Search

Abstract: This paper describes an investigation into ATC complexity as a contributory factor in changes of controllers’ workload. ATC complexity, together with equipment interface and procedural demands comprise the task demands on the controller; subsequent controller activities are mediated by performance shaping factors to create workload. In order to establish a link between ATC complexity and a controller’s subjective workload, complexity factors are identified and subsequently related to workload indicators. The studied data comes from a real-time simulation using Controller-Pilot Data-Link Communication (CPDLC) technology, recently completed at EUROCONTROL CRDS in Budapest. [ABSTRACT FROM AUTHOR]

Connected and automated vehicles (CAVs) promise to significantly improve road traffic. To a certain extent, this situation is similar to the expectations at the end of the last century about the positive effects that the introduction of Adaptive Cruise Control (ACC) systems would have had on motorway traffic. The parallelism is interesting because ACC equipped vehicles represent the first level of vehicle automation and are now widely available on the market. In this light, studying ACC impacts can help to anticipate potential problems related to its widespread application and to avoid that AVs and CAVs will lead to the same problems. Only a few test-campaigns had been carried out studying the ACC impacts under real-world driving conditions in quantitative terms. To bridge this gap, the Joint Research Centre of the European Commission has organized a number of experimental campaigns involving several ACC-equipped vehicles to study different implications of their widespread. In this context, the present paper summarizes the outcomes of a test campaign involving 10 commercially available ACC-equipped vehicles. The test campaign has been executed in two different test-tracks of the ZalaZONE proving ground, in Hungary. The tests have been carried out at low-speeds (30–60 km/h) and have involved platoons of vehicles of different brands and different powertrains, which were tested in a variety of vehicle orders and with different settings of their ACC systems. Test results have been used to derive information about the properties of the different ACC systems, to study their string stability, to study the effect of ACC systems on traffic flow, and to draw inference about the possible implications on energy consumption and traffic safety. Results confirm the previous findings in terms of string instability of the ACC and highlight that in the present form, ACC systems will possibly lead to higher energy consumption and introduce new safety risks when their penetration in the fleet increases. However, they also highlight that the materialization of the above findings for AVs depends on the operational logic that manufacturers will adopt during the implementation phase. Therefore, results suggest that functional requirements to guarantee string stability and in general to not disrupt the normal flow of traffic should be introduced both for ACC and for any automated system that will be placed on the market in the future. [ABSTRACT FROM AUTHOR]