Search

We report tests of an alternate technique for constraining MHD equilibrium analysis in tokamak plasmas using internal magnetic field measurements based on |B| measurements from the motional Stark splitting of Dα spectral lines emitted by a neutral heating beam (MSE-LS). We compare results using MSE-LS with those of the standard equilibrium analysis technique based on line polarization of the Dα emission (MSE-LP). An alternative to MSE-LP is needed in future devices such as ITER where MSE-LP will be difficult due to a plasma-induced coating of the first optical element. The tests utilized data from 10 DIII-D shots with 7 MSE-LS and 14 MSE-LP views covering a range of radii along the outer midplane of the plasma. Seven MSE-LS measurements can contribute significantly to the equilibrium reconstruction of pressure and q profiles using both synthetic and experimental DIII-D MSE-LS data. For example, 7 MSE-LS plus seven MSE-LP measurements give a fit quality that is as good as the same cases with 14 MSE-LP measurements. Analyzing synthetic data for 14 MSE-LS measurements shows significant improvement in fitting quality over the case with 7 MSE-LS locations.We report tests of an alternate technique for constraining MHD equilibrium analysis in tokamak plasmas using internal magnetic field measurements based on |B| measurements from the motional Stark splitting of Dα spectral lines emitted by a neutral heating beam (MSE-LS). We compare results using MSE-LS with those of the standard equilibrium analysis technique based on line polarization of the Dα emission (MSE-LP). An alternative to MSE-LP is needed in future devices such as ITER where MSE-LP will be difficult due to a plasma-induced coating of the first optical element. The tests utilized data from 10 DIII-D shots with 7 MSE-LS and 14 MSE-LP views covering a range of radii along the outer midplane of the plasma. Seven MSE-LS measurements can contribute significantly to the equilibrium reconstruction of pressure and q profiles using both synthetic and experimental DIII-D MSE-LS data. For example, 7 MSE-LS plus seven MSE-LP measurements give a fit quality that is as good as the same cases with 14 MSE-LP meas...

A 12-processor Linux PC cluster has been installed to perform between-pulse magnetic equilibrium reconstructions during tokamak operations using the EFIT code written in FORTRAN. The MPICH package implementing message passing interface is employed by EFIT for data distribution and communication. The new system calculates equilibria eight times faster than the previous system yielding a complete equilibrium time history on a 25 ms time scale 4 min after the pulse ends. A graphical interface is provided for users to control the time resolution and the type of EFITs. The next analysis to benefit from the cluster is CERQUICK written in IDL for ion temperature profile analysis. The plan is to expand the cluster so that a full profile analysis (Te, Ti, ne, Vr, Zeff) can be made available between pulses, which lays the ground work for Kinetic EFIT and/or ONETWO power balance analyses.

The motional Stark effect (MSE) diagnostic was developed to provide a measurement of the magnetic pitch angle or q profile in tokamaks. The technique relies upon polarization measurements of Stark broadened Dα emission to determine the pitch angle of the Lorentz vb×B electric field, where vb is the injected neutral beam particle velocity and B is the total magnetic field. However, in many advanced confinement regimes, large values of the plasma radial electric field, Er, are observed and can affect the interpretation of MSE measurements. Viewing fixed locations in the plasma from two different viewing angles allows one to separate the Er field from the vb×B field, thus providing simultaneous measurement of the Er and q profiles. To achieve this measurement, the DIII–D MSE diagnostic was recently upgraded from 16 to 35 channels with three independent viewing angles. The new instrument provides an Er resolution of 5–10 kV/m with a time response of 1 ms. Measurement results from the VH mode, reverse shear, a...

Motional Stark effect produces large net linear polarization of Hα emission from neutral beams in tokamaks. Measurement of the polarization direction permits determination of the local magnetic field pitch angle. Design of a single point, spatially scannable, high‐sensitivity polarimeter installed on DIII‐D is described. Excellent signal‐to‐noise ratio with good temporal and spatial resolution was obtained in preliminary measurements of magnetic field pitch angle.

The DIII-D tokamak magnetic diagnostic system [E. J. Strait, Rev. Sci. Instrum. 77, 023502 (2006)] has been upgraded to significantly expand the measurement of the plasma response to intrinsic and applied non-axisymmetric "3D" fields. The placement and design of 101 additional sensors allow resolution of toroidal mode numbers 1 ≤ n ≤ 3, and poloidal wavelengths smaller than MARS-F, IPEC, and VMEC magnetohydrodynamic model predictions. Small 3D perturbations, relative to the equilibrium field (10(-5)δB/B010(-4)), require sub-millimeter fabrication and installation tolerances. This high precision is achieved using electrical discharge machined components, and alignment techniques employing rotary laser levels and a coordinate measurement machine. A 16-bit data acquisition system is used in conjunction with analog signal-processing to recover non-axisymmetric perturbations. Co-located radial and poloidal field measurements allow up to 14.2 cm spatial resolution of poloidal structures (plasma poloidal circumference is ~500 cm). The function of the new system is verified by comparing the rotating tearing mode structure, measured by 14 BP fluctuation sensors, with that measured by the upgraded B(R) saddle loop sensors after the mode locks to the vessel wall. The result is a nearly identical 2/1 helical eigenstructure in both cases.

Motional Stark effect produces large net linear polarization of Hα emission from neutral beams in tokamaks. Measurement of the polarization direction permits determination of the local magnetic field pitch angle. Design of a single point, spatially scannable, high‐sensitivity polarimeter installed on DIII‐D is described. Excellent signal‐to‐noise ratio with good temporal and spatial resolution was obtained in preliminary measurements of magnetic field pitch angle.