Search

Additively printed circuits provide advantages in reduced waste, rapid prototyping, and versatile flexible substrate choices relative to conventional circuit printing. Copper (Cu) based inks along with intense pulsed light (IPL) sintering can be used in additive circuit printing. However, IPL sintered Cu typically suffer from poor solderability due to high roughness and porosity. To address this, hybrid Cu ink which consists of Cu precursor/nanoparticle was formulated to seed Cu species and fill voids in the sintered structure. Nickel (Ni) electroplating was utilized to further improve surface solderability. Simulations were performed at various electroplating conditions and Cu cathode surface roughness using the multi-physics finite element method. By utilizing a mask during IPL sintering, conductivity was induced in exposed regions; this was utilized to achieve selective Ni-electroplating. Surface morphology and cross section analysis of the electrodes were observed through scanning electron microscopy and a 3D optical profilometer. Energy dispersive X-ray spectroscopy analysis was conducted to investigate changes in surface compositions. ASTM D3359 adhesion testing was performed to examine the adhesion between the electrode and substrate. Solder-electrode shear tests were investigated with a tensile tester to observe the shear strength between solder and electrodes. By utilizing Cu precursors and novel multifaceted approach of IPL sintering, a robust and solderable Ni electroplated conductive Cu printed electrode was achieved. [ABSTRACT FROM AUTHOR]

In this study, an intense pulsed light (IPL) annealing process for a printed multi-layered indium–gallium–zinc–oxide (IGZO) and silver (Ag) electrode structure was developed for a high performance all-printed inorganic thin film transistor (TFT). Through a solution process using IGZO precursor and Ag ink, the bottom gate structure TFT was fabricated. The spin coating method was used to form the IGZO semiconductor layer on a heavily-doped silicon wafer covered with thermally grown silicon dioxide. The annealing process of the IGZO layer utilized an optimized IPL irradiation process. The Ag inks were printed on the IGZO layer by screen printing to form the source and drain (S/D) pattern. This S/D pattern was dried by near infrared radiation (NIR) and the dried S/D pattern was sintered with intense pulsed light by varying the irradiation energy. The performances of the all-printed TFT such as the field effect mobility and on–off ratio electrical transfer properties were measured by a parameter analyzer. The interfacial analysis including the contact resistance and cross-sectional microstructure analysis is essential because diffusion phenomenon can occur during the annealing and sintering process. Consequently, this TFT device showed noteworthy performance (field effect mobility: 7.96 cm2/V s, on/off ratio: 107). This is similar performance compared to a conventional TFT, which is expected to open a new path in the printed metal oxide-based TFT field. [ABSTRACT FROM AUTHOR]

Toe joint is known as one of the critical factors in designing a prosthetic foot due to its nonlinear stiffness characteristic. This stiffness characteristic provides a general feeling of springiness in the toe-off and it also affects the ankle kinetics. In this study, the toe part of the prosthetic foot was designed to improve walking performance. The toe joint was implemented as a single part suitable for 3D printing. The various shape factors such as curved shape, bending space, auxetic structure, and bending zone were applied to mimic human foot characteristics. The finite element analysis (FEA) was conducted to simulate terminal stance (from heel-off to toe-off) using the designed prosthetic foot. To find the structure with characteristics similar to the human foot, the optimization was performed based on the toe joint geometries. As a result, the optimized foot showed good agreement with human foot behavior in the toe torque-angle curve. Finally, the simulation conditions were validated by comparing with human walking data and it was confirmed that the designed prosthetic foot structure can implement the human foot function. [ABSTRACT FROM AUTHOR]