Search

Extended Range Wide Area Network (LoRaWAN) has recently gained a lot of attention from the industrial and research community for dynamic Internet of Things (IoT) applications. IoT devices broadcast messages for neighbor gateways that deliver the message to the application server through an IP network. Hence, it is required to deploy LoRaWAN gateways, i.e., network planning, and optimization, in an environment while considering Operational Expenditure (OPEX) and Capital Expenditure (CAPEX) along with Quality of Service (QoS) requirements. In this article, we introduced a LoRaWAN gateway placement model for dynamic IoT applications called DPLACE. It divides the IoT devices into groups with some degree of similarity between them to allow for the placement of LoRaWAN gateways that can serve these devices in the best possible way. Specifically, DPLACE computes the number of LoRaWAN gateways based on the Gap statistics method. Afterward, DPLACE uses K-Means and Fuzzy C-means algorithms to calculate the LoRaWAN gateway placement. The simulations&rsquo, results proved the benefits of DPLACE compared to state-of-the-art LoRaWAN gateway placement models in terms of OPEX, CAPEX, and QoS.

In this work, resistive moisture sensors were obtained by dip coating sulfonated polycarbonate (SPC) onto silver interdigitated electrodes. Commercial polycarbonate was sulfonated with acetyl sulphate at two different sulfonation degrees corresponding to 9.0 and 18.0 mole %. Impedance spectroscopy was used to investigate the humidity sensing properties at controlled relative humidity (RH%) environments generated from standard saline solutions in the range of 11–90 RH%. For the highest sulfonated sample, in the RH% range investigated (11 to 90%), the sensor impedance changed from 4.7 MΩ to 18 kΩ. Humidity sensors made from sulfonated polycarbonate showed exponential decay behavior of the impedance at constant frequency with the environmental relative humidity. Sample 9SPC presented dielectric relaxation response for environmental humidity between 58 and 90 RH% while sample 18SPC presented dielectric relaxation response for the entire measured range between 11 and 90 RH%. Sulfonated polycarbonate could be a promising material for the fabrication of simple and cheap humidity-sensing sensors for the assessment of relative humidity of the surrounding environment, as suggested by experimental results.