Search

The transmission behavior of Lamb waves and the possible occurrence of resonance at an adhesive butt joint of plates are studied experimentally. To this purpose, two 2.5-mm thick aluminum alloy plates are bonded at their edges using cyanoacrylate-based adhesive. Bonded plate specimens with different joint conditions are prepared by changing the bonding procedure. The measurements are performed for the transmission characteristics of the lowest-order symmetric (S0) and antisymmetric (A0) Lamb modes for the frequency range of 0.4–0.6 MHz below the cut-off frequency of the higher-order modes. The experimental results show that the transmission coefficients of the S0 and A0 modes exhibit different frequency-dependent characteristics depending on the joint condition. Furthermore, for the incidence of the S0 mode at the center frequency of 1 MHz, the transmitted S0 mode in weakly bonded specimens shows a long oscillation tail due to the resonance effect. The experimental results are discussed in the light of the theoretical results based on the spring-type interface model. The interfacial stiffnesses identified from the transmission coefficients are shown to be correlated with the bonding condition of the joint and give reasonable estimates of the resonance frequencies of weakly bonded specimens. [ABSTRACT FROM AUTHOR]

Abstract: Numerical simulations were carried out to quantify the reflection and transmission characteristics of the fundamental Lamb modes propagating in aluminium sub-plates, which are formed due to a semi-infinite horizontal crack. It was observed that, a Lamb mode propagating in a sub-plate when incident at the edge of a crack, undergoes reflection and transmits through the main plate, as well as the other sub-plate. The mode transmitted through the sub-plate has been termed the ‘Turning Lamb Mode’ (TLM). Furthermore, a mode converted mode also propagates along with the TLM. This mode has been termed the ‘Mode Converted Turning Lamb Mode’ (MCTLM). Reflection and transmission characteristics of the fundamental Lamb modes in aluminium sub-plates were studied at frequencies 150kHz, 175kHz, and 200kHz. Experiments conducted to validate the observations made in numerical simulations, confirmed that the transmission and reflection characteristics depend on the thickness ratio. From this study it is surmised that when a Lamb mode propagates through a plate containing horizontal crack, the TLM and the MCTLM start propagating from one sub-plate to the other at the rear edge of the crack and amplitude of these modes depends on the location of the crack across the plate thickness. [Copyright &y& Elsevier]

Abstract: An analysis is given to the band structure of the two-dimensional phononic crystal plate constituted of a square array of elastic anisotropic, circular Pb cylinders embedded in elastic isotropic epoxy. The numerical results show that the band gap can be tuned by rotating the anisotropic material orientation. It is found that the influence of anisotropy on band gap of Lamb wave is clearly different from that on the band gap of bulk waves. The thickness of the system under study is a sensitive parameter to affect the influence of anisotropic materials on the normalized gap width. [Copyright &y& Elsevier]