Search

Summary The advent of new imaging technologies in Scanning Electron Microscopy (SEM) using low energy (0–2 keV) electrons has brought about new ways to study materials at the nanoscale. It also brings new challenges in terms of understanding electron transport at these energies. In addition, reduction in energy has brought new contrast mechanisms producing images that are sometimes difficult to interpret. This is increasing the push for simulation tools, in particular for low impact energies of electrons. The use of Monte Carlo calculations to simulate the transport of electrons in materials has been undertaken by many authors for several decades. However, inaccuracies associated with the Monte Carlo technique start to grow as the energy is reduced. This is not simply associated with inaccuracies in the knowledge of the scattering cross-sections, but is fundamental to the Monte Carlo technique itself. This is because effects due to the wave nature of the electron and the energy band structure of the target above the vacuum energy level become important and these are properties which are difficult to handle using the Monte Carlo method. In this review we briefly describe the new techniques of scanning low energy electron microscopy and then outline the problems and challenges of trying to understand and quantify the signals that are obtained. The effects of charging and spin polarised measurement are also briefly explored. SCANNING 9999:1–17, 2016. © 2016 Wiley Periodicals, Inc.

A method for scanning electron microscopy imaging of nonconductive specimens, based on measurement and utilisation of a critical energy, is described in detail together with examples of its application. The critical energy, at which the total electron yield curve crosses the unit level, is estimated on the basis of measurement of the image signal development from the beginning of irradiation. This approach, concentrated onto the detected signal as the only quantity crucial for the given purpose of acquiring a noncharged micrograph, evades consequences of any changes in an irradiated specimen that influence the total electron yield curve and possibly also the critical energy value. Implementation of the automated method, realised using a cathode lens-equipped scanning electron microsope (SEM), enables one to establish a mean rate of charging over the field of view and its dependence on the electron landing energy. This dependence enables one to determine the energy of a minimum damage of the image of the given field of view. Factors influencing reliability and applicability of the method are discussed and examples of noncharged micrographs of specimens from both life and material science fields are presented.

Minimum necessary adaptations are described that are sufficient for obtaining very low energy electron micrographs (VLEEMs) from commercially available routine scanning electron micrographs (SEMs) with the electrons accelerated to an energy of the order of tens of keV. A cathode lens inserted into the specimen chamber enables one to decelerate electrons in front of the specimen surface to a desired low landing energy, which can be freely varied even down to zero. When a potential slightly more negative than the accelerating voltage is applied, a scanning mirror electron microscopy mode can be effected. The achievable point resolution at very low energies proves to be not too dependent on the objective lens parameters, so that the physical limit of aberrations of the homogeneous field of the cathode lens is nearly attainable. The detection efficiency for the standard Everhart-Thornley secondary electron detector is discussed, and results for the routine Tesla BS 340 SEM are presented.

One of the well-proven and efficient methods of obtaining a very low-energy impact of primary electrons in the scanning electron microscope is to introduce a retarding field element below the pole piece of the objective lens (OL). It is advantageous to use the specimen alone as the negatively biased electrode (i.e., cathode of the cathode lens). The optical power of the cathode lens modifies some of the standard parameters of the image formation such as relation of working distance to OL excitation or magnification to the scanning coils current, the impact angle of primary electrons, and so forth. In computer-controlled electron microscopes these parameters, particularly with regard to focusing and magnification, can be corrected automatically. Derivation of algorithms for such corrections and their experimental verifications are presented in this paper. Furthermore, a more accurate analytical expression for the focal length of an aperture lens is derived.