Search

This research provides a study for an experimental program using sand‐perlite‐lightweight reinforced concrete (RC) beams strengthened and anchored with carbon fiber reinforced polymer (CFRP) materials. The main objective of this work is to showcase the efficiency of using U‐wrap anchors to secure the externally applied CFRP sheets on lightweight RC beams. A series of six full‐scale T‐beams with an increasing number of CFRP U‐wraps per shear span was prepared and tested. The use of U‐wrap anchorage enhanced the flexural performance of the sand‐lightweight concrete beams by progressively delaying the premature debonding of CFRP sheets as a direct function of the number of U‐wraps used per shear span. The beam flexural capacity gradually improved from 116 kN without the use of U‐wrap anchors to 182 kN when using six U‐wraps per shear span, which reflects a significant enhancement. Similarly, the ultimate deflection gradually improved from 56 mm for the beam without U‐wrap anchors to 94 mm when applying six U‐wraps per shear span. A design model established earlier, for normal weight concrete, has been successfully qualified to yield accurate findings against the experimental results. Also, the outcome of this study interestingly showed that the ultimate strength results of the anchored beams were close to their counterparts of normal weight concrete conducted on identical beams. This finding shows that U‐wrap anchors performed efficiently despite the lack of coarse aggregate interlock in the concrete mix. [ABSTRACT FROM AUTHOR]

The dual‐function retrofitting system that uses the carbon‐fabric reinforced cementitious matrix (C‐FRCM) as both the anode of impressed current cathodic protection (ICCP) system and the structural strengthening (SS) material, that is, an ICCP‐SS system, is investigated. The experimental program mainly focused on the shear behavior of C‐FRCM strengthened reinforced concrete (RC) continuous beam under the dual‐function retrofitting system. The influence of anode polarization on the shear strengthening of RC continuous beams is analyzed. Shear tests were conducted on a total of 14 corroded RC continuous beams to investigate the influence of key parameters, including anode polarization degree of prefabricated C‐FRCM plate, layer of carbon fiber mesh and side‐wrapping. The failure modes, shear capacities, and load‐deflection curves of the shear‐strengthened RC continuous beams are reported. Based on the test results, the applicability of relevant design codes was evaluated and found to provide rather conservative predictions for the shear capacity of the examined C‐FRCM strengthened RC continuous beams. [ABSTRACT FROM AUTHOR]