for constructing image, the system suffers from low SNR. In this paper we present a computationally efficient method to construct sector mode image and to increase the SNR in HFR system. The method uses Golay complementary sequence as excitation to realize two transmission events. Each event simultaneously transmits two plane waves with different transmission angle. Then the received echo signals related to different angle are separated according to orthogonality of Golay complementary sequence and used to construct two images of different area by HFR method. Finally the two images are synthesized to one frame of sector mode image.

Compared with medical ultrasonic pulse-echo imaging system, coded excitation system has the potential of higher SNR and deeper penetration depth. In this paper, the basic principle of coded excitation is introduced. Through acoustic intensity analysis, the maximum improvement of SNR of ultrasonic image with coded excitation is deduced. Then, guide lines to choose codes in ultrasonic imaging are introduced. Some codes, such as white noise, pseudo-random code, Golay code, Chirp and pseudo-chirp are described in details. At last, the applications of ultrasonic coded excitation in B-mode imaging, Doppler flow measurement, B-flow imaging and harmonics imaging are described.

A high frame rate (HFR) ultrasonic imaging method developed by Jianyu Lu has been attracting attention in the related imaging area. Because a special weighting on the received signal is needed to implement this method, the imaging system is complicated. This paper presents a new kind of theroetical analysis for the HFR imaging system in view of the angular spectrum concept. Based on the study, the special weighting process can be replaced by Fourier transform. Computer simulation demonstrates the correctness of the analysis. It shows that the constructed images by the new method have the same high quality as those obtained by using the original HFR method while the system implementation is greatly simplified.