Search

In this study we measure the in situ response of a fiber Bragg grating (FBG) sensor embedded in the adhesive layer of a single composite lap joint, subjected to harmonic excitation after fatigue loading. After a fully reversed cyclic fatigue loading is applied to the composite lap joint, the full-spectral response of the sensor is interrogated at 100 kHz during two loading conditions: with and without an added harmonic excitation. The full-spectral information avoided dynamic measurement errors often experienced using conventional peak wavelength and edge filtering techniques. The short-time Fourier transform (STFT) is computed for the extracted peak wavelength information to reveal time-dependent frequencies and amplitudes of the dynamic FBG sensor response. The dynamic response of the FBG sensor indicated a transition to strong nonlinear dynamic behavior as fatigue-induced damage progressed. The ability to measure the dynamic response of the lap joint through sensors embedded in the adhesive layer can provide in situ monitoring of the lap joint condition.

In this paper, we embed fiber Bragg grating (FBG) sensors in graphite fiber–epoxy woven composite laminates to detect evolving damage modes. The peak wavelengths of the FBG sensors are interrogated at 625 and 295 kHz, while the laminates are subjected to 11.0 J low-velocity impact events. It is demonstrated that 295 kHz interrogation is sufficient for accurately collecting the dynamic response of the sensors. The FBG sensors embedded at the laminate midplanes successfully reconstructed the global laminate response to impact. The maximum and full width at half-maximum (FWHM) for the relative strain histories demonstrated the same trends as the maximum and FWHM of the contact force histories measured from the impactor. More noise was present in the strain histories obtained from the FBG sensors than the contact force histories, as the embedded FBGs were sensitive to local perturbations in the stress state. The FBG sensors embedded below the midplane of the laminate were closer to the damage regions and measured complex strain histories. In one case, this strain history revealed the presence of delamination.

This paper presents a new means for collecting fiber Bragg grating (FBG) data during drop-tower measurements used to assess damage to composite structures. The high repetition-rate collection process reveals transient features that cannot be resolved in quasi-static measurements. The experiments made at a repetition rate of about 500 Hz show that the detected FBG spectrum broadens for a short period of time and relaxes quickly to a narrower static state. Furthermore, this relaxation time increases dramatically as the strike count increases. The information gained by such measurements will enhance the ability to characterize and distinguish failure modes and predict the remaining lifetime in composite laminate structures.