Search

The absolute radiometric accuracy of the Fengyun 3D advanced Medium Resolution Spectral Imager (FY3D MERSI-II) thermal infrared bands was evaluated using the collected field measurements and atmospheric transfer simulations during 16–22 August 2019 at Lake Qinghai. A thermal infrared radiometer equipped on an unmanned surface vehicle was used to continuously collect the water temperature. Atmospheric conditions, surface emissivity, and aerosol optical depth measured near the field experiment site were adopted by the atmospheric transfer code to calculate the parameters about the influence of atmosphere on long-wave radiation, including the path radiance and the transmittance propagated from land surface to the satellite. The radiometric calibration accuracy analysis suggests that the differences between the simulated brightness temperature and satellite-based brightness temperature are −0.346 K and −0.722 K for channel 24 on 18 and 20 August, respectively, while it reaches −0.460 K and −1.036 K for channel 25 on 18 and 20 August, respectively. The vicarious calibration coefficients were found to be in good agreement with the internal onboard calibration coefficient in channel 24 and 25 of the FY3D MERSI-II according to the validation analysis in selected regions. The thermal infrared bands of the FY3D have a good in-orbit operational status according to our vicarious calibration experiments.

Land surface temperature (LST) is a key variable influencing the energy balance between the land surface and the atmosphere. In this work, a split-window algorithm was used to calculate LST from Sentinel-3A Sea and Land Surface Temperature Radiometer (SLSTR) thermal infrared data. The National Centers for Environmental Prediction (NCEP) reanalysis atmospheric profiles combined with the radiation transport model MODerate resolution atmospheric TRANsmission version 5.2 (MODTRAN 5.2) were utilized to obtain atmospheric water vapor content (WVC). The ASTER Global Emissivity Database Version 3 (ASTER GED v3) product was utilized to estimate surface emissivity in order to improve the accuracy of LST estimation over barren surfaces. Using a simulation database, the coefficients of the algorithm were fitted and the performance of the algorithm was evaluated. The root-mean-square error (RMSE) values of the differences between the estimated LST and the actual LST of the MODTRAN radiative transfer simulation at each WVC subrange of 0–6.5 g/cm2 were less than 1.0 K. To validate the retrieval accuracy, ground-based LST measurements were collected at two relatively homogeneous desert study sites in Dalad Banner and Wuhai, Inner Mongolia, China. The bias between the retrieved LST and the in situ LST was about 0.2 K and the RMSE was about 1.3 K at the Dalad Banner site, whereas they were approximately -0.4 and 1.0 K at the Wuhai site. As a reference, the retrieved LST was compared with the operational SLSTR LST product in this study. The bias between the SLSTR LST product and the in situ LST was approximately 1 K and the RMSE was approximately 2 K at the Dalad Banner site, whereas they were approximately 1.1 and 1.4 K at the Wuhai site. The results demonstrate that the split-window algorithm combined with improved emissivity estimation based on the ASTER GED product can distinctly obtain better accuracy of LST over barren surfaces.

Land surface temperature (LST) is an essential climate variable (ECV) for monitoring the Earth climate system. To ensure accurate retrieval from satellite data, it is important to validate satellite derived LSTs and ensure that they are within the required accuracy and precision thresholds. An emissivity-dependent split-window algorithm with viewing angle dependence and two dual-angle algorithms are proposed for the Sentinel-3 SLSTR sensor. Furthermore, these algorithms are validated together with the Sentinel-3 SLSTR operational LST product as well as several emissivity-dependent split-window algorithms with in-situ data from a rice paddy site. The LST retrieval algorithms were validated over three different land covers: flooded soil, bare soil, and full vegetation cover. Ground measurements were performed with a wide band thermal infrared radiometer at a permanent station. The coefficients of the proposed split-window algorithm were estimated using the Cloudless Land Atmosphere Radiosounding (CLAR) database: for the three surface types an overall systematic uncertainty (median) of −0.4 K and a precision (robust standard deviation) 1.1 K were obtained. For the Sentinel-3A SLSTR operational LST product, a systematic uncertainty of 1.3 K and a precision of 1.3 K were obtained. A first evaluation of the Sentinel-3B SLSTR operational LST product was also performed: systematic uncertainty was 1.5 K and precision 1.2 K. The results obtained over the three land covers found at the rice paddy site show that the emissivity-dependent split-window algorithms, i.e., the ones proposed here as well as previously proposed algorithms without angular dependence, provide more accurate and precise LSTs than the current version of the operational SLSTR product.

Land surface temperature (LST) is a crucial parameter in the interaction between the ground and the atmosphere. The Sentinel-3A Sea and Land Surface Temperature Radiometer (SLSTR) provides global daily coverage of day and night observation in the wavelength range of 0.55 to 12.0 μm. LST retrieved from SLSTR is expected to be widely used in different fields of earth surface monitoring. This study aimed to develop a split-window (SW) algorithm to estimate LST from two-channel thermal infrared (TIR) and one-channel middle infrared (MIR) images of SLSTR observation. On the basis of the conventional SW algorithm, using two TIR channels for the daytime observation, the MIR data, with a higher atmospheric transmittance and a lower sensitivity to land surface emissivity, were further used to develop a modified SW algorithm for the nighttime observation. To improve the retrieval accuracy, the algorithm coefficients were obtained in different subranges, according to the view zenith angle, column water vapor, and brightness temperature. The proposed algorithm can theoretically estimate LST with an error lower than 1 K on average. The algorithm was applied to northern China and southern UK, and the retrieved LST captured the surface features for both daytime and nighttime. Finally, ground validation was conducted over seven sites (four in the USA and three in China). Results showed that LST could be estimated with an error mostly within 1.5 to 2.5 K from the algorithm, and the error of the nighttime algorithm involved with MIR data was about 0.5 K lower than the daytime algorithm.

Microwave emissions at the L-band (1&ndash, 2 GHz) in Antarctica are characterized by a significant contribution of ice layers at great depth, from hundreds to a thousand meters. Brightness temperatures, thus, could provide the internal temperature of the ice sheet. However, there are two difficulties to overcome in developing an accurate retrieval algorithm. First, it is difficult to know precisely from which depths waves are emanating because the ice-absorption coefficient is uncertain at the L-band, despite several formulations proposed in the literature over the past few decades. Second, emissivity potentially varies in Antarctica due to remnant scattering in firn (or ice), even at the Brewster angle, and despite the low frequency, limiting the accuracy of the estimate of the physical temperature. Here, we present a retrieval method able to disentangle the absorption and emissivity effects from brightness temperature over the whole continent. We exploit the fact that scattering and absorption are controlled by different physical parameters and phenomena that can be considered as statistically independent. This independence provides a constraint to the retrieval method, that is then well-conditioned and solvable. Our results show that (1) the retrieved absorption agrees with the permittivity model proposed by M&auml, tzler et al. (2006), and (2) emissivity shows significant variations, up to 6% over the continent, which are correlated with wind speed and accumulation patterns. A possible cause of this latter point is density heterogeneity and sastrugi buried in the firn. These two results are an important step forward for the accurate retrieval of internal temperature using low-frequency microwave radiometers.

An autonomous system for field land surface temperature (LST) measurements taken at different observation angles was developed to be deployed easily at any conventional meteorological tower station. The system permits ground-truth data to be acquired on a continuous basis, and angularly scans land and sky hemispheres with a single thermal-infrared (TIR) radiometer. This paper describes the autonomous angular system and the methodology to assess ground-truth LST and relative-to-nadir emissivity data from system measurements. Ground-truth LSTs were used to validate satellite-retrieved LST products at two experimental sites (rice crop and shrubland areas). The relative-to-nadir emissivity values were used to analyze the anisotropy of surface emissive properties over thermally-homogeneous covers. The EOS-MODIS MOD11_L2/MYD11_L2 LST product was evaluated and shown to work within expected uncertainties (

The ECO System Spaceborne Thermal Radiometer Experiment on Space Station (ECOSTRESS) is a new space mission developed by NASA-JPL which launched on July 2018. It includes a multispectral thermal infrared radiometer that measures the radiances in five spectral channels between 8 and 12 μm. The primary goal of the mission is to study how plants use water by measuring their temperature from the vantage point of the International Space Station. However, as ECOSTRESS retrieves the surface temperature, the data can be used to measure other heat-related phenomena, such as heat waves, volcanic eruptions, and fires. We have cross-compared the temperatures obtained by ECOSTRESS, the Advanced Spaceborne Thermal Emission and Reflectance radiometer (ASTER) and the Landsat 8 Thermal InfraRed Sensor (TIRS) in areas where thermal anomalies are present. The use of ECOSTRESS for temperature analysis as well as ASTER and Landsat 8 offers the possibility of expanding the availability of satellite thermal data with very high spatial and temporal resolutions. The Temperature and Emissivity Separation (TES) algorithm was used to retrieve surface temperatures from the ECOSTRESS and ASTER data, while the single-channel algorithm was used to retrieve surface temperatures from the Landsat 8 data. Atmospheric effects in the data were removed using the moderate resolution atmospheric transmission (MODTRAN) radiative transfer model driven with vertical atmospheric profiles collected by the University of Wyoming. The test sites used in this study are the active Italian volcanoes and the Parco delle Biancane geothermal area (Italy). In order to test and quantify the difference between the temperatures retrieved by the three spaceborne sensors, a set of coincident imagery was acquired and used for cross comparison. Preliminary statistical analyses show a very good agreement in terms of correlation and mean values among sensors over the test areas.

Due to the difficulty in accurately interpreting surface emissivity spectra, problems remain in the application of passive microwave satellite observations over land surfaces. This study develops a parameterized soil surface emissivity model to quantify the microwave emissivity accurately and rapidly for Gaussian-correlated rough surfaces. We first analyze the sensitivity of surface emissivity to parameters using the advanced integral equation model (AIEM) simulated data. On the basis of the analysis and previous empirical models, two function factors that consider the polarization dependence of surface reflectivity are developed in the parameterized soil surface emissivity model. These factors also comprehensively account for the effects of surface roughness, soil moisture, and incident angle. A comparison with the AIEM simulated data indicates that the absolute error of effective reflectivity estimated by the parameterized soil surface emissivity model is small with a magnitude of 10−2. Validation through experimental measurements suggests that a good agreement could be obtained. The parameterized soil surface emissivity model is applied to simulate satellite measurements of the Advanced Microwave Scanning Radiometer-Earth Observing System (AMSR-E). Compared with the commonly-used microwave land emissivity model developed by Weng et al. (2001), the simulation results using the parameterized soil surface emissivity model yield a lower root-mean-square error (RMSE) and the overall errors are reduced, particularly for horizontal polarization. The newly-developed parameterized soil surface emissivity model should be useful in improving our understanding and modeling the measurements of passive microwave radiometers.

Satellite-based temperature measurements are an important indicator for global climate change studies over large areas. Records from Moderate Resolution Imaging Spectroradiometer (MODIS), Advanced Very High Resolution Radiometer (AVHRR) and (Advanced) Along Track Scanning Radiometer ((A)ATSR) are providing long-term time series information. Assessing the quality of remote sensing-based temperature measurements provides feedback to the climate modeling community and other users by identifying agreements and discrepancies when compared to temperature records from meteorological stations. This paper presents a comparison of state-of-the-art remote sensing-based land surface temperature data with air temperature measurements from meteorological stations on a pan-arctic scale (north of 60° latitude). Within this study, we compared land surface temperature products from (A)ATSR, MODIS and AVHRR with an in situ air temperature (Tair) database provided by the National Climate Data Center (NCDC). Despite analyzing the whole acquisition time period of each land surface temperature product, we focused on the inter-annual variability comparing land surface temperature (LST) and air temperature for the overlapping time period of the remote sensing data (2000–2005). In addition, land cover information was included in the evaluation approach by using GLC2000. MODIS has been identified as having the highest agreement in comparison to air temperature records. The time series of (A)ATSR is highly variable, whereas inconsistencies in land surface temperature data from AVHRR have been found.

Quantifying roughness effects on ground surface emissivity is an important step in obtaining high-quality soil moisture products from large-scale passive microwave sensors. In this study, we used a semi-empirical method to evaluate roughness effects (parameterized here by the parameter) on a global scale from AMSR-E (Advanced Microwave Scanning Radiometer for EOS) observations. AMSR-E brightness temperatures at 6.9 GHz obtained from January 2009 to September 2011, together with estimations of soil moisture from the SMOS (Soil Moisture and Ocean Salinity) L3 products and of soil temperature from ECMWF’s (European Centre for Medium-range Weather Forecasting) were used as inputs in a retrieval process. In the first step, we retrieved a parameter (referred to as the parameter) accounting for the combined effects of roughness and vegetation. Then, global MODIS NDVI data were used to decouple the effects of vegetation from those of surface roughness. Finally, global maps of the Hr parameters were produced and discussed. Initial results showed that some spatial patterns in the values could be associated with the main vegetation types (higher values of were retrieved generally in forested regions, intermediate values were obtained over crops and grasslands, and lower values were obtained over shrubs and desert) and topography. For instance, over the USA, lower values of were retrieved in relatively flat regions while relatively higher values were retrieved in hilly regions.