Search

In this study, we present an extension to existing numerical retrackers of synthetic-aperture radar (SAR) altimetry signals. To our knowledge at the time of writing this manuscript, it offers the most consistent retrieval of geophysical parameters compared to low-resolution mode (LRM) retracking results. We achieve this by additionally estimating the standard deviation of vertical wave-particle velocities σ v and a new parameter u x , linked to a residual Doppler in the returned radar echoes, which can be related to wind speed and direction. Including this new parameter into the SAR stack retracker mitigates sea surface height estimation errors by up to two centimeters for Sentinel-6MF SAR mode results. Additionally, we found a closed-form equation to describe u x as a function of eastward and northward wind variables, which allows mitigating the effects of this parameter on a SAR stack within level 1B processing and generating a lookup table to correct sea surface height estimates in SAR mode. This additionally opens up the door to estimating the wind speed and direction from SAR altimetry stacks. Additionally, we discuss how this new retracker performs with respect to different planned future baseline processor changes of Sentinel-6MF, namely F09 and F10, by attempting to imitate their level 2 processing. This is achieved by processing cycles 017 to 051 (nearly a full year) of Sentinel-6MF level 1A data on a global scale. We observe that the new retracking method is, on average, more accurate with respect to LRM. However, there is a slight increase in measurement noise due to the introduction of an additional parameter. To ensure that the results of the new retracker are not biased, we retrack using both the new method and the SINCS-OV ZSK retracker on Sentinel-6MF stack data produced in a Monte Carlo simulation. We analyze the simulation results with respect to accuracy, precision, and correlations between estimated parameters. We show that the accuracy of the new retracker is better than SINCS-OV ZSK but less precise, which could be related to higher correlation coefficients—especially with respect to the new parameter u x —between estimated parameters. [ABSTRACT FROM AUTHOR]

This study assesses the capability of Surface Quasi-Geostrophy (SQG) to reconstruct the three-dimensional (3D) dynamics in four critical areas of the Arctic Ocean: the Nordic, Barents, East Siberian, and Beaufort Seas. We first reconstruct the upper ocean dynamics from TOPAZ4 reanalysis of sea surface height (SSH), surface buoyancy (SSB), and surface velocities (SSV) and validate the results with the geostrophic and total TOPAZ4 velocities. The reconstruction of upper ocean dynamics using SSH fields is in high agreement with the geostrophic velocities, with correlation coefficients greater than 0.8 for the upper 400 m. SSH reconstructions outperform surface buoyancy reconstructions, even in places near freshwater inputs from river discharges, melting sea ice, and glaciers. Surface buoyancy fails due to the uncorrelation of SSB and subsurface potential vorticity (PV). Reconstruction from surface currents correlates to the total TOPAZ4 velocities with correlation coefficients greater than 0.6 up to 200 m. In the second part, we apply the SQG approach validated with the reanalysis outputs to satellite-derived sea level anomalies and validate the results against in-situ measurements. Due to lower water column stratification, the SQG approach's performance is better in fall and winter than in spring and summer. Our results demonstrate that using surface information from SSH or surface velocities, combined with information on the stratification of the water column, it is possible to effectively reconstruct the upper ocean dynamics in the Arctic and Subarctic Seas up to 400 m. Future remote sensing missions in the Arctic Ocean, such as SWOT, Seastar, WaCM, CIMR, and CRISTAL, will produce enhanced SSH and surface velocity observations, allowing SQG schemes to characterize upper ocean 3D mesoscale dynamics up to 400 m with higher resolutions and lower uncertainties. [ABSTRACT FROM AUTHOR]

This paper provides an overview of the Dragon 4 project dealing with operational monitoring of sea ice and sea surface salinity (SSS) and new product developments for altimetry data. To improve sea ice thickness retrieval, a new method was developed to match the Cryosat-2 radar waveform. Additionally, an automated sea ice drift detection scheme was developed and tested on Sentinel-1 data, and the sea ice drifty capability of Gaofen-4 geostationary optical data was evaluated. A second topic included implementation and validation of a prototype of a Fully-Focussed SAR processor adapted for Sentinel-3 and Sentinel-6 altimeters and evaluation of its performance with Sentinel-3 data over the Yellow Sea; the assessment of sea surface height (SSH), significant wave height (SWH), and wind speed measurements using different altimeters and CFOSAT SWIM; and the fusion of SSH measurements in mapping sea level anomaly (SLA) data to detect mesoscale eddies. Thirdly, the investigations on the retrieval of SSS include simulations to analyse the performances of the Chinese payload configurations of the Interferometric Microwave Radiometer and the Microwave Imager Combined Active and Passive, SSS retrieval under rain conditions, and the combination of active and passive microwave to study extreme winds. [ABSTRACT FROM AUTHOR]