Search

A rotating filtration device (RFD) that is filled with porous media is developed for sampling particulate matter with a diameter of 1 μm or less (PM1). An experiment is conducted on a test system using corn oil as a test aerosol. The RFD was evaluated using an aerodynamic particle sizer. The results yielded cutoff sizes of 1.68 μm and 1.04 μm at rotational speeds of 0 rpm and 9000 rpm, respectively, with foam with 80 pores per inch (ppi), a thickness of 80 mm, and a face velocity of 13.5 cm/s. When the foam was replaced with 94 ppi nickel mesh, the cutoff size decreased from 1.45 μm to 0.98 μm as the thickness increased from 17 to 68 mm. As the face velocity of the RFD increased from 13.5 to 108.3 cm/s, the cutoff size declined from 1.04 μm to 0.77 μm. Most of the changes in the cutoff sizes of the RFD were statistically significant (p

Despite the extensive use of the Internet, printed newspapers remain a primary information source. In this study, reading a newspaper in a relatively confined or poorly ventilated indoor space was simulated to determine the profile of particles released from the newspaper into the air. The consecutive simulated conditions were reading without agitation of the newspaper (NoAg), followed by reading with agitation of the newspaper (Ag) and post-reading absent the newspaper (PostR), repeated with four newspapers. We found that particle number concentration (ΣN) fell during Ag owing to electroadhesion of ultrafine particles (200 nm) caused by static charges created by friction between the paper surface and the air as a result of newspaper agitation. Conversely, particle surface area concentrations (ΣA) and particle volume concentrations (ΣV) increased significantly during Ag. This was because the larger, fine (1-2.5 μm) and coarse mode (2.5-10 μm), particles were detached from the newspaper during agitation due to inertial detachment - the release of even a small number of these particles contributing greatly to ΣA and ΣV. The critical particle number diameter (CPND) occurred at 207-310 nm. Particles smaller than this were subject to electroadhesion during Ag. The critical particle volume diameter (CPVD) occurred at 130-497 nm. Particles larger than this were subject to inertial detachment during Ag. These observations indicate that the electroadhesion of smaller particles and the inertial detachment of larger particles occur simultaneously. Particle mass concentrations were found to be as high as 168.7-534.3 μg m

This study systemically investigated the ambient PM2.5 (n=108) with comprehensive analyses of the chemical composition, identification of the potential contributors, and estimation of the resultant respiratory physician visits in the residential regions near energy-consuming and high-polluting industries in central Taiwan. The positive matrix fraction (PMF) model with chemical profiles of trace metals, water-soluble ions, and organic/elemental carbons (OC/EC) was applied to quantify the potential sources of PM2.5. The influences of local sources were also explored using the conditional probability function (CPF). Associations between the daily PM2.5 concentration and the risk of respiratory physician visits for the elderly (≥65years of age) were estimated using time-series analysis. A seasonal variation, with higher concentrations of PM2.5, metals (As, Cd, Sb, and Pb), OC/EC and ions (i.e., NO3-, SO42- and NH4+) in the winter than in the spring and summer, was observed. Overall, an increase of 10μgm-3 in the same-day PM2.5 was associated with an ~2% (95% CI: 1.5%-2.5%) increase in respiratory physician visits. Considering the health benefits of an effective reduction, we suggest that the emission from coal combustion (23.5%), iron ore and steel industry (17.1%), and non-ferrous metallurgy (14.4%), accounting for ~70% of the primary PM2.5 in the winter are prioritized to control.

This study investigated allergenic terpenol compounds in incense powder and smoke. The powder of two Thai brands contained higher concentrations of terpenols up to 6.15 times higher than those of two Taiwanese brands. Consequently, Thai incense makers face a higher potential risk of contact dermatitis than Taiwanese incense makers do. d -Limonene was the primary terpenol compound in the powder of Thai B (64.0%) and Thai Y (31.5%), sold in Thailand. By contrast, anisyl alcohol was the primary terpenol compound in the powder of LST (40.3%) and SC (37.7%), sold in Taiwan. After the four brands of incense were ignited, their mean PM 2.5 emission factor was 18.02 ± 6.20 mg g − 1 incense. The PM 2.5 mass emission factors of the Taiwanese brands were far higher than those of the Thai brands, and so were the PM 2.5 terpenol emission factors, showing that the smokes of the Taiwanese incense were potentially more allergenic than those of the Thai incense. Geraniol, the most allergenic terpenol compound, was 2.8%–10.7% of total terpenol compounds in the powder of the four brands, yet was the main contributor to PM 2.5 , constituting 66.3%–83.5% of terpenol compounds in the smokes of the four brands. Furthermore, geraniol exhibited an IP ratio, defined as the incense/powder (IP) ratio of terpenol-related species, > 1 in all four brands, and > 5 in the Taiwanese brands, suggesting a greater health risk with the smoke from the Taiwanese incense. The IP ratios of other terpenol species were all 1, meaning that the generation of PM 2.5 terpenol compounds was potentially enhanced by indoor lighting.

The Mid-Autumn Festival (MAF), or Moon Festival, is a harvest festival in Taiwan, celebrated by families across the island with evening barbecues outside. This study investigated the potential impact of these activities on the air quality in Tainan, a city in southern Taiwan. Fine particulate matter (PM2.5) was examined in the period leading up to the MAF (pre-MAF), during the Festival (MAF), after the Festival (post-MAF), and in the period after this (a period of moderate air quality: MAQ). Gaseous pollutants in PM2.5 were, from highest to lowest mean concentration, NH3, SO2, HCl, HNO3, HNO2, and oxalic acid, while inorganic salts were mainly in the form of the photochemical products SO4(2-), NH4(+), and NO3(-). These inorganic salts accounted for 37.6%-44.5% of the PM2.5 mass concentration, while a further 26.3%-42.8% of the PM2.5 mass was total carbon (TC). TC was mostly composed of organic carbon (OC) produced by photochemical reactions. Of this, 9.8%-14.9% was carboxylates, of which oxalate was the most abundant compound, accounting for 22.8%-31.9% of carboxylates. The presence of phthalates in the PM2.5 indicated emissions from the plastics industry. Although a noticeable amount of aerosol was produced by festival activities and burning of softwood and hardwood, onshore air currents during the festival prevented potential high aerosol loading. During the moderate air quality period following post-MAF, the concentration of total carbohydrates was 1.44-2.64 times the amount during the festival. Levoglucosan and myo-inositol accounted for 81.7%-89.6% of the total carbohydrate concentration. The average Levo/Manno ratio was 18.64 ± 5.24. The concentration of levoglucosan was closely related to that of PO4(3-), erythritol, and galactose. Backward trajectories indicated that biomass burning in China affected the air quality of Tainan City.

Visibility data from over the past four decades accumulated from urban areas of central Taiwan indicated that air pollutants have significantly degraded visibility in recent years. Currently, the annual average visibility in urban areas of the same region is approximately 8–10 km, while the visibility in remote areas is approximately 25–30 km. To understand how aerosols affect the visibility in this region, here we selected three sites in central Taiwan to measure the soluble ionic and carbonaceous species of PM 2.5 and PM 2.5–10 during 1997–1998. A MOUDI cascade impactor was used to measure the size distributions of atmospheric sulfate, nitrate, and carbonaceous particles. The aerosol data were then analyzed together with meteorological and air quality data. Comparing the results obtained from urban, coastal suburban and remote sites revealed that sulfate, carbonaceous species and local wind speed significantly affected the visibility in the urban area. However, sulfate concentration and humidity influenced visibility in the coastal area of central Taiwan. The particulate concentration at the remote station was roughly one-fifth of that in the city. Regression analysis results indicated that humidity is a dominant factor affecting remote visibility.

This investigation conducted seven intensive field measurements of PM 2.5 and PM 2.5–10 at three sites within the Taichung coastal area in Taiwan, between December 1996 and November 1997. Samples were collected for chemical analysis of soluble ionic species, elemental and organic carbon. Comparing these aerosol data with air quality and meteorological data reveals that the fractions of sulfate, nitrate, and ammonia of PM 10 on hazy days, are significantly higher than on clear days. Visibility shows a strong negative correlation with sulfate, ammonia, and nitrate and a moderately negative correlation with humidity. The average sulfur oxidation ratio and nitrogen oxidation ratio of PM 10 increases from 0.18 and 0.06, respectively, on clear days, to 0.46 and 0.12, respectively, on hazy days. These ratios indicate an enhanced formation of acidic particulates on hazy days. A regression model based on sulfate and humidity has been developed, and the comparison indicates that visibility in the coastal area can be properly simulated by the equation derived herein.