Search

To address the common challenges in enhanced biological phosphorus removal (EBPR) related to stability and unfavorable influent carbon to phosphorus ratio, a side-stream EBPR (S2EBPR) process that involves a side-stream anaerobic biological sludge hydrolysis and fermentation reactor was proposed as an emerging alternative. In this study, a full-scale pilot testing was performed with side-by-side operation of a conventional anaerobic-anoxic-aerobic (A2O) process versus a S2EBPR process. A comparison of the performance, activity and microbial community between the two configurations was performed. The results demonstrated that, with the same influent wastewater characteristics, S2EBPR configuration showed improved P removal performance and stability than the conventional A2O configuration, especially when the mixers in the side-stream anaerobic reactor were operated intermittently. Mass balance analysis illustrated that both denitrification and EBPR were enhanced in S2EBPR configuration, where return activated sludge was diverted into the anaerobic zone to promote fermentation and enrichment of polyphosphate accumulating organisms (PAOs), and the influent was bypassed to the anoxic zone for enhancing denitrification. A relatively higher PAO activity and total PAO abundance were observed in S2EBPR than in A2O configuration, accompanied by a higher degree of dependence on glycolysis pathway than tricarboxylic acid cycle. No significant difference in the relative abundances of putative PAOs, including Ca. Accumulibacter and Tetrasphaera, were observed between the two configurations. However, higher microbial community diversity indices were observed in S2EBPR configuration than in conventional one. In addition, consistently lower relative abundance of known glycogen accumulating organisms (GAOs) was observed in S2EBPR system. Extended anaerobic retention time and conditions that generate continuous and more complex volatile fatty acids in the side-stream anaerobic reactor of S2EBPR process likely give more competitive advantage for PAOs over GAOs. PAOs exhibited sustained EBPR activity and delayed decay under extended anaerobic condition, likely due to their versatile metabolic pathways depending on the availability and utilization of multiple intracellular polymers. This study provided new insights into the effects of implementing side-stream EBPR configuration on microbial populations, EBPR activity profiles and resulted system performance.

Being able to predict the soluble microbial product (SMP) concentration, an important foulant in membrane bioreactors (MBRs), with mathematical models provides the opportunity to use foulant production as an MBR design and optimization parameter. This study examined the ability of three mathematical model structures to describe two distinct mechanisms of SMP production. The production mechanisms evaluated are (1) the erosion or hydrolysis of floc-associated extracellular polymeric substance (EPS) and (2) decay of active cells. The models were compared based on their ability to predict SMP concentrations observed in an MBR system during a period of increased SMP and floc-associated EPS production due to increased predation. Predation was an important contributor to overall biomass decay. Short-term batch experiments were also preformed to examine model assumptions related to the (1) production of SMP due to decay of active cells, (2) production of SMP due to erosion of floc-associated EPS, (3) degradability of SMP present in the MBR mixed liquor during increased predation and (4) degradability of eroded floc-associated EPS. Both erosion of floc-associated EPS and decay of active cells were shown to be important independent mechanisms of SMP production. Therefore, a mathematical model used to predict SMP concentrations should provide the ability to capture both mechanisms independently. SMP produced during increased predation were slowly degradable while eroded floc-associated EPS was rapidly degradable. Model results demonstrate that the slowly biodegradable SMP fraction will dominate the bulk phase SMP concentration.

Shear, in the form of vigorous aeration, is used to control fouling in membrane bioreactor (MBR) systems. However, shear also influences the physicochemical and biological properties of MBR biomass. The current study examines the relationship between the aeration intensity and extracellular polymeric substance (EPS) production in MBRs. Two identical submerged MBRs were operated in parallel but the aeration rate was three times greater in one of the MBRs. The concentrations of floc-associated and soluble EPS were monitored for the duration of the experiment. Microscopic images and floc-size measurements were also collected regularly. The membrane fouling potential of the biomass was quantified using the flux-step method. Increased aeration did not have a direct effect on soluble or floc-associated EPS production in the microfiltration MBRs. However, aeration intensity had a significant effect on predatory organisms. Large aquatic earthworms, Aeolosoma hemprichi, proliferated under lower shear conditions but were never observed in the high shear reactor. Predation by A. hemprichi resulted in increased floc-associated and soluble EPS production. Thus, the mixing conditions in the low shear MBR indirectly resulted in increased soluble EPS concentrations and higher fouling potential. This research suggests that predation can have a significant impact on the production rates of floc-associated and soluble EPS – key parameters driving membrane fouling in MBRs.

Shear is used to control fouling in membrane bioreactor (MBR) systems. However, shear also influences the physicochemical and biological properties of MBR biomass. The current study examines the relationship between the level of shear and extracellular polymeric substance (EPS) production in MBRs. Two identical MBRs were operated in parallel where the biomass in one reactor was exposed to seven times greater shear forces. The concentrations of floc-associated and soluble EPS were monitored for the duration of the experiment. The stickiness of extracted floc-associated EPS from each reactor was also characterized using atomic force microscopy. A mathematical model of floc-associated and soluble EPS production was applied to quantitatively describe changes in EPS production with shear. Biomass grown in a high shear environment has lower floc-associated EPS production compared to biomass grown in a lower shear environment. This decrease in floc-associated EPS production also corresponds to a decrease in soluble EPS production, which can be explained by both the lower concentration of floc-associated EPS and the production of stickier floc-associated EPS that is more erosion resistant in the high shear reactor. This research suggests that mechanical stresses can have a significant impact on the production rates of floc-associated and soluble EPS-key parameters governing membrane fouling in MBRs.