Search

In this paper, we present the preliminary results concerning the deposition of highly transparent and conductive gallium-doped zinc oxide (GZO) deposited on transparent flexible substrate based on cellulose derivatives. Prior to the deposition of the GZO film, the surface of the polymer have been coated with a thin silicon dioxide (SiO2) layer deposited by thermal evaporation assisted by an electron gun. By doing this surface treatment, we succeeded in depositing highly conductive and transparent GZO with an electrical resistivity of 2.0×10−3 Ω cm and an average optical transmittance in the visible part of the spectrum (400–700 nm) of 70% by r.f. magnetron sputtering at room temperature. Besides the optoelectronic properties, the films are mechanically stable with a polycrystalline structure with a strong preferred (002) orientation, parallel to the substrate. [Copyright &y& Elsevier]

In this paper, we present results concerning the thickness dependence (from 70 to 890 nm) of electrical, structural, morphological and optical properties presented by gallium-doped zinc oxide (GZO) deposited on polyethylene naphthalate (PEN) substrates by r.f. magnetron sputtering at room temperature. For thicknesses higher than 300 nm an independent correlation between the electrical, morphological, structural and optical properties are observed. The lowest resistivity obtained was 5×10−4 Ω cm with a sheet resistance of 15 Ω/□ and an average optical transmittance in the visible part of the spectra of 80%. It is also shown that by passivating the surface of the polymer by depositing a thin silicon dioxide layer the electrical and structural properties of the films are improved nearly by a factor of two. [Copyright &y& Elsevier]

Abstract: Nitrogen (N)-doped ZnO thin films were RF sputtered with different N2 volume (ranging from 10% to 100%) on sapphire (001) substrates. The influence of N2 vol.% on the properties of ZnO films was analyzed by various characterization techniques. The X-ray diffraction studies showed that the films grow along the preferential (002) crystallographic plane and the crystallinity varied with varying N2 vol.%. The films sputtered with 25 vol.% N2 showed better crystallinity. The transmittance was decreased with increasing N2 volume until 25% and was almost constant above 25%. A maximum optical band gap (2.08 eV) obtained for 10 vol.% N2 decreased with increasing N2 volume to reach a minimum of 1.53 eV at 100%. The compositional analysis confirmed the incorporation of N into ZnO films, and its concentration increased with increasing N2 volume to reach a maximum of ∼3.7×1021 atom/cm3 at 75% but then decreased slightly to 3.42×1021 atoms/cm3. The sign of Hall coefficient confirmed that the films sputtered with ≤25 vol.% N2 possess p-type conductivity which changes to n-type for >25 vol.% N2. [Copyright &y& Elsevier]

In this paper, we investigate the optoelectronic properties and the photodegradation of amorphous silicon films produced by the hot wire plasma assisted technique (HWPA-CVD). We observed that hydrogen dilution in the gas phase plays an important role in the time dependence of the photoconductivity, which is correlated with an enhancement of defect density. We also compare the degradation of these films with those produced by plasma enhanced and by hot wire chemical vapour deposition techniques (PECVD and HW-CVD) and we found lower time dependence for the photodegradation of the films produced by HWPA-CVD technique [Copyright &y& Elsevier]