Search

Ferrous-sulphate infused gels, or 'Fricke gels', encounter great interest in the field of radiation dosimetry, due to their potential for 3D radiation dose mapping. Typically, magnetic resonance (MR) relaxation rates are determined in these systems in order to derive the absorbed dose. However, when large concentration gradients are present, diffusion effects before and during the MR imaging may not be negligible. In these cases, optical techniques may represent a viable alternative. This paper describes research aimed at measuring 3D dose distributions in a Fricke-xylenol orange gel by measuring optical density with a CCD camera. This method is inexpensive and fast. A series of early experiments is described, in which optical density profiles were measured with a commercial microdensitometer for film dosimetry. The light box of the device was modified to work at 567 nm, close to the maximum absorbance of the ferric ion-xylenol orange complex. Under these conditions, the gel shows linearity with dose and high sensitivity.

In radiotherapy involving thermal and epithermal neutrons, the knowledge of dose distributions, with separation of the contribution of each secondary radiation component, is of utmost importance. Layers of Fricke-Xylenol-Orange-infused gel dosemeters give the possibility of achieving such requirements because, owing to the layer-geometry, enriching or depleting the gel matrix of suitable isotopes does not sensibly alter neutron transport. The dosimetry method has been critically re-examined with the aim of improving its suitability to boron neutron capture therapy (BNCT) requirements, as it applies to the protocol of measurement and analysis, the sensitivity of the method and the range of the linearity of the dosemeters. Software has been developed and studied to obtain automatically the images of the various dose components with the established separation procedure.

In Fricke-agarose gels, an accurate determination of the spatial dose distribution is hindered by the diffusion of ferric ions. In this work, a model was developed to describe the diffusion process within gel samples of finite length and, thus, permit the reconstruction of the initial spatial distribution of the ferric ions. The temporal evolution of the ion concentration as a function of the initial concentration is derived by solving Fick's second law of diffusion in two dimensions with boundary reflections. The model was applied to magnetic resonance imaging data acquired at high spatial resolution (0.3 mm) and was found to describe accurately the observed diffusion effects.

The effect of temperature on the oxidation of Fe2+ in the gamma radiolysis of acidic ferrous sulfate solutions has been modelled using the stochastic IRT method, incorporating simulated electron track structures. There is an 11% increase in the Fe3+ yield in aerated 0.4 M H2SO4 solution on going from 298 to 573 K (25 to 300 degrees C). The H2 yield in aerated solution increases about 24% from 0.41 at 298 K to 0.51 at 573 K. In the absence of oxygen, the increase in the yields of both Fe3+ and H2 is about 12%. Calculated yields are consistent with available experimental data at room, and elevated temperatures. Simulations for heavy water (D2O) show similar temperature effects to those found for ferrous sulfate solutions in light water (H2O).