Search

Abstract We report on experimental and numerical investigation of burst-mode supercontinuum generation in sapphire crystal. The experiments were performed using bursts consisting of two 190 fs, 1030 nm pulses with intra-burst repetition rates of 62.5 MHz and 2.5 GHz from an amplified 1 MHz Yb:KGW laser and revealed higher filamentation and supercontinuum generation threshold for the second pulse in the burst, which increases with the increase of intra-burst repetition rate. The experimental results were quantitatively reproduced numerically, using a developed model, which accounted for altered material response due to residual excitations remaining after propagation of the first pulse. The simulation results unveiled that residual free electron plasma and self-trapped excitons contribute to elevated densities of free electron plasma generated by the second pulse in the burst and so stronger plasma defocusing, significantly affecting its nonlinear propagation dynamics. The presented results identify the fundamental and practical issues for supercontinuum generation in solid-state materials using femtosecond pulse bursts with very high intra-burst repetition rates, which may also apply to the case of single pulses at very high repetition rate, where residual material excitations become relevant and should be accounted for.

Abstract The formation and evolution of laser-induced periodic surface structures in fused silica under irradiation of widely tunable (in the 1–3 $$\upmu$$ μ m range) linearly polarized femtosecond (200 fs) pulses was studied experimentally. The structures were inscribed in high fluence regime (exceeding the surface ablation threshold for a single pulse) and characterized by using scanning electron microscopy and two dimensional Fourier transform. The results revealed rapid (after irradiation with a few successive pulses) formation of periodic laser-induced periodic surface structures aligned parallel to laser polarization, whose period increases with increasing the inscription wavelength, obeying the $$\lambda /n$$ λ / n law. With further increase of number of pulses, the generated structures gradually reorganize into laser polarization-independent low spatial frequency annular structures associated with formation of the damage crater, which fully established after irradiation with a few tens of successive laser pulses. This particular evolution scenario was observed over the entire wavelength tuning range of incident pulses.

Abstract We compare supercontinuum generation in $$\hbox {CaF}_2$$ CaF 2 crystal under tight and loose focusing of 150 fs, 515 nm second harmonic pulses from an amplified Yb:KGW laser at a repetition rate of 10 kHz. It is demonstrated that supercontinuum generation geometry applying loose focusing ( $$\hbox {NA}=0.004$$ NA = 0.004 ) of the pump beam into a long (25 mm) $$\hbox {CaF}_2$$ CaF 2 sample is advantageous in terms of supercontinuum spectral extent and durability of damage-free operation of the nonlinear material as compared to a commonly used supercontinuum generation setup which employs tight focusing ( $$\hbox {NA}=0.012$$ NA = 0.012 ) into a short (5 mm) sample and to setup which uses tight focusing into a long (25 mm) sample. More specifically, loose focusing into a long sample showed remarkably longer (20 min) damage-free operation of the nonlinear material, which was not translated with respect of the pump beam, while in tight focusing condition the sample is damaged just within 2 min of operation, leading to a complete extinction of the supercontinuum spectrum. The evolution of optical degradation of the nonlinear material in time and its impact to supercontinuum spectrum is studied in terms of filament-induced luminescence due to self-trapped exciton emission and light scattering at the pump wavelength indicating the onset of optical damage. Our findings are supported by the numerical simulations which compare relevant parameters related to filament propagation in tight and loose focusing conditions.