Search

Abstract The deformation behavior of metallic glasses has been shown in prior studies to be often dependent on its structural state, namely higher energy “rejuvenated” state versus lower energy “relaxed” state. Here, the deformation behavior of thermally rejuvenated Zr-Cu-Al-(Ti) bulk metallic glasses (BMGs) was evaluated. Rejuvenation was achieved by cryogenic thermal cycling with increase of free volume measured in terms of enthalpy of relaxation. Hardness, stiffness, and yield strength of the BMGs were all found to decrease while plasticity increased after rejuvenation. More free volume in the rejuvenated BMG resulted in homogeneous plastic deformation as was evident from the high strain rate sensitivity and more pronounced shear band multiplication during uniaxial compression. Shear transformation zone (STZ) volume was calculated by cooperative shear model and correlated well with the change in structural state after rejuvenation. The enhanced plasticity with the addition of 1 at. % Ti as well as after cryogenic thermal cycling was explained by lower activation energy for shear flow initiation due to increased heterogeneity induced in the system. Molecular dynamics simulation demonstrated that the variation in plastic deformation behavior is correlated with local atomic structure changes.

Abstract The compositional dependence and influence of relaxation state on the deformation behavior of a Pt–Pd-based bulk metallic glasses model system was investigated, where platinum is systematically replaced by topologically equivalent palladium atoms. The hardness and modulus increased with rising Pd content as well as by annealing below the glass transition temperature. Decreasing strain-rate sensitivity and increasing serration length are observed in nano indentation with increase in Pd content as well as thermal relaxation. Micro-pillar compression for alloys with different Pt/Pd ratios validated the greater tendency for shear localization and brittle behavior of the Pd-rich alloys. Based on total scattering experiments with synchrotron X-ray radiation, a correlation between the increase in stiffer 3-atom cluster connections and reduction in strain-rate sensitivity, as a measure of ductility, with Pd content and thermal history is suggested.