Search

To investigate the role of fissure angle and heat treatment temperature on the mechanical properties and deformation failure behavior, uniaxial compression tests were carried out on granite specimens containing a single fissure. Using stress–strain curves, the peak strength, peak strain, and elastic modulus of the one-fissured granite specimens were analyzed in detail. The mechanical parameters are closely related to the fissure angle and the high temperature. As the fissure angle increases from 0° to 90°, the peak strength and elastic modulus first decrease and then increase, while the peak strain increases slowly. However, the peak strength and elastic modulus first increase and then decrease, while the peak strain first decreases and then increases with increasing treatment temperature. During the experiments, the crack evolution process and acoustic emission (AE) counts were obtained using real-time photography and the AE monitoring technique. In the granite specimens containing a pre-existing fissure, large AE counts are clearly observed before the peak strength, which indicates crack initiation and propagation. The accumulated AE count first increases slowly, but is followed by a sharp increase, with increasing deformation. The AE events in the one-fissured specimen also depend on the heat treatment temperature. As the temperature increases, the rate of increase of the accumulated AE count curve is reduced. Finally, using a digital image correlation method, the full fields of surface deformation were obtained for the entire testing process. In addition, the local strain around the pre-existing fissure was measured using strain gauges. The full strain field and local strain concentration are discussed to describe the fracture mechanism of brittle granite. [ABSTRACT FROM AUTHOR]

The deformation failure characteristics of marble subjected to triaxial cyclic loading are significant when evaluating the stability and safety of deep excavation damage zones. To date, however, there have been notably few triaxial experimental studies on marble under triaxial cyclic loading. Therefore, in this research, a series of triaxial cyclic tests was conducted to analyze the mechanical damage characteristics of a marble. The post-peak deformation of the marble changed gradually from strain softening to strain hardening as the confining pressure increased from 0 to 10 MPa. Under uniaxial compression, marble specimens showed brittle failure characteristics with a number axial splitting tensile cracks; in the range of σ = 2.5-7.5 MPa, the marble specimens assumed single shear fracture characteristics with larger fracture angles of about 65°. However, at σ = 10 MPa, the marble specimens showed no obvious shear fracture surfaces. The triaxial cyclic experimental results indicate that in the range of the tested confining pressures, the triaxial strengths of the marble specimens under cyclic loading were approximately equal to those under monotonic loading. With the increase in cycle number, the elastic strains of the marble specimens all increased at first and later decreased, achieving maximum values, but the plastic strains of the marble specimens increased nonlinearly. To evaluate quantitatively the damage extent of the marble under triaxial cyclic loading, a damage variable is defined according to the irreversible deformation for each cycle. The evolutions of the elastic modulus for the marble were characterized by four stages: material strengthening, material degradation, material failure and structure slippage. Based on the experimental results of the marble specimens under complex cyclic loading, the cohesion of the marble decreased linearly, but the internal friction angles did not depend on the damage extent. To describe the peak strength characteristics of the marble specimens under complex cyclic loadings with various deformation positions, a revised strength criterion for damaged rocks is offered. [ABSTRACT FROM AUTHOR]