Search

Vibration energy harvesters in industrial applications usually take the form of cantilever oscillators covered by a layer of piezoelectric material and exploit the resonance phenomenon to improve the generated power. In many aeronautical applications, the installation of cantilever harvesters is not possible owing to the lack of room and/or safety and durability requirements. In these cases, strain piezoelectric harvesters can be adopted, which directly exploit the strain of a vibrating aeronautic component. In this research, a mathematical model of a vibrating slat is developed with the modal superposition approach and is coupled with the model of a piezo-electric patch directly bonded to the slat. The coupled model makes it possible to calculate the power generated by the strain harvester in the presence of the broad-band excitation typical of the aeronautic environment. The optimal position of the piezoelectric patch along the slat length is discussed in relation with the modes of vibration of the slat. Finally, the performance of the strain piezoelectric harvester is compared with the one of a cantilever harvester tuned to the frequency of the most excited slat mode.

The impact of raindrops on a dry surface leads to a splashing phenomenon that dissipates a lot of energy. To improve energy collection, a novel piezoelectric raindrop energy harvester equipped with a spoonful of water was developed. The advantages and the drawbacks of this solution were analyzed with the aid of numerical simulations. A series of experimental tests were carried out in a laboratory with simulated raindrops. Experimental results showed that the negative effect of the added water mass was exceeded by the positive effects related to the impact of the raindrop on a liquid surface. Tests carried out connecting the harvester to a resistive load showed that the prototype was able to collect more energy than a simple cantilever harvester.

The design and fitting of prosthetic sockets can significantly affect the acceptance of an artificial limb by persons with lower limb amputations. Clinical fitting is typically an iterative process, which requires patients’ feedback and professional assessment. When feedback is unreliable due to the patient’s physical or psychological conditions, quantitative measures can support decision-making. Specifically, monitoring the skin temperature of the residual limb can provide valuable information regarding unwanted mechanical stresses and reduced vascularization, which can lead to inflammation, skin sores and ulcerations. Multiple 2D images to examine a real-life 3D limb can be cumbersome and might only offer a partial assessment of critical areas. To overcome these issues, we developed a workflow for integrating thermographic information on the 3D scan of a residual limb, with intrinsic reconstruction quality measures. Specifically, workflow allows us to calculate a 3D thermal map of the skin of the stump at rest and after walking, and summarize this information with a single 3D differential map. The workflow was tested on a person with transtibial amputation, with a reconstruction accuracy lower than 3 mm, which is adequate for socket adaptation. We expect the workflow to improve socket acceptance and patients’ quality of life.