Search

Abstract: The paper describes the experimental design and results of tests used to investigate the use of compressible EPS (geofoam) seismic buffers to attenuate dynamic loads against rigid retaining wall structures. The tests were carried out using 1-m-high models mounted on a large shaking table. Three different geofoam buffer materials retaining a sand soil were tested under idealized dynamic loading conditions. The results of these tests are compared to a nominal identical structure without a seismic buffer. The test results demonstrate that the reduction in dynamic load increased with decreasing seismic buffer density. For the best case reported here, the maximum dynamic force reduction was 31% at a peak base acceleration of 0.7g. [Copyright &y& Elsevier]

Abstract: A simple displacement-type block model is proposed to compute the compression–load–time response of an idealized seismic buffer placed against a rigid wall and used to attenuate earthquake-induced dynamic loads. The seismic buffer is modelled as a linear elastic material and the soil wedge shear surface by a stress-dependent linear spring. The model is shown to capture the trends observed in four physical reduced-scale model shaking table tests carried out with similar boundary conditions up to a base excitation level of about 0.7g. In most cases, quantitative predictions are in reasonable agreement with physical test results. The model is simple and provides a possible framework for the development of advanced models that can accommodate more complex constitutive laws for the component materials and a wider range of problem geometry. [Copyright &y& Elsevier]