Search

This article presents a method for detecting rotational speed by LC (inductor-capacitor) wireless sensors. The sensing system consists of two identical LC resonant tanks. One is mounted on the rotating part and the other, as a readout circuit, is placed right above the rotating part. When the inductor on the rotating part is coaxially aligned with the readout inductor during rotation, the mutual coupling between them reaches the maximum, resulting in a peak amplitude induced at the readout LC tank. The period of the readout signal corresponds to the rotation speed. ADS (Advanced Design System) software was used to simulate and optimize the sensing system. A synchronous detection circuit was designed. The rotational speed of an electric was measured to validate this method experimentally, and the results indicated that the maximum error of the rotation speed from 16 rps to 41 rps was 0.279 rps. [ABSTRACT FROM AUTHOR]

In order to obtain desirable crop yields, grain seeds need to be sown at the optimal seed amount per hectare with uniform distribution in the field. In previous grain sowing processes, the seeding rates are controlled by the rotational speed of the flute roller which significantly effects the uniform distribution of the seeds due to disturbances, such as the reduction of the seeds' mass in the hopper and the change of working length of the flute roller. In order to overcome the above problem, we developed an adaptive roller speed control system based on the seed flow rate sensor. The developed system can monitor and feedback actual seeding rates. In addition, based on the monitoring value of the real-time seeding rates, an adaptive roller speed control method (ARSCM), which contains an algorithm for calculating the seeding rate with a compensation, was proposed. Besides, the seeding performance of the ARSCM and that of the conventional roller speed control method (CRSCM) were compared. The results of constant-velocity experiments demonstrated that the accuracy (SA) and the coefficient of variation (SCV) of the seeding rates controlled by the ARSCM were 94.12% and 6.77%, respectively. As for the CRSCM, the SA and SCV were 89.00% and 8.95%, respectively. Under variable-velocity conditions, the SA and SCV of the proposed system were 91.58% and 11.08%, respectively, while those of the CRSCM were 88.48% and 13.08%, respectively. Based on the above results, this study concluded that the ARSCM is able to replace the CRSCM in practical sowing processes for the optimal and uniform seed distribution in the field. [ABSTRACT FROM AUTHOR]

In industrial production processes, rotational speed is a key parameter for equipment condition monitoring and fault diagnosis. To achieve rotational speed measurement of rotational equipment under a condition of high temperature and heavy dust, this article proposes a digital approach using an electrostatic sensor. The proposed method utilizes a strip of a predetermined material stuck on the rotational shaft which will accumulate a charge because of the relative motion with the air. Then an electrostatic sensor mounted near the strip is employed to obtain the fluctuating signal related to the rotation of the charged strip. Via a signal conversion circuit, a square wave, the frequency of which equals that of the rotation shaft can be obtained. Having the square wave, the M/T method and T method are adopted to work out the rotational speed. Experiments were conducted on a laboratory-scale test rig to compare the proposed method with the auto-correlation method. The largest relative errors of the auto-correlation method with the sampling rate of 2 ksps, 5 ksps are 3.2% and 1.3%, respectively. The relative errors using digital approaches are both within ±4‰. The linearity of the digital approach combined with the M/T method or T method is also superior to that of the auto-correlation method. The performance of the standard deviations and response speed was also compared and analyzed to show the priority of the digital approach. [ABSTRACT FROM AUTHOR]