Search

The dual‐function retrofitting system that uses the carbon‐fabric reinforced cementitious matrix (C‐FRCM) as both the anode of impressed current cathodic protection (ICCP) system and the structural strengthening (SS) material, that is, an ICCP‐SS system, is investigated. The experimental program mainly focused on the shear behavior of C‐FRCM strengthened reinforced concrete (RC) continuous beam under the dual‐function retrofitting system. The influence of anode polarization on the shear strengthening of RC continuous beams is analyzed. Shear tests were conducted on a total of 14 corroded RC continuous beams to investigate the influence of key parameters, including anode polarization degree of prefabricated C‐FRCM plate, layer of carbon fiber mesh and side‐wrapping. The failure modes, shear capacities, and load‐deflection curves of the shear‐strengthened RC continuous beams are reported. Based on the test results, the applicability of relevant design codes was evaluated and found to provide rather conservative predictions for the shear capacity of the examined C‐FRCM strengthened RC continuous beams. [ABSTRACT FROM AUTHOR]

This paper presents an experimental investigation into the flexural and cracking behavior of corroded reinforced concrete continuous beams with 11‐month wet–dry cycles strengthened by anodic polarized carbon‐fabric‐reinforced cementitious matrix (C‐FRCM) plates. The failure modes and flexural bearing capacities were discussed. The influences of the layer of carbon fabric mesh and complete carbon fiber‐reinforced polymer (CFRP) wrapping as end anchorage on the strengthening effectiveness were explored. The complete crack development patterns were captured by a digital image correlation system, and the results showed that the C‐FRCM system can provide satisfactory crack width control, as proved by the reduced crack spacing and the maximum crack width. The flexural capacities of the strengthened beams were effectively enhanced and the debonding failure can be eliminated through complete CFRP wrappings. Moreover, the design recommendations were proposed based on the estimation of the crack development as per related design guidelines. [ABSTRACT FROM AUTHOR]